Question about 1999 GMC Jimmy

1 Answer

Not getting fire to fuel pump - 1999 GMC Jimmy

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 3 Answers

Relay ,under the hood,drivers side

Posted on Oct 12, 2013

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I put a new fuel pump in rear tank and fuel filter but not starting.im getting fire at fuel pump but no fire from relay .i put new relay still nothing


Fuel pump will usually only run when on Crank. When engine fires up then it stays running. This is so it won't pump in a crash.

Jan 31, 2015 | Cars & Trucks

1 Answer

No fire 2 fuel pump on 2002 suburban


Have you checked the fuel pump relay yet ?
It should have power for three seconds when you turn the key switch on, then power after the engine starts.

Jan 22, 2013 | 2002 Chevrolet Suburban

2 Answers

2000 lincoln ls want start. replace fuel pump and fuel pump relay.


have you checked the fuel pressure regulater or the map sensor

Mar 20, 2012 | 2001 Lincoln LS V8

1 Answer

Will tiurn over but will not start


make sure the engine is firing,if engine not firing bad crank sensor..... if engine is firing, it could be fuel pump relays,bad connection at fuel pump if fuel pump on the frame, or fuel pump itself

Jan 19, 2011 | 1989 Ford F 150

3 Answers

I have a 1988 Chevy K2500, V8-350 cu. in with TBI. I have fire, but there is no fire running to the fuel pump. There is a new fuel pump relay installed and the fuse is also good. Truck ran fine, then...


Oil pressure switch puts power to the pump after it is started.

Pumps also tend to loose their ground with age. I often splice in a new ground at the pump to eliminate that problem area.

Need some votes, thanks

Aug 22, 2010 | 1990 Chevrolet K2500

1 Answer

I have an 1999 ford rsnger that wont start


DOES IT HAVE POWER/ A GOOD BATTERY? IF SO CHECK & SEE IF IT IS GETTING FIRE OUT FROM THE COIL PACKS,THE QUICKEST WAY TO SEE IF IT IS FIRE OR A FUEL PROBLEM IS SPRAY A LITTLE STARTING FLUID IN THE THROTTLE BODY,& IF IT CRANKS & THEN CUTS RIGHT BACK OFF ITS A FUEL PROBLEM,FUEL PUMP FUSE,FUEL PUMP RELAY,OR FUEL PUMP,& OR FUEL FILTER, IF ITS NOT GETTING FIRE IT COULD BE A CRANK SENSOR, A CAM POSITION SENSOR,COIL PACK(S) OR A FUSE OR RELAY.

Dec 05, 2009 | 1999 Ford Ranger SuperCab

1 Answer

Wont start , no fuel getting to fuel pump


Are you sure there is gas in the tank? I "fixed" more than one car that came in for a fuel pump replacement that ran out of gas. If you have gas, check the fuel pump fuse, fuel pump relay, check for power to the fuel pump. check wiring, kinked lines, clogged fuel filter. Sometimes new FI cars are hard to prime if there is air in the system. Take off the air filter and have someone squirt fuel down the throttle body while you crank the engine. If it fires, you know it's not getting fuel, but when it does fire , it may prime the pump enough to run.

Jun 29, 2009 | 1991 Toyota MR2

2 Answers

97 z71 vortec 5.7 replaced fuel pump.getting fuel but won't start


The # 5 cylinder is miss firing. not getting fuel. Could the injector just be stopped or the crankshaft sensor in gone.

Jun 26, 2009 | Chevrolet Silverado 1500 Cars & Trucks

1 Answer

Doesn't get fire since replacing fuel pump.


Normally after replacement of the fuel pump you need to get the fuel flowing back through the system again. To do this, turn the ignition key until you hear the fuel pump kick in for a few seconds, then turn key back to off. Repeat this several times to get the fuel flowing. If this doesn't help, you will need to ensure that the fuel pump is actually coming on. Let me know

May 24, 2009 | 1995 Dodge Ram

Not finding what you are looking for?
1999 GMC Jimmy Logo

Related Topics:

17 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...