Question about 2004 Land Rover FreeLander

1 Answer

I have a freelander td4 on a 2000 plate.it has been very lazy starting espeacially first thing.diagnostic test shows low pressure in fuel pump,this was changed and still lazy first thing,turns over but doesnt fire,after 3 or 4 attempts goes but some times drops out,i have also put a new battery on. any one help?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Contributor
  • 23 Answers

Try checking the glow plugs if there ok try checking the camshaft sensor ( fitted on top of cam cover)

Posted on May 01, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Put new EC module, IT module, distributor EGR valve, coil, TP sensor and fuel pump works. The car cranks but will not fire.


What's missing ? Spark , fuel pressure , or compression. Try spraying carb cleaner into the engine ,throttle plate . Does it try to start then ? If the injectors are bad it will not start , just crank ! Videos on youtube showing how to test fuel injectors with a ohm meter .

No Start Diagnostic Basics EricTheCarGuy
047 Engine Hard to Start or No Start Scan Data for Ignition Testing Fuel Injectors Fast


May 24, 2017 | Cars & Trucks

2 Answers

2005 2KD Hiace, starts lazy,revs good when it starts but accelerator goes dead, check light comes on, then in about 2 minuets the engine dies. 093 code.


fault code is missing a letter and first number
so its P0093 large fuel leak

the fault list has list of what to check
http://www.obd-codes.com/p0093

Fuel injector failure, Fuel line common rail leak, Fuel pressure sensor malfunction
Fuel pump or lift pump failure, Fuel heater constantly on Fuel temperature sensor failure ,

Leaks at any point in the high pressure circuit Electrical connector corrosion or seating problems
Fuel pressure regulator malfunction Fuel filter plugged dropping the fuel line volume Injector pump leak
Fuel control actuator failure
Cascade overflow valve malfunction Short in the electrical harness at the injectors or to the ECM Fuel pressure limiting valve ECM failure
Copyright OBD-Codes.com

Jun 07, 2016 | Toyota Cars & Trucks

2 Answers

Lately my freelander cranks but no start.


2001 2003 LAND ROVER FREELANDER SERVICE MANUAL
just download the service manual and all your queries will be solved :)

Jan 16, 2016 | 2002 Land Rover Freelander

1 Answer

I have a 2004 land rover freelander and it cut off after fitting in injector now it just cranks and won"t start


If the injector you fitted is faulty..it wont build fuel pressure and start.Have an injector leak off test done to identify if injector(s) are faulty or not. Also check the low pressure pump underneath drivers rear behind wheel...will often jam before failing...if it dont run with ignition on / cranking...give it a little tap.

Feb 18, 2015 | 2004 Land Rover FreeLander

1 Answer

Astra van 1.3 diesel starts but won't run


What tests have you run. Has the maintenance been good and on time? Can you run a compression test, fuel pressure test, and an oil pressure test. The injection pump needs good clean oil to work correctly. The filters need to be clean, low fuel pressure can affect, even damage fuel injectors. I wish that I could be more help but I need more info to be more useful. Good luck.

Feb 06, 2014 | Cars & Trucks

1 Answer

I have a 1988 suburban 1500 4x4 5.7 liter v8. I replaced fuel pump and filter, will start and run for about 10 seconds then die and will not restart. Not getting fuel somehow. Injectors were also replaced....


Most likely it is the fuel pressure regulator..also check for spark here's some info for you.. The first thing to do is check for spark.

Disconnect #1 ignition wire at the spark plug.
Install a spark tester into the end of the spark plug boot.
Have an assistant crank the engine over and check for spark at the tester.
Repeat this process at each spark plug.
If any cylinder does not show spark, proceed to secondary component tests.
If ALL secondary components show no spark, test components individually.
If all cylinders test O.K., inspect for fouled spark plugs and clean or replace as necessary.

2010-08-21_174426_1.jpg

If spark checks out good, then you could have a fuel delivery problem. I would recommend to start by checking fuel pressure. Fuel injected cars are very fuel pressure sensitive. Fuel pressure is very important and must be within specifications! But if the pressure is low, it does not mean the pump is bad. A plugged fuel filter, a pinched line, and low voltage at the pump can contribute to low fuel pressure. All three must be check before replacing the pump! You can get a fuel pressure gage at a local auto parts store for cheap.

Fuel pressure testing is frequently overlooked but it is one of the common causes of poor performance. The test procedure must include testing that will insure normal
fuel pressure under all operating conditions.

Key Factors

1. Fuel demands are low at idle.

2. Wide open throttle at high engine revs uses the most fuel.

3. Port injection fuel pressure must be reduced when manifold vacuum is high. Vacuum pulls fuel out of the injector causing it to deliver too much fuel if the pressure remains high. Manifold vacuum is used to open the pressure regulator at a lower pressure when vacuum is high.2010-08-21_175858_1.gif

Mar 31, 2013 | Cars & Trucks

1 Answer

I JUST INSTALL A GOOD ENGINE ON A 2004 V6


The ECU controls the firing of the injectors based on the position of piston and valves which the Cam and Crank sensors report to the ECU.
Your saying the pump works(b+ at the pump and its buzzing) but there is no residual pressure to start the vehicle and you don't know if the pump can produce the pressure needed to keep the vehicle running.
Well fuel pressure testing is dangerous.
So I'll start with making sure B+ is making it to pump and its buzzing.If pump buzzes then use a fuel pressure gauge and attach it to the schrater valve on the fuel rail and test its residual pressure. Use shop manual to determine if you have the correct residule.
Then do whatever shop manual tells you to test for running fuel pressure.
If dealing with fuel is not your thing then take it to a repair shop. It's safer for one thing

I'm gonna call it at the pump cause if there is no residual pressure that means pump is defective and you will finish burning up pump trying to get the vehicle to start.

May 18, 2010 | 2002 Land Rover Freelander

3 Answers

How do u know if you need a new fuel pump


You will have loss of power. intermittent stall or no start. or if it goes out completely no start at all. You can have your fuel pressure tested and you can have a lab scope connected to the fuel pump circuit and a trained mechanic can tell the integrity of your fuel pump by the wave pattern on the lab scope.

Nov 02, 2009 | 2005 Pontiac Grand Am

2 Answers

Low Fuel Pressure on Landrover Freelander TD4


From 53 reg onwards, diesel pump is under R.H. rear wheel arch, hidden by the plastic wheel arch liner. Older versions have combined fuel pump/sender in the tank (under R.H part of rear seat).
You should be able to hear a faint purr from the pump when ignition is turned on but engine not yet running.

Oct 07, 2009 | 2003 Land Rover Freelander

1 Answer

Freelander td4 bmw engine will not start


fuel rail preasure rgulator valve may be faulty

Sep 12, 2009 | 2003 Land Rover Freelander

Not finding what you are looking for?
2004 Land Rover FreeLander Logo

369 people viewed this question

Ask a Question

Usually answered in minutes!

Top Land Rover Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

yadayada
yadayada

Level 3 Expert

75822 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8215 Answers

Are you a Land Rover Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...