Question about 2002 Dodge Neon

Open Question

2002 Dodge Neon has the following trouble codes ... P0846, P0706, P0734, P0733, P1790, P0700.

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 328 Answers

SOURCE: OBD2 DTC P0700 &P0733

P0700 Transmission Control System Malfunction P0733 Gear 3 Incorrect ratio INFO FROM http://autorepair.about.com/cs/troubleshooting/l/bl_obd_7.htm
hope this helps.....good luck!

Posted on Dec 25, 2008

  • 412 Answers

SOURCE: transmission codes:

I WOULD TRY REPLACING THE INPUT SPEED SENSOR..A DEFECTIVE SPEED SENSOR CAN CAUSE ALL OF THESE FAULTS..IT IS LOCATED IN FRONT OF TRANS ABOVE SOLENOID PACK..IT IS THE ONE CLOSEST TO THE ENGINE..IT SCREWS INTO TO TRANSMISSION..A 1 INCH SOCKET FITS IT..ALSO CHECK WIRING TO BOTH SPEED SENSORS..A SENSOR IS ABOUT 35 BUCKS,AVAILABLE AT YOUR LOCAL DODGE DEALER..GET A NEW ONE AND YOU'LL SEE WHAT IT LOOKS LIKE..FAIRLY COMMON PROBLEM..HAVE REPLACED LOTS OF THEM

Posted on Jul 07, 2009

  • 181 Answers

SOURCE: 2002 dodge dakota code p0733 p0734

This code means gear ratio dont match from in to out on transmission in 3rd po733 4th po734 first thing to do is do a filter change and replace the fluid.LOOK for metal shavings. If you see alot could be interal problems. I have seen this fixed by a good trans flush Hope this helps

Posted on Feb 17, 2010

  • 340 Answers

SOURCE: 2003 Dodge Caravan Trouble codes

p0731 transmission shift problems
p0841 solinoid problems in the transmission
p0846 fluid level
p0700 solinoid stuck or sticking hard shifting
there is a solinoid in the transmission that shifts the trans and downshifts when stopping this is a problem you generally don't want to do your self

Posted on Mar 03, 2010

  • 1 Answer

SOURCE: trans in limp mode with codes P0700, P0733 and P0734

1998 dodge caravan code P0700-Transmission Control System (Malfunction Indicator Lamp Request) How do I fix this?

Posted on Nov 17, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Dtc Code P2314


2002 Dodge Intrepid Ignition Coil Circuit Codes: Electrical ...

www.2carpros.com/.../dodge-intrepid-2002-dodge-intrepid-ignition-coil...
Aug 13, 2008 - 2002 Dodge Intrepid 6 cyl Front Wheel Drive Automatic 130000 miles. Getting the following codes. P0353 P2302 P2305 P2308 P2311 P2314

What are 2002 Dodge Intrepid trouble codes PO442 and ...

www.answers.com > ... > American Cars > Dodge > Dodge Intrepid
What does the Error Code P0846 on 2002 Dodge Intrepid mean? .... Trouble code P2314 means: Ignition coil E, secondary circuit - malfunction Trouble code .

Oct 29, 2015 | 2002 Dodge Intrepid

1 Answer

Loss of power, transmission issues


code p0700 refers to transmission control system/MIL --malfunction===causes --wiring ---TCM (1)
code po740 refers to torque converter clutch (TCC) solenoid--circuit malfunction===causes--wiring--TCC solenoid--ECM/TCM (transmission control module) (again)
code p0871 refers to transmission fluid pressure (TFP) sensor C -range/ performance problem==causes---wiring--poor connection--TFP sensor--ECM /TCM (yet again)
code p0734 refers to gear 3 ratio (po374 is gear ratio 4) incorrect ratio===causes --wiring--TR sensor/switch--shift solenoids--transmission mechanical fault (causes are the same for po733&734)
code po846 refers to transmission fluid pressure (TFP) sensor B-range/ performance problem===causes ---wiring--poor connection--TFP sensor--ECM/TCM (again). Give the clutch a miss as you still have 1st gear and if the clutch is not working you will not be going any where. Have a pressure test done on the transmission to check for internal mechanical failures (pump ). The rest are sensors are wiring connections , sensor and TCM. My bet is the TCM unit. Have it checked out. What ever you do treat any suggestion of a new transmission with a grain of salt until you are shown proof positive that you need one.

Nov 15, 2013 | 2003 Dodge Neon

1 Answer

P0700 p0733 p0734 1997 chrysler intrepid


P0700 codes are Transmission DTC's (Diagnostic Trouble Codes)...

The specific codes are Incorrect Gear Ratio codes. This problem could be caused by low transmission fluid, deteriorated transmission fluid, a shift solenoid malfunction, the transmissions line pressure, quite a few electrical problems, etc. First step would be to check the fluid level the correct way. The vehicle must be up to operating temperature, and the shifter must be in the Neutral position. Also look at the color of the fluid. If the fluid is no longer the right condition, (most of the time it is bright red) it will be brown, or darker looking. Also smell the fluid, it may smell burnt. If this is the case, the clutch may also be slipping. In conclusion, if the fluid is NOT the problem, you may need to have the transmission tested by a certified technician. Hope this helps you.

Feb 25, 2011 | 1997 Dodge Intrepid

2 Answers

2003 Dodge Caravan Trouble codes p0731,p0841,p0846,p0700 Help Please.


p0731 transmission shift problems
p0841 solinoid problems in the transmission
p0846 fluid level
p0700 solinoid stuck or sticking hard shifting
there is a solinoid in the transmission that shifts the trans and downshifts when stopping this is a problem you generally don't want to do your self

Mar 03, 2010 | 2003 Dodge Caravan

1 Answer

2001 Jeep Grand Cherokee won't shift out of first gear and the fault codes are P0733 and P0734.


P0733=Gear 3 Incorrect Ratio
P0734=Gear 4 Incorrect Ratio,
your transmission is in "limp" mode,
Have the following sensors checked on the transmission,input sensor,output sensor,and speed sensor.
The transmission is not getting a signal from one of them,So it doesn't know how fast your going so it doesn't up shift.

Jan 22, 2010 | 2002 Jeep Grand Cherokee

2 Answers

Trans in limp mode with codes P0700, P0733 and P0734


1998 dodge caravan code P0700-Transmission Control System (Malfunction Indicator Lamp Request) How do I fix this?

Aug 30, 2009 | 2002 Dodge Caravan

1 Answer

2002 caravan trans. no 3 or 4 gear


replace the input and output speed sensors

May 28, 2009 | 2002 Dodge Caravan

1 Answer

Transmission with codes P0218 P0732 P0733 P0740 P0846 P1790


I agree, this is a lot of codes. I would tend to think this would be electrical, perhaps computer are a loose connection? These trannys I have rebuilt so far usually have a couple of codes related to the problem but not this many - all over the place.

Apr 16, 2009 | Chrysler Town and Country Cars & Trucks

1 Answer

OBD2 DTC P0700 &P0733


P0700 Transmission Control System Malfunction P0733 Gear 3 Incorrect ratio INFO FROM http://autorepair.about.com/cs/troubleshooting/l/bl_obd_7.htm
hope this helps.....good luck!

Dec 25, 2008 | 1997 Dodge Intrepid

Not finding what you are looking for?
2002 Dodge Neon Logo

Related Topics:

101 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7710 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...