Question about Cars & Trucks

1 Answer

Mitsubishi shogun sport has a high idle about 1200rpm but when the car comes to a stop it drops off back to about 800 rpm

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 3,178 Answers

Idle valve on the intake may need cleaning. a build up of muck from the air intake line can cause this also change the air filter.

Posted on Oct 11, 2013

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

SOURCE: idle problem

you can't adjust the idle it's all done by the pcm.you might have a IAC going bad or sticking(idle air control solenoid)

Posted on Jun 25, 2008

zappanut
  • 959 Answers

SOURCE: high revs

being a fuel injected engine , there are many reasons this could be happening.
from the top , lets check the Manifold Absolute Pressure (M.A.P.) sensor , as it is easiest.
Find the MAP sensor , it has a couple a wires and a vacuum tube going to it and is on the firewall or fender support under the bonnet.
Disconnect the wire harness from it (small plug with wires).
If the engines RPMs drop to normal , replace the MAP sensor.

Posted on Dec 01, 2008

  • 15 Answers

SOURCE: High Idle speed on 1989 Merc Sable, 3.0L V-6. Approx 2000 RPM

My wife had a 93 ford tempo 4 cylinder with same problem.It turned out to be the idle air solenoid mounted on the air intake manifold.

Posted on Jan 17, 2009

Molson02536
  • 3854 Answers

SOURCE: My idle is running as high as 3000 rpm while

It could also be carbon build up on the throttle body, but regardless the cure is the same. Your going to need to clean the throttle body and the idle air control valve (IAC). With a can of throttle body cleaner, (follow instruction on the can) clean the throttle body blade and the IAC passage way in the throttle body. Once the throttle body is cleaned, with the engine off, turn the ignition key to the on position (engine not running) and wait for 30 seconds and then turn if off for 10 seconds and then start it. This should reset the IAC, if it did not work do it again and see if it helps. If not clean out the IAC passage way again. The turning on and off the ignition reset's the IAC and it may still be stuck with carbon build up. Once the engine has started, Note there will be lots of smoke form the tail pipe, that's normal. It's just the left over throttle body cleaner and carbon being burn off, take's not more then 10 min to burn off. Good luck and this should keep you from replacing the IAC. Oh and don't use Carb cleaner, Carb cleaner is to corrosive to the throttle body gasket.

Posted on Nov 04, 2009

  • 1 Answer

SOURCE: engine high rev at stop and slowly goes to idle speed.

I've got Hyundai Lantra 1.6 year 2000. It's take time to start when it's hot. When I start my car it revs at about 2k-3k rpm. It also does it when I come to a stop. When I come to a stop it will stay at a higher rpm than that of idle speed. It drives ok when on freeway but uses more petrol. I have changed the water & petrol pump but no luck

Posted on Feb 12, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

High idle rpm + hyundai santro


run the fault codes before you waste any more money as there are several sensors that will cause high idle.

Jul 17, 2013 | Cars & Trucks

1 Answer

I have a 2008 mercury Milan with nearly 60k miles on it. When I come to a stop the rpm drops by 1000 then recovers quickly. What should I do to fix the problem? Any suggestions will be greatly appreciated.


Check out related help links to troubleshoot these problem:----Click the link below:---Idles Fine but RPM jumps in drive mode? http://technoanswers.blogspot.in/2012/07/idles-fine-but-rpm-jumps-in-drive-mode.html
---------Mitsubishi Lancer rpm needle bounces? http://technoanswers.blogspot.in/2012/02/mitsubishi-lancer-rpm-needle-bounces.html
--------How to adjust rpm on 2009 dodge charger SRT8?


http://schematicsdiagram.blogspot.com/2011/12/how-to-adjust-rpm-on-2009-dodge-charger.html
---------
Engine cuts out at 3000 RPM? http://schematicsdiagram.blogspot.com/2011/12/engine-cuts-out-at-3000-rpm.html

---------

Cold start problem and vehicle shudder around 2500 to 3500 rpms
http://repairhelpcenter.blogspot.com/2012/10/cold-start-problem-and-vehicle-shudder.html

---------
High rpm in neutral? Inconsistant high RPM in neutral? http://technoanswers.blogspot.in/2012/02/high-rpm-in-neutral-inconsistant-high.html

-----------
Jetski Sputters and Low RPM? http://whatisbyme.blogspot.in/2012/07/jetski-sputters-and-low-rpm.html

--------
Fuel Injection Problem And RPM suddenly increases http://whatisbyme.blogspot.in/2012/07/fuel-injection-problem-and-rpm-suddenly.html

----------
2005 Toyota Highlander: Engine runs hard RPM below 3000? http://whatisbyme.blogspot.in/2012/05/2005-toyota-highlander-engine-runs-hard.html

---------
1987 Toyota Camry: RPM Drops going Up hills? http://whatisbyme.blogspot.in/2012/05/1987-toyota-camry-rpm-drops-going-up.html

-----------
Cruise Control stops working, Excessive cranks to start the engine and RPM goes max 2500 http://whoisbyme.blogspot.in/2012/07/cruise-control-stops-workingexcessive.html

----------
1990 Toyota 4Runner: Engine cuts off when reaches 2000 RPM?


http://whatisbyme.blogspot.in/2012/05/1990-toyota-4runner-engine-cuts-off.html

------------
1999 Toyota Camry: Erratic stalling and high engine RPM at idle?


http://whatisbyme.blogspot.in/2012/05/1999-toyota-camry-erratic-stalling-and.html

---------
1995 Toyota LS: Misfire at idle or low RPM http://whatisbyme.blogspot.in/2012/04/1995-toyota-ls-misfire-at-idle-or-low.html

-----------
Lexus RX: Tapping noise under Valve Cover At Low RPM? http://technoanswers.blogspot.in/2012/04/lexus-rx-tapping-noise-under-valve.html

----------
These will help.
Thanks.

Nov 22, 2012 | Cars & Trucks

1 Answer

Driving on the road the RPM goes higher wituout speedind


Check out related help links to troubleshoot these problem:----Click the link below:---Idles Fine but RPM jumps in drive mode?http://technoanswers.blogspot.in/2012/07/idles-fine-but-rpm-jumps-in-drive-mode.html
---------Mitsubishi Lancer rpm needle bounces?http://technoanswers.blogspot.in/2012/02/mitsubishi-lancer-rpm-needle-bounces.html
--------How to adjust rpm on 2009 dodge charger SRT8?


http://schematicsdiagram.blogspot.com/2011/12/how-to-adjust-rpm-on-2009-dodge-charger.html
---------
Engine cuts out at 3000 RPM?http://schematicsdiagram.blogspot.com/2011/12/engine-cuts-out-at-3000-rpm.html

---------

Cold start problem and vehicle shudder around 2500 to 3500 rpms
http://repairhelpcenter.blogspot.com/2012/10/cold-start-problem-and-vehicle-shudder.html

---------
High rpm in neutral? Inconsistant high RPM in neutral?http://technoanswers.blogspot.in/2012/02/high-rpm-in-neutral-inconsistant-high.html

-----------
Jetski Sputters and Low RPM? http://whatisbyme.blogspot.in/2012/07/jetski-sputters-and-low-rpm.html

--------
Fuel Injection Problem And RPM suddenly increaseshttp://whatisbyme.blogspot.in/2012/07/fuel-injection-problem-and-rpm-suddenly.html

----------
2005 Toyota Highlander: Engine runs hard RPM below 3000?http://whatisbyme.blogspot.in/2012/05/2005-toyota-highlander-engine-runs-hard.html

---------
1987 Toyota Camry: RPM Drops going Up hills?http://whatisbyme.blogspot.in/2012/05/1987-toyota-camry-rpm-drops-going-up.html

-----------
Cruise Control stops working, Excessive cranks to start the engine and RPM goes max 2500 http://whoisbyme.blogspot.in/2012/07/cruise-control-stops-workingexcessive.html

----------
1990 Toyota 4Runner: Engine cuts off when reaches 2000 RPM?


http://whatisbyme.blogspot.in/2012/05/1990-toyota-4runner-engine-cuts-off.html

------------
1999 Toyota Camry: Erratic stalling and high engine RPM at idle?


http://whatisbyme.blogspot.in/2012/05/1999-toyota-camry-erratic-stalling-and.html

---------
1995 Toyota LS: Misfire at idle or low RPMhttp://whatisbyme.blogspot.in/2012/04/1995-toyota-ls-misfire-at-idle-or-low.html

-----------
Lexus RX: Tapping noise under Valve Cover At Low RPM?http://technoanswers.blogspot.in/2012/04/lexus-rx-tapping-noise-under-valve.html

----------
These will help.
Thanks.

Nov 22, 2012 | 2008 Toyota Avalon

1 Answer

High rpm at idle: code P1294 target idle not reached


Hi Rodrigo, The idle control is activated by the temperature sender unit. It sounds as though yours is giving a cold signal to the computer and it pushes up the idle speed to compensate as if it has just started. The sender unit is a different unit from that which operates the gauge on the dash instrument panel. Replace it and I believe your problems will be over.Regards John

Apr 29, 2012 | 1995 Mitsubishi Eclipse

1 Answer

'92 Mitsubishi Diamante - Stalls sometimes when come to a stop


find the Idle air control valve on the side of the intake and then take off and clean or replace you could try taking a small ball peen hammer and tapping it lightly while it is idling let will genarly free them up

Mar 04, 2009 | 1992 Mitsubishi Diamante

1 Answer

High jdle after warm up on 98 chevy k1500 4.3l v6


egr vlve itself will cause rough idling ,stalling,stumbles during accelaration,iwould take it off clean valve ports of carbon deposits,put it back on and see,egrs are exp.enough,and like ccn7 said sounds like tps problem,but usually they give a code

Mar 03, 2009 | 1998 Chevrolet Blazer

1 Answer

Hesitation or stumble during acceleration


take your car for a tune up
if they are carburetor type motors you may need your carbie cleaned and a tune up
if you clean it your self with carbie cleaner it may increase in idle speed this is nothing to worries about it is a simple adjustment
with a carburetor type motor they tend to idle higher when their cold this is the automatic choke kicking in and normally it should happen till the car is a bit warmer and the accelerator has been depresses
although a car should idle at 800 rpm my paddok car dose when it is cold it idles at 1200rpm i like it this way as the car warms up quicker as i will not drive a car while it is cold
hope this helps
ricko

Oct 20, 2008 | 1989 Nissan Pathfinder

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

83 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...