Question about 1999 Volkswagen Cabrio

Open Question

Location of the cam sensor on a 2002 volkswagon cabrio

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
michigan man
  • 3533 Answers

SOURCE: Where is the camshaft position sensor on 2001 VW Cabrio?

try autozone.com to see if they have your car listed for diagrams pictures and step by step instructions if your car is not listed then try your local library they have all the car manuals and even copy them for you

Posted on Mar 20, 2009

Ad
bschilz
  • 2049 Answers

SOURCE: location of crank sensor 1998 jetta 2.0

It's located near the cam gear on the front of the engine however, the crank sensor, to the right of the oil filter near the bell housing is the part notorious for going out on these cars, and causing a p0322 and/or p0341 code, and sometimes others as well To replace the crank sensor you have to: Support the motor with a floor jack. Remove the starter, 2 of the starter bolts connect to the motor mount. Remove the motor mount from the frame, very easy. Remove the oil filter. That will give you just enough room to get an allen wrench in to remove the bolt holding the sensor in.

Posted on Oct 25, 2009

  • 192 Answers

SOURCE: 2002 volkswagon cabrio glx fault code p1582 idle

For the Volkswagen cars the Throttle body is actuated by a motor and sensor. The motor opens and closes the throttle at idle to allow more or less fuel in as needed. Over the miles as the car engine ages and accumulates dirt the Engine control unit has to push the motor rod out a little further to allow more air into the engine. The P1582 code is thrown when the motor of the TB is at its end of travel and cannot go any further. If you are VERY technical and DIY with cars you can possibly clean it but its a laborious task. Here are instructions for a Jetta (you have similar engine) and has its dangers for further damage. http://faculty.ccp.edu/faculty/dreed/campingart/jettatech/p1582/index.htmOtherwise it might be best to have yoru dealer or mechanic replace the Throttle body and clear the code. The repair will require VAGCOM a Volkswagen software program to recode teh ECU and set timing, mixture, etc after eitehr cleaning or replacement. The lin

Posted on Jun 06, 2010

Smith-alone
  • 360 Answers

SOURCE: where is the fuse panel located on a 2002 cabrio

Hi, the f.use box is located under the driver side dash board, far left side. Panel drops down right above the hood latch.
Take care.

Posted on Jul 24, 2010

  • 1 Answer

SOURCE: 2002 volkswagon cabrio light is

I had this problem, took it in to the shop and it was the thermostat had to be replaced. Hope this helps.

Posted on Feb 11, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Power windows and mirrors do not work on my 2000 Volkswagon Cabrio


MOST LIKELY BLOWN FUSE OR RELAY CHECK OWNERS MANUAL WILL SHOW THE LOCATIONS.

Jan 03, 2013 | 2000 Volkswagen Cabrio

1 Answer

2002 volkswagon cabrio light is on looks like a boat/water. what does that indicate.


I had this problem, took it in to the shop and it was the thermostat had to be replaced. Hope this helps.

Feb 10, 2011 | 2002 Volkswagen Cabrio

1 Answer

2001 volkswagon cabrio power windows on driver side wont go up and passenger window wont go down, stopped working all at the same time


The Cabrio electric window issues are most often related to a bad Window regulator. My wife owns a 2002 Cabrio, that had a mis-behaving drivers window. After inspecting it, I found one of the cable roller guides was broken, causing the cable to snag when using the window open / close. I had a local garage order the regulator for me, and then I disassembled the drivers door and installed the new regulator (problem is now solved). Additionally, her passenger window stopped working, however, if you listened carefully, you could here a click sound when the button was pushed. I took this door apart as well, removing the regulator, I found it was jammed. Carefully, I removed the cover concealing where the cable rolls up, and was able to free the pressure. Once this was done, the window worked fine.

Oct 31, 2010 | 2001 Volkswagen Cabrio

1 Answer

Where is the fuse panel located on a 2002 cabrio volkswagon convertible car?


Hi, the f.use box is located under the driver side dash board, far left side. Panel drops down right above the hood latch.
Take care.

Jul 24, 2010 | 2002 Volkswagen Cabrio

1 Answer

Where is the cam sensor located?


it is under the timing cover at the front of the engine. under the cam belt pulley

Apr 02, 2010 | 2002 Kia Sedona

4 Answers

Location of crank sensor 1998 jetta 2.0


It's located near the cam gear on the front of the engine however, the crank sensor, to the right of the oil filter near the bell housing is the part notorious for going out on these cars, and causing a p0322 and/or p0341 code, and sometimes others as well To replace the crank sensor you have to: Support the motor with a floor jack. Remove the starter, 2 of the starter bolts connect to the motor mount. Remove the motor mount from the frame, very easy. Remove the oil filter. That will give you just enough room to get an allen wrench in to remove the bolt holding the sensor in.

Oct 25, 2009 | 1998 Volkswagen Jetta

1 Answer

Where does the cam sensor go on a 99 vw Cabrio?


Just off the top of my head; try facing motor from fan-end,on the right side of the block under the manifold set-up, a small flexible mirror should help you see it.

Jun 20, 2009 | 2002 Volkswagen Golf

1 Answer

Ineed to know the location of the cam sensor on a ford escape 2002 with the 3.0 liter V6 DOHC


SECTION 303-14: Electronic Engine Controls 2002 Escape Workshop Manual REMOVAL AND INSTALLATION Camshaft Position (CMP) Sensor —3.0L (4V) Removal and Installation
  1. Remove the camshaft position (CMP) sensor.
    1. Disconnect the electrical connector.
    1. Remove the bolt.
    1. Remove the sensor.
4544c22.gif
#56 is the cam sensor. please rate as fixed if this is what you need.

231ee68.gif

May 02, 2009 | Ford Escape Cars & Trucks

1 Answer

Where is the camshaft position sensor on 2001 VW Cabrio?


try autozone.com to see if they have your car listed for diagrams pictures and step by step instructions if your car is not listed then try your local library they have all the car manuals and even copy them for you

Mar 20, 2009 | 2001 Volkswagen Cabrio

Not finding what you are looking for?
1999 Volkswagen Cabrio Logo

Related Topics:

49 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

yadayada
yadayada

Level 3 Expert

76164 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...