Question about Honda Cars & Trucks

1 Answer

Pressure control solenoid on a 2005 diesel crv, will not turn over but runs just fine.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Honda Master
  • 20,706 Answers

What does turn over mean/
1: I can crank the engine , that is the starter works ok.
2: the engine does not start and run,?
turn over means , NADA.
it cranks and starts.
or in rare cases cant crank but you push started car ok.

the runs fine, implies , you push starter car? or like me
park on hills, (too cheap to buy a good battery) grin? LOL

Posted on Nov 09, 2013

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 333 Answers

SOURCE: p2716 pressure control solenoid d 2005 toyota

This is very common on Matrix/Corollas and is repairable by way of replacement PCM to correct invalid parameters. the labor is low but the part is very expensive.

Expect approximately $89 or less in labor, and $648 for the new PCM



Reference bulletin #TC015-07

The contents are below:

TRANSMISSION & CLUTCH
TC015-07 Title:
HARSH SHIFT AND M.I.L. "ON"
DTC P2716 Models:
'05 - '07 Corolla & Matrix (1ZZ-FE) September 20, 2007

Introduction
Some 2005 - 2007 model year Corolla and Matrix vehicles equipped with an automatic transaxle may exhibit a harsh shift condition and a M.l.L. ON" with DTC P2716 stored.
Improvements have been made to the Engine Control Module (ECM) (SAE term:
Powertrain Control Module/PCM) to reduce the possibility of this condition occurring.

Applicable Vehicles
^ 2005 - 2007 model year Corolla and Matrix (2WD) vehicles equipped with the 1ZZ-FE engine.
Warranty Information
Applicable Warranty*:
This repair is covered under the Toyota Federal Emissions Warranty. This warranty is in effect for 96 months or 80,000 miles, whichever occurs first, from the vehicle's in-service date.

Posted on Oct 29, 2009

emissionwiz
  • 76109 Answers

SOURCE: Pressure Control Solenoid "D" location on a 2005 Toyota Corolla?

this solenoid is part of the solenoid pack that is located on the valve body inside the transmission.

Posted on Mar 28, 2010

  • 14036 Answers

SOURCE: where is the pressure control solenoid on 2005

PRESSURE CONTROL SOLENOID IN TRANSMISSION VALVE BODY IN THE TRANSMISSION SIDE PAN COVER.YOU NEED A TRANSMISSION MANUAL MU4 OR MU5 FOR THAT VECHICLE. TO LOCATE PRESSURE CONTROL SOLENOID.BECAUSE YOU HAVE MANY SOLENOIDS IN VALVE BODY.

Posted on Jul 20, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Honda 2005 crv engine code P0780 what does that mean?


shift control system fault
Possible causes
- Low transmission fluid level
- Dirty transmission fluid
- Faulty shifting solenoid valve
- Shifting solenoid valve harness is open or shorted
- Shifting solenoid valve circuit poor electrical connection


Read more: http://engine-codes.com/p0780_honda.html#ixzz3EEnWkTOq

Sep 24, 2014 | Honda CRV Cars & Trucks

1 Answer

How to fix : clutch pressure control solenoid valve B failure in 2004 honda crv


Can you explain more , my crv only has a master and slave cylinder on the clutch system can't see a solo niod valve

Aug 15, 2014 | Cars & Trucks

1 Answer

Honda crv diesel lossof power at low revs


Diesel
low compression
or under fueled.
did you do all service, (filters and what not?) buy the book?

Feb 03, 2014 | 2005 Honda CRV 2.2

1 Answer

From a stop engine is running fine (not over speeding) but vehicle starts slowly as if on wrong gear


code p0740 refers to torque converter clutch (TCC) solenoid --circuit malfunction Causes---Wiring---TCC solenoid--- ECM/TCM
Code p2716 refers to transmission fluid pressure(TFP) solenoid D-electrical Causes---Wiring---TFP solenoid.
Code p0785 refers to shift/ timing solenoid circuit malfunction Causes---Wiring---shift/timing solenoid---ECM?TCM The common fault here appears to be the TCM ( transmission control module) have it check out..

Apr 07, 2013 | 2005 GMC Sierra

1 Answer

Driver side rear suspension 20 mm lower then the opposite side spring and rubber bushes are fine honda crv 05 diesel


The springs may look fine but one may be weak on that side. Also the shock obsorber may be weak. you need to get them checked.

Jul 02, 2011 | 2005 Honda CR-V

1 Answer

2005 impala LS with 3.8 eng. & 61290 miles. Transmission started shifting hard on 1st & 2nd gears, just out of nowhere. Is this a common problem on Chevys? Once on open high way vehicle runs...


two things: Pressure control solenoid first. Second issue is the valve body. These are common issues, but 9 times out of 10 its just the pressure control solenoid. Power steering, could have a leak, that causes air,which in turn causes noise or yes, a noisy pump.

Nov 29, 2010 | 2005 Chevrolet Impala

1 Answer

Where is the pressure control solenoid on 2005 vibe


PRESSURE CONTROL SOLENOID IN TRANSMISSION VALVE BODY IN THE TRANSMISSION SIDE PAN COVER.YOU NEED A TRANSMISSION MANUAL MU4 OR MU5 FOR THAT VECHICLE. TO LOCATE PRESSURE CONTROL SOLENOID.BECAUSE YOU HAVE MANY SOLENOIDS IN VALVE BODY.

Jul 20, 2010 | 2005 Pontiac Vibe

1 Answer

Pressure Control Solenoid "D" location on a 2005 Toyota Corolla?


this solenoid is part of the solenoid pack that is located on the valve body inside the transmission.

Mar 28, 2010 | 2006 Toyota Corolla

2 Answers

F350 Super Duty Diesel 2005 suddenly died while driving.Cranks fine but wont start.Help


that's good but it still doesn't rule out a leak in the high pressure oil system. When you turn on the key do the injectors buzz like normal? Usually 5-10 secs

Jan 09, 2009 | 2005 Ford F 350 Super Duty

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

104 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...