Question about Hyundai Santa Fe

Open Question

Find the canister purge valve on 2008 3.3l v6 Santa Fe

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 21 Answers

SOURCE: purge valve

Against the middle of the firewall in the engine compartment. If you are looking at the engine, its behind the surge tank of the intake manifold. Has one vacuum hose going to intake manifold and one going to EVAP canister in the center of the truck, and one 2 terminal electrical connector.

Posted on Jul 02, 2008

Ad
  • 169 Answers

SOURCE: '96 Regal Purge Canister Valve?

ADAM
THE PURGE SOLANOID IS ON THE ENGINE WITH A RED CONNECTOR ON IT. IT IS LOCATED ON THE REAR OF THE ENGINE ABOVE THE REAR VALVECOVER. YOU ARE ACTUALLY LOOKING FOR THE CANISTER VENT SOLANOID AND IT IS IN THE REAR OF THE CAR AND THEY FAIL OFTEN. GET THE PART FROM G.M. AND THEY CAN TELL YOU EXACTLY WHERE IT IS. THE G.M. PART IS UNDER $30.00.

Posted on Aug 26, 2008

  • 21 Answers

SOURCE: transmission filter on 2003 hyundia santa fe

In 2002 they discontinued the external trans filter. So your vehicle could have the external filter. If you look next to the trans dipstick tube, on top of the trans case you will see the filter or you will see just a spot where the filter use to go before they eliminated it. Yes, the filter does llok like a regular engine oil filter. If the trans does not have the external filter ontop then there is no service to the filter to be done, the only recommendation is to bring vehicle into a shop to have the fluid flushed. By the way, make SURE you use the correct Hyundai SP-III trans fluid (not dexron/mercon). This fluid is specific to the Hyundai and can not be purchased from auto parts stores, only the dealership. Failure to use SP-III will cause premature wear to the internal bands and clutches.

Posted on Oct 19, 2008

savdragon
  • 37 Answers

SOURCE: Mustang GT 4.6 EVAP Canister Purge Valve Location?

You will need to remove the right front wheel & wheel well liner. The canister purge valve is behind the cover. It should have two tube going into the bottom and one on the side near the top.
You can fix it!
If this helps you out please rate me!
Brett

Posted on Mar 19, 2009

  • 291 Answers

SOURCE: where is the charcoal canister

charcoal canister is under the vehicle near the gas tank, usually on the driver side of the vehicle.
thanks and please do not forget to accept the solution

Posted on Apr 03, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Anytime Iput gas in after 10-20 stop and starts it has extended cranks for 1 minute the turns over till the next time I put gas in . I only put in 3/4 tank so I don't over flow/ I have put in cran


Then the system is purging when it should not. when the system purges certain criteria needs to be met.Fuel vapor are forced to flow in the canister from the fill vent valve to the fuel liquid vapor seperator this isolates fule from vapor there the vapor goes to the canister the vapor from the canister is fed in to the intake manifold into the combustion chamber this according to the purge process. The solution is to monitor the purge control solenoid unless the cansitor is fuel soaked.

Feb 24, 2012 | 2004 Hyundai Santa Fe

1 Answer

2004 Hyundai Sante Fe difficulty starting after fill up bulletin boards indicate that it may be a purge valve do you agree and where is this part located on the vehicle.. Thank You


Yes, the PCSV (Purge Control Solenoid Valve) is usually the cause of difficulty in starting the engine after refueling. The 2004 Santa Fe came with three different engines and this valve is located in different places on each engine (2.4 (4 Cylinder), 2.7 V6 and the 3.5 V6). Go to www.hmaservice.com and register your vehicle by VIN #.. you'll then have access to wiring diagrams, shop & owner manuals, service bulletins, campaigns, illustrations and procedures, etc

Sep 11, 2011 | Hyundai Santa Fe Cars & Trucks

1 Answer

My 2002 Hyundai Santa FE 2.7 engine dies every time I gas up. It runs fine the rest of the time. So far I have replaced the fuel pump and vent valve. It still stalls. What could the problem be>


The evaporative emissions system consists of 5 major components
1. CCV - Canister Close Valve
2. Charcoal Canister & filter
3. Purge Contro Solenoid Valve (PCSV)
4. Differential Pressure Sensor (DPS - Fuel Tank Pressure Sensor)
5. Fuel Cap

Based on my experience, you have a PCSV which is sticking OPEN and constantly applying a vacuum to the charcoal canister. When you fill up, the fuel vapors which were absorbed by the charcoal are being constantly/continually sucked into the engine intake manifold causing an excessive 'RICH' mixture of fuel-to-air.

Sep 08, 2011 | 2002 Hyundai Santa Fe

1 Answer

2004 hyundai santa fe will not start without pumping the gas pedal after a gas fill-up. research on the internet points to a vent valve. how do i replace it?


The evaporative emissions system consists of 5 major components
1. Charcoal Canister
2. Canister Close Valve (CCV)
3. Purge Control Solenoid Valve (PCSV)
4. Fuel Tank Pressure Sensor (or differential pressure sensor) (FTPS)
5. Canister Air Filter & Fuel Filler Cap

If you haven't done it already, you should have a qualified Hyundai Service Technician properly diagnose this problem. My experience tells me you have a Purge Control Solenoid Valve (PCSV) that is sticking open and is applying constant engine vacuum to the charcoal canister (which was just freshly saturated with gasoline/fuel vapors when you refueled the vehicle).

You can Go to www.hmaservice.com and register your vehicle by VIN #.. you'll then have access to wiring diagrams, shop manuals, service bulletins, illustrations and procedures, etc.

Sep 01, 2011 | 2004 Hyundai Santa Fe

1 Answer

Hyundai Sante Fe 2004 p0446p


P0446 means there is a higher than expected amount of vacuum in the fuel tank when purge is commanded. This can be caused by a canister close valve being stuck closed, but more likely, it is a restricted air inlet filter at/near the charcoal canister.

Jun 21, 2011 | 2004 Hyundai Santa Fe

1 Answer

I have a 2003 Hyundai Santa Fe, lately everytime i fill up it takes a long while to get it started again.Once it's started, it's fine until the next fill up. any suggestions??


Sounds like the purge control valve on your evaporative system is stuck open. In this case, what happens during fill-up is that fuel vapors are forced from the fuel tank into the intake manifold, effectively flooding the engine.
Todays fuel tanks are vented back into the engine. A "Carbon Canister" is supposed to absorb the vapors and then feed them into the engine in a controlled manner. If your canister is saturated or the purge valve stuck open, the fumes can "flood" the engine while refueling. Try holding the throttle wide open when you start after refueling to clear the vapor quickly.

Also next time you go to fill up, don't fill it all the way, maybe half or so, since the evap lines are at the top of the tank this should solve your problem, and give you at least some good information to take to your mechanic

Sep 15, 2010 | 2003 Hyundai Santa Fe

2 Answers

Where is the purge valve located on a 2004 santa fe?


You have not responded CLEARLY!... which ENGINE?

Oct 30, 2009 | 2003 Hyundai Santa Fe

1 Answer

'02 Santa Fe V6 awd, Upon start up after a refuel you have to keep the revs up or it will stall,after that it starts fine.Also after running the a/c it doesn't want to shut off,turn the key back on and off...


One problem at a time please. No. 1!. Your description points to a faulty Purge Control Solenoid Valve (related to engine stall after refuel). The second problem could be caused by 'hot spots' in the combustion chamber -- however, the only way for any fuel to enter the combustion chamber after the KEY is turned OFF, is through the Purge Contro Solenoid Valve - it's the only component directly related to the problem you describe (unless you (or someone else) has modified the engine in some way other than original manufacture's design. Solution (provided no modifications have been performed), replace the Purge Control Solenoid Valve.

Jun 11, 2009 | 2002 Hyundai Santa Fe

1 Answer

Where is the charcoal canister


charcoal canister is under the vehicle near the gas tank, usually on the driver side of the vehicle.
thanks and please do not forget to accept the solution

Apr 03, 2009 | 2003 Hyundai Santa Fe

1 Answer

Purge valve


Against the middle of the firewall in the engine compartment. If you are looking at the engine, its behind the surge tank of the intake manifold. Has one vacuum hose going to intake manifold and one going to EVAP canister in the center of the truck, and one 2 terminal electrical connector.

Jul 02, 2008 | 2003 Hyundai Santa Fe

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

89 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8582 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...