Question about 1997 Chevrolet Blazer

Open Question

On a 1996 chevy blazer do you drive in overdrive or drive normally

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 41 Answers

SOURCE: how do you remove the starter from a 1996 chevy 4WD blazer?

NO, it's kind of tight, but it's not that bad. You do need to remove the torque converter cover, and slide/rotate it as much to the driver's side of the vehicle as possible.

Posted on Jan 23, 2009

Ad
  • 1 Answer

SOURCE: 96 chevy blazer 3rd gear and overdrive slipping

i got a 1996 chev. blazer s-s10 4.3 engine 4x4.problem i got is i got 1st 2nd & overdrive & reverse but no 3rd gear what should i do

Posted on Jan 19, 2010

tncspoor
  • 10 Answers

SOURCE: 1996 Blazer: How do install a 1996 chevy blazer serpentine belt...

It will have a diagram right above the fan blades to show you how it needs to be ran. Just need to release some pressure off the belt tensioner to make it all fit

Posted on Aug 17, 2010

  • 6 Answers

SOURCE: 1996 chevy blazer tire size

stock is generally the 235/75r15, but if you can find someone to install them or do it yourself easily be able to run 31x10r15 for a little meatier look, this would involve a slight trim of the front skirt edge on some models or depending on your suspension. Any tire shop would easily be able to tell you stock tires or what would fit, but most major retailers (walmart, fleetfarm) will not install ANY tire not listed as factory. so you would have to find a private shop then.

Posted on Sep 03, 2010

Molson02536
  • 3854 Answers

SOURCE: loud tweeting noise while driving 1996 chevy

Common noise heard when the brake pads are getting close to the end of its life and will need to be replaced. Replace the brake pads and rotors since the rotors are not that expansive, might as well replace them also.

Good luck and stay safe, thank you for using fixya.

Posted on Oct 23, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

In a 95 chevy blazer 4 by 4 Should the transmission be in drive or overdrive for normal driving condition?


normal drive yes the od unit comes on after 40 mph is reached and maintained above that speed , if you happen to engage 4x4 then the od shouldn't come on at any speed , point of reminder this model and year has a recurrent problem with 4x4 transfer case not disengaging all the way , and causes some delay in transfer of engine power to proper drive axles , its mostly caused by improper transfer case lube oil changes and dirt builds up inside it causing all sort of mayhem

May 04, 2016 | Cars & Trucks

1 Answer

Schematic for 1996 chevy blazer fuel tank


Get a Haynes or Chiltons Manual for diagrams and instructions for your vehicle.

Sep 13, 2014 | 1996 Chevrolet Blazer

1 Answer

What gear do I use when driving on normal road in my 98 Chevy blazer


The owners manual says to use the overdrive gear under normal conditions and when pulling a trailer.You are suppose to drop down on gears only when going up a incline ( Hill ) that is causing you to accelerate drastically.

Apr 26, 2011 | 2000 Chevrolet Silverado 1500

1 Answer

1995 chevy blazer transmission will not let truck shift out of second when in drive


Normally while driving in overdrive (4th gear) you will feel it start slipping and finally slide into third gear. Then 3rd gear slips out into second, and you will never see 3rd or 4th gear again. I'm guessing this was the problem? If so its time for an overhaul

Dec 22, 2009 | 1995 Chevrolet Blazer

1 Answer

I have a 1996 chevy blazer replaced the fuel and


No, the fuel pressure valve may be stuck open so that the fuel pressure is too low when you start up, but the pump keeps up after the engine starts...
The fuel pressure valve is draining the fuel back into the fuel tank when the Blazer is parked.


Sep 28, 2009 | 1996 Chevrolet Blazer

4 Answers

96 chevy blazer 3rd gear and overdrive slipping


i got a 1996 chev. blazer s-s10 4.3 engine 4x4.problem i got is i got 1st 2nd & overdrive & reverse but no 3rd gear what should i do

Jun 30, 2009 | 1996 Chevrolet Blazer

1 Answer

1996 chevy blazer, the front passenger side axle is lock in and other tires can move freely


WI replace the wheel bearing and put brakepads on.This is when the problem start...When I am driving I hear a stumping and humming sound. 1996 CHEVELETE BLAZER . YOU CAN PUT IT IN FOUR WHEEL DRIVE

Apr 02, 2009 | 1996 Chevrolet Blazer

1 Answer

1997 Chevy Blazer will not go in overdrive


If you open the hood on top of engine in front you will see what looks like a tempature sending unit it screws into the intake with a 2 wire plug on it, i cant remember what its called, but i know when truck gets to tempature it sends a signal down to trans. so it will shift into overdrive, when it goes bad it won't send the signal hense no overdrive. I have chg. a couple of them with a simmler problem you got and it fixed them. $10.00 at autozone.

Feb 05, 2009 | 1998 Chevrolet Blazer

2 Answers

Whats the cost to repair the overdrive in a 96 chevy blazer


Trans needs to be rebuilt. I just had one rebuilt for a 2000 chev pickup $2000 

Dec 18, 2008 | 1996 Chevrolet Blazer

1 Answer

I was wanting to know if u could tell me how much it would cost to repair the overdrive in a 96 chevy blazer?


It,s expensive i beleive it,s a 700r4 transmission about $900 is a cheap figure some shops charge more it,s a complete rebuild.Usually the reverse will go out at the same time.

Dec 18, 2008 | 1996 Chevrolet Blazer

Not finding what you are looking for?
1997 Chevrolet Blazer Logo

Related Topics:

61 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8499 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...