Question about Nissan Cars & Trucks

Open Question

Miss fire on number 4 cylinder in 2002 maxima 3.5lt

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 100 Answers

SOURCE: miss fire on # 3 cylinder after complete engin overhall

check your firing sequence.

Posted on Jun 21, 2009

  • 1 Answer

SOURCE: miss fire on cylinder 1 and 2 coils replaced

have u put a new set off leads on it as mite be brakeing down under pressure

Posted on Jun 25, 2009

  • 6 Answers

SOURCE: Number 4 cylinder miss fire

Check your distributor cap & wires first. If all is ok pull the spark plug and check if it's oil fouled. If there is no oil on the plug the plug might be bad. if there is oil on the plug you can get an adaptor that screws over the end of the plug and shields it from getting oil fouled. Of course this is a temporary solution for a piston ring or valve seal problem. I had a caddy I ran with plug shields fo 5 years so they work! Good luck!....PS If your plug is oil fouled you can also use a heavier oil like a 20/50 or use 4 quarts of 10/40 and a quart of lucas oil stabilizer. This will help keep the oil where it belongs and don't forget to do an oil change every 2,500 to 3000 miles.

Posted on Sep 23, 2009

CarMech97
  • 427 Answers

SOURCE: 2002 escape miss fire on cylinder one

power not reaching cylinder 1 ignition coil. check electrical connections and wiring for any damage. test for power and ground at cylinder 1.
hope this helps.

Posted on Oct 07, 2009

  • 7353 Answers

SOURCE: code po304 #4 cylinder mis fire

ck if you have spark at the coil for that cylinder. check the plug wire closely. if it has spark at the coil, then replace all the spark plug wires.

Posted on Oct 12, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Just replaced valve covers on Nissan Maxima 2002 due to misfire. Now it smokes and burns oil every start? What's should I do .


If is is only smoking when you first start it up. Most likely the valve guide seals, oil is leaking into the cylinders and smoking when you start it up.

Mar 20, 2016 | 2002 Nissan Maxima

1 Answer

New plugs an coils code po300 still comes up maultiple miss fire?


Always start with basics. Check compression on each cylinder should be within 20 pounds of each other check manufacture spec.( Make sure new plugs and coils are firing) If thats all good get vacuum gauge on intake and check vacuum (18-21hg) if low check for vacuum leaks or plugged catalytic converter. If good go and fuel pressure and injectors. You have to do it systemmatically to narrow it down. Good luck.

May 31, 2015 | 2002 Nissan Maxima

3 Answers

Trying to find the firing order for a 2002 maxima


2002 Nissan Maxima 3.5 liter 24-Valve DOHC V-6

zjlimited_404.gif


Hope this helps (remember to rate and comment this free answer).

May 30, 2011 | Nissan Maxima Cars & Trucks

1 Answer

I have a 2002 duel ovethead cam, what is the fireing order for the spark plugs?


here ya go:

Firing Order: 1-4-2-5-3-6

Cylinder numbers:
1-2-3
4-5-6
(Frt. Of vehicle)

Coil Numbering (put this end of the wire on first)
--4 PIN--
--Connector--
-----------------
--1--- 2--- 3--
----------------
--5--- 6--- 4--

Feb 22, 2011 | 2002 Ford Taurus

1 Answer

What does miss fire on #4 cylinder mean. My engine light is on and had a diagnostic test, it indicated the number 4 cylinder was miss fireing.


Should be the plug wire, I had the same problem here, I took a wire from another car just to check it and sure enough, it was the plug wires, Just replace the whole set and keep a couple for spares. Hope this helps.

Oct 11, 2010 | 2002 Mercury Sable

1 Answer

Cylinder 5 misfire were is tha cylinder


CYLINDER NUMBER 5 IS STANDING IN FRONT OF VECHICLE IT WILL BE THE 5 CYLINDER COUNTING FRONT TO THE BACK CYLINDERS IS IN ORDER 1 2 3 4 5 6 THAT YOUR CYLINDER ORDER. YOU HAVE A INLINE 6 CYLINDER ENGINE.YOUR MISS FIRE COULD BE THE COIL - SPARK PLUG - CLOGGED OR FAULTY FUEL INJECTOR. ALSO INTAKE MANIFOLD VACUUM LEAK OR SLIGHT HEAD GASKET LEAK WILL CAUSE MISFIRE.

May 06, 2010 | 2002 GMC Envoy

1 Answer

My 95 nissan maxima se is not firing on its number 4 cylinder. How dangerous is this to drive until it can be fixed. I understand it could be spark plugs, and or coil. Anything else that might cause this...


If your car has a Power Transistor Unit like my 90 300ZX had, that could do it too, but it's more likely to be a coil or spark plug. You should not drive the car until this is solved. Having a missing cylinder throws the engine drastically out of balance and can cause severe damage.

Nov 13, 2009 | 1995 Nissan Maxima

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

13 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...