Question about 1999 Mercedes-Benz S-Class

Open Question

How can I get my s500 Mercedes to change from limp mode

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 39 Answers

SOURCE: 1998 S500 Battery Change

Only radio and some trouble codes can be cleared.If you have no warning lamps illuminated (such as MIL)
you can remove and charge the battery.

Posted on May 07, 2009

wadembly
  • 448 Answers

SOURCE: change the wing mirror on 1999 mercedes S500

there should be to little covers that come out then it unbolts

Posted on Nov 13, 2009

  • 88 Answers

SOURCE: i have a 1992 Mercedes s500 which occasionally the

Suspect idle control motor, although mass air flow sensor problems have sometimes been related to idle surge. Have pcm codes pulled for further diagnosis.

Posted on Dec 26, 2009

e-Guru
  • 3917 Answers

SOURCE: 02 mercedes clk430 stuck in

HI

Since you have rebuilt the transmission it is suggested to replace the speed sensor,this is the cause that your car is stuck in limp mode.

Let us know if you want to know somethin more else accept the suggestion.

Thanks for contacting fixya.com

Posted on Apr 27, 2010

emissionwiz
  • 75066 Answers

SOURCE: mercedes 20004 c class 2.7 cdi keeps going in limp mode

The engine and the transmission in this car are controlled electronically by a computer module, when the car is put in limp mode the computer has detected a serious problem that may cause damage to the engine if you were to drive it at full power settings. What must be done now is to have the systems computer scanned for fault codes that will ID why this is happening.

Posted on Jun 11, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

C270 goes in limp mode M Benz tech department said maf sensor and throttle control, I replaced both and the same happened


the limp mode is also activated by problem sensors in the transmission. Have the fault codes read again or have the system reset after replacing the faulty items.

Jan 16, 2015 | Mercedes-Benz C-Class Cars & Trucks

1 Answer

Mercedes benz limp mode


You need to first have the systems computer scanned for fault codes.

Apr 02, 2014 | 2000 Mercedes-Benz C-Class

1 Answer

Mercedes benz limp mode


WHEN YOUR VEHICLE GOES INTO LIMP MODE IT INDICATES A PROBLEM THAT NEEDS ATTENTION CAN BE TRANS OR ENGINE TRY TURNING SWITCH OFF AT A STOP AND GO AGAIN WITHOUT HOTRODDING IT. THERE ARE TIMES WHEN WIPING AROUND DANGEROUSLY IT WILL GO INTO LIMP MODE.

Oct 30, 2013 | Mercedes-Benz ML320 Cars & Trucks

2 Answers

Somtimes my throttle dose not work on my s500


this car uses electronic throttle controls, when a fault occurs in the electronics the computer (ECM) limits the amount of travel the throttle can open to limit the load on the engine to prevent any further damage, when the fault clears itself as they often do the throttles are returned to normal operation, the limited throttle is called "Limp mode", what u need to do now is have the dealer test the computer (ECM) for fault codes that may be stored to explain why the system was put in "Limp mode" with the resulting loose of throttle control..

Oct 27, 2010 | 1994 Mercedes-Benz S-Class

2 Answers

02 mercedes clk430 stuck in limp mode. Transmission has been rebuilt, we have no power to the speed sensor, we changed the connector plate and the car is still in limp mode what can be wrong? all fuses are...


HI

Since you have rebuilt the transmission it is suggested to replace the speed sensor,this is the cause that your car is stuck in limp mode.

Let us know if you want to know somethin more else accept the suggestion.

Thanks for contacting fixya.com

Apr 27, 2010 | 2001 Mercedes-Benz CLK-Class

1 Answer

I have a 1992 Mercedes s500 which occasionally the rev counter suddenly jumps up & down then stops completely then ASR light comes on and the car goes into ''limp mode'', then after a few minutes it...


Suspect idle control motor, although mass air flow sensor problems have sometimes been related to idle surge. Have pcm codes pulled for further diagnosis.

Dec 25, 2009 | 1992 Mercedes-Benz Mercedes Benz S Class

1 Answer

Change the wing mirror on 1999 mercedes S500


there should be to little covers that come out then it unbolts

Nov 13, 2009 | 1999 Mercedes-Benz S-Class

2 Answers

MERCEDES NOT CHANGING GEARS


it should be in 2nd gear your gearbox is in limp mode need to have it looked at a.s.a.p ( the oil level may low)

Jun 11, 2009 | 2003 Mercedes-Benz CLK-Class

2 Answers

Merc 190e


Ok there is a number of things that will stop it from revving past 3k from your description I would check the ignition timing for advance mechanical and vacuum .I don't know when you experience the fault or eg while driving or just free reviving in Neutral .
BTW 190e does not have limp home mode so there is a real problem. Hope this helps

Dec 05, 2008 | 1990 Mercedes-Benz 190

Not finding what you are looking for?
1999 Mercedes-Benz S-Class Logo

Related Topics:

31 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercedes-Benz Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

yadayada
yadayada

Level 3 Expert

75066 Answers

Michael Contreras
Michael Contreras

Level 2 Expert

166 Answers

Are you a Mercedes-Benz Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...