Question about Cars & Trucks

Open Question

Gmc Envoy Problemsometimes on my 2007 envoy the abs & traction control light comes on & my a/c fan stops blowing until i turn the key off & back on

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 101 Answers

SOURCE: 2006 GMC Envoy and the A/C fan wont work in number 5 position

replace the resistor 4 the blower motor that should slove that hope this helps

Posted on Mar 05, 2009

Ad
farroutideas
  • 78 Answers

SOURCE: wiring diagram or fuse box diagram-2007 GMC Envoy Denali

Hi there;

Here is the wiring diagram for the trailer wiring for your truck.
22593cd.jpg
Hope this helps
Farrout!

Posted on Mar 18, 2009

  • 1 Answer

SOURCE: abs light/traction control light

You can check out what the trouble code is by pushing and holding the information button and the up arrow (right side of instrument cluster above the radio) until all the instrument clusters light. Press the information button (last) to enter test mode. I've had an error C1234, meaning Left rear wheel sensor fault. I found the problem to be a corroded connector under the chasis just under the rear left door about 2 feet in. I had to by-pass (replace 1 wire due to corrosion at the connector.

Posted on Sep 15, 2009

  • 293 Answers

SOURCE: 2007 GMC Envoy - Gas gauge showing empty and check engine light

This is a safety feature that the vehicle brings. You need to reset the E.C.U on dealership or it will keep doing it to you. It was probably caused by one single time that you did not closed the fuel cap correctly. Good luck

Posted on Dec 29, 2009

  • 1311 Answers

SOURCE: i have a climate control problem on 2004 gmc

The likely problem is the blower motor resistor pack is defective. It is located behind an access panel below the glovebox. Go to www.trailvoy.com and do a search on "blower motor resistor replacement"

Posted on Sep 09, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

I have a 2007 GMC Envoy The traction control and ABS kick in at very slow speeds


Ok I found the problem it was dirt (rust) accumulation under the ABS sensor on the front wheels I simply removed the sensor passed a wire brush on the hub and the problem was solved

Jul 31, 2017 | GMC Cars & Trucks

2 Answers

Problem with stabilitrak system and ABS light on. what is the problem


You need to take it to a garage and have them put a code reader onto the OBD11 port and the codes tell you precisely what the problem is and then the webpage of the code tells you what the fix it. It is no good guessing.

Feb 05, 2017 | GMC Cars & Trucks

1 Answer

My whole dash went out on my 2002 gmc envoy all the gauges arent working i checked fuses under the hood they seemed fine. Any advice for these problems?


Does it light up ? When you turn the key on do the warning lights come on ? Check engine , oil , abs , air bag etc... just gauges not working ? Does the vehicle start an run ? With vehicle running is check engine light on ? GM had a problem with the stepper motors that control the gauges . How to repair GM Instrument Cluster Speedometer Gauge Stepper

Sep 12, 2016 | 2002 GMC Envoy

1 Answer

Hello. I also am having issues with my Envoy, the stabilizer lights are on and also the ABS and break light. But along with the lights being on I have no control of my heat or air conditioner, oh and no...


On my s1s10, it was a blown fuse under the hood and front wheel hubs needing replaced. The bad wheel hubs were throwing abs and traction systems as well as no cruise. The noise from the hubs confused the abs sensors until they got new ones. Everything is one piece nowadays.

Nov 30, 2014 | 2006 GMC Envoy Xl

1 Answer

Service traction control light


The light has to be on when it is checked. Also it could be something as simple as tire pressure that is causing this.

Feb 15, 2013 | 2006 GMC Envoy

1 Answer

Service traction control light


Probably a sensor going bad.

Feb 15, 2013 | 2006 GMC Envoy

1 Answer

Do keys for a 2007 GMC Envoy have a chip in them?


you have to get another key from gmc,security measures

Oct 18, 2009 | 2007 GMC Envoy Denali

1 Answer

Abs light, brake light, traction control, traction control service lights are on. No braking problems


did you jacked th car up for any reason or remove the rear tires for any reason?, have the lights reset with a scan tool.

Jul 19, 2009 | 2006 GMC Envoy

1 Answer

Abs traction control fix tc light and brake light on


sometimes when acar with abs is jacked up the abs light will come on, thats not indicaion or a problem, disconect the batt pos terminal for about 20 seconds and recconect, the light will go off.

Jul 19, 2009 | 2006 GMC Envoy

1 Answer

Electrical malfunctions in 2006 GMC Envoy XL


Check your ignition switch by checking the voltage at the fuses for affected circuts vs. other circuts that are working well...

Jun 21, 2009 | 2006 GMC Envoy Xl

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

83 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...