Question about Renault Cars & Trucks

1 Answer

Engine stalls idles low rpm

I have recently had my Fuel injector regulator and sensor replaced, however the engine is now idling at low revs and cuts out when stopped, what do you think is the problem?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 9 Answers

Adjust idle with the throttle body and see how that helps

Posted on Oct 11, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 178 Answers

SOURCE: rough idle stalls at low rpm's

hello first check your idle with the car running foot on brake see were your rpm reading is if your below 500rpm check your label underhood for your curb idle setting second see if theres a adjustment screw you can increase were your gas cable lever rest against your set screw underhood if you feel confident enough remove your iac motor idle air control valve if the bore were the end of the pintle extracts out to close has varnish builup our carbon it will stick creating vacuum leak type senario causing stalling rough idle sometimes even no start conditions good luck

Posted on Sep 18, 2008

  • 295 Answers

SOURCE: 1997 DODGE RAM 1500 360 VERY LOW IDLE

I think you have ruled out the engine with all the parts you have replace. The transmission torque convertor is in lock up mode all the time. The engine is having to hard of a time to stay at the normal idle. The over drive clutches and soleniod are most likely damaged in the transmission.
I think you should take the vehicle to a trasnmission shop , The can check the torque convetror soleniods and pressure control soleniod.

The oil light coming on bothers me. I know you have the rebuilt engine in the vehicle but I think the oil pump in the engine is starting to go out or could be weak. The lower bearings connected to the crank shaft might be starting to leak. Have the oil pressure checked .

Posted on Mar 19, 2009

  • 14 Answers

SOURCE: 1992 gmc chevy 350 wont idle when warm

This could be a number of things but i think that your problem sounds like a vacuum leak or an EGR problem. Try listening for leaks and try un-plugging the EGR solenoid valve one time.

Posted on Apr 17, 2009

bitchn65cuda
  • 70 Answers

SOURCE: 1996 s10 2.2 engine starts but idles rough and will not rev up.

Hi! You must be frustrated by now! your code is marking that the O2 sensor is bad in bank 1. Did you replace the O2 sensor that is located  before the catalytic converter?  The S10 has an O2 sensor specially made for that cat. its about 30$ That would explain for your blackened spark plugs; your pc on the car is asking for more fuel. GOOD LUCK!!

Posted on Apr 29, 2009

  • 62 Answers

SOURCE: 1999 VW Passat low idle

replace your fuel filter first. If that does not do it, then try an air-flow meter. (if the check engine light is on it may be an airflow meter.

Posted on Jul 11, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Low idle & vibration at idle


I don't know if this will help. Had a similar problem with a 99 Blazer.
Would drop to between 300 and 500 rpm at stop signs and red lights, would stall and shake.
Did all the same checks, replaced mass air flow sensor, replaced cam sensor, cleaned the fuel injectors but the problem was still there.
Replaced both #1 and #2 O2 sensors in the exhaust pipes and now the vehicle runs fine. The idle is back to a steady 750 rpm in all stopping conditions. The Mass air flow sensor and Cam position sensor get information from the O2 sensors.

Apr 10, 2014 | Ford Transit Connect Cars & Trucks

1 Answer

Engine cut out


Sounds like you may have fuel filter problem. you may want to check the pump and filters located in or near the fuel tank.
Go directly to the source ( Fuel Tank, Pump, Filters, Fuel Pressure Regulator and Injectors )
You may have water or grit in the fuel
Hope this helps

Mar 22, 2014 | GMC Sonoma Cars & Trucks

1 Answer

1989 mercedes 560 sel, gas, w126/ Car cold starts every morning and idles for 10 min. then stalls


the idle control motor probly worn-on the throttlbody--also the tps sensor - get intake area inspectd--a haynes manual will xplain complete car-partstore hazit--------starter fluid is used for low compression or weak spark

Dec 25, 2013 | Cars & Trucks

2 Answers

Camry stalling


Fuel filter,air filter,IAC sensor,Bring up low idle at throttle body is small set screw.

Jun 12, 2013 | Cars & Trucks

1 Answer

Quits running.


What is RPM,do you have gauge should be 750 to 800.at the idle.do you change air filter.Could be crankshaft sensor.

Feb 12, 2013 | 2000 Nissan Altima

1 Answer

89 Chevy Sprint takes about 5 minutes to warm up to be able to drive away or it stalls when I give it gas. The engine will rev up for 3-4 seconds then drop down and almost stall and then rev again during...


Plug the vacuum line you unplugged and the idle should come back. Change your air filter and the map sensor. check for correct coolant level and replace the coolant temp. sensor. This sensor affects cold starting and idle through the ECU (open loop mode, rich fuel mapping and 1200 rpm idle) It should go to closed loop mode in the ECU once engine warm up is achieved ( lean fuel mapping and normal 900 rpm idle). Do not unplug anything else till you perform an OBDII scan of the stored fault history

Jun 14, 2017 | Chevrolet Sprint Cars & Trucks

3 Answers

Engine cutting out when idling or slowing down


Here is the common cause of surges, stalls at stops, slow idle speed, erratic idle speed, rough idle and engine hesitation (and other problems), it is in most cases the idle speed control air-bypass valve and or throttle valve and upper intake, these area's get full of gunk and combustion residue over the miles and cause idle issues (stalls, low idle) like yours, Get a can of intake cleaner from any local parts store, not carb spray, intake cleaner, it is made by a company called CRC, remove the air intake hose to the engine, hold the idle high so the engine won't stall, then spray the can of cleaner into the intake while keeping the engine running, use at least 1/2 the can, shut down the engine and disconnect the battery for 5 minutes, then restart and complete a number of mixed driving cycles, town, freeway, stop and go etc., after a few days the problem will go away as the system will relearn to the clean intake

Jun 18, 2009 | 2004 Renault 181

1 Answer

Engine stalls when stepping on gas pedal and will not idle on its own.


Have you checked the ignition timing? Maybe you need to turn the distributor to the left or right if you don't have the timing light gun

Oct 02, 2008 | 1990 Honda CRX

1 Answer

C240 wagon (4-matic) idles low almost cutting out at stops


Hi,is never a bad thing to add a good fuel injector cleaner to your gas tank to prevent injectors from getting cloged ,you can try this for two days ,if no diference , check your air conditioner idle compensator,this regulates the idle when you turn the air on and off. good luck

Aug 18, 2008 | Mercedes-Benz C230 Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

188 people viewed this question

Ask a Question

Usually answered in minutes!

Top Renault Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

xxxxxx xxx

Level 3 Expert

4848 Answers

yadayada
yadayada

Level 3 Expert

75822 Answers

Are you a Renault Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...