Question about 2008 Toyota Yaris 1.0
Check the fuel pump pressure (44-49 psi), MAF sensor, catalytic converter, clutch plate (if manual trans), CVT oil and forward clutch (CVT Trans).
Posted on Dec 14, 2013
Not getting enough back pressure in the exhaust system. weak or lose of power can be caused by this. usually middle box. if you hit it and it rattles thats were your problem is. also can be piston rings falling under pressure.
Posted on Oct 11, 2013
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: 2002 sequioa sudden stall
Often when the battery is disconnected or replaced the computer will lose it's learned idle settings. You could try letting the engine idle in park until the engine temperature comes up to normal and leave it like that for a few minutes, then put the Air con on and let it idle again for a few minutes, then switch the air con off and put it into drive. If it does not stall, let it idle in drive for 2 minutes or so, and then do the same with the Air con on. This should relearn the base idle settings and stop it from stalling on you. Before you carry out this procedure you should make sure that when you replaced the battery you didn't remove any other plugs or knocked anything that may be causing the fault. If you try this procedure and it still stall when you select drive, you will need to get a Mechanic to check the vehicle over.
Hope this helps,
Posted on Nov 02, 2008
SOURCE: loses power on steep grade
Sounds like you need a clutch replacement.
Try this. Go somplace where there are no cars, and no possibility of running into anything. Stop the car. Set the park brake. With the engine running, put the vehicle in 1st gear. Hold the foot brake pedal, and give it gas, and let out the clutch slowly.
If the engine does not stall real quick, the clutch disc is bad.
Posted on Jan 24, 2009
Tips for a great answer:
Dec 12, 2016 | Toyota Cars & Trucks
Jan 29, 2016 | Cars & Trucks
Feb 19, 2015 | 2007 Ford Edge SEL Plus
Sep 04, 2011 | 1995 Ford Contour
Aug 30, 2011 | 1999 Lexus RX 300
Apr 21, 2010 | 2007 Toyota RAV4
Sep 30, 2009 | 2003 Ford F250 Super Duty Crew Cab
Jun 15, 2009 | 2008 Toyota Sienna
172 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: