Question about 1995 Mazda 626

1 Answer

Random beeping and locking and unlocking of doors

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.


    An expert that gotĀ 5 achievements.


    An expert whose answer gotĀ voted for 20 times.


    An expert who has answered 20 questions.

  • Contributor
  • 34 Answers

Sounds like the remote-entry sensor receiver is failing or becoming short-circuted. it is located in the trunk. on a 2000, it is on the driver-side near the rear-dash mount speaker. rectangular black box with small wire-harness. to eliminate the problem until a replacement or shorted wire can be found, press the " deactivate remote entry" switch on the inner-upper driverside rear fender. inside trunk. just make sure to keep the keys in your pocket.

Posted on Dec 27, 2013

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2006 Pontiac g6 door locks gone crazy, locking and unlocking randomly.

I would take a close look at the connections in the power distribution box , also look at the door switches. most likely will find a loose connection coming into the power distribution box.

Oct 18, 2015 | 2006 Pontiac G6

1 Answer

My central locking is fairly dodgy

check the cable going to the driver's door by the driver's door lower hinge. check for a wire that is damaged.

Aug 23, 2014 | 2001 Ford Focus

1 Answer

Door locks cycle on/off randomly

Check your negative terminal on battery , for corrosion !

Jun 16, 2014 | 1993 Ford Taurus

1 Answer

While I'm driving, the car locks and unlocks at random. what's the problem?

there is a possible 2x ratio solution, have the doorlocks checked for a open circuit, ( break in the wiring) or check the contact points on the doors, open all doors and with a scrw driver lock each door individually and check whick door lock causes the doors to unlock again, that doorlock will then be the root cause problem.

solution 2 , the doorlock switch could be faulty

Dec 20, 2012 | 2001 Nissan Altima

1 Answer

Car Alarm beep Problem

Sometimes tow beeps when locking means that one of the door is not properly closed or is ajar. If that is not the case, get it reprogrammed.

May 30, 2012 | Proton Cars & Trucks

2 Answers

2004 suburban doors randomly lock and unlock while driving

There are two relays that control the locks. One controls locking, the other unlocking. One of those could be defective. Replace one. If that corrects the problemyou are good to go. Do not discard the old relay yet. If the problem persists replace the other existing relay with the old on you just removed. I believe the lock relay actually works through the unlock relay or vice versa.

May 21, 2012 | 2004 Chevrolet Suburban

1 Answer

Random door locking

theres 1 thing I can think of, if you put your key in the door 2 unlock it and hold the key 2 the unlock position for a few seconds all the doors should unlock, well the electronics inside the door panel that control that is probably bad or shorting out causing the doors to lock . You can also hold the key 2 the lock position for a few seconds and lock all the doors

Dec 08, 2011 | Cadillac Cars & Trucks

1 Answer

1998 Taurus SE warning chime beeps as you get in the driver door

Hi John,

Had a similar problem with my Saturn. Door chime going all the time, the seat belts going up - down - up for no apparent reason.

Turned out to be the switch in the door jamb had become unseated. As it randomly made and broke contact, the cars computer thought the doors were opening and closing, then acted accordingly.

I remounted it with the help of a hot glue gun (plastic mount).

Hope this info helps with your problem.

Best regards

Aug 03, 2009 | 1996 Ford Taurus

Not finding what you are looking for?
1995 Mazda 626 Logo

62 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts


Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides