Change to "LED"
I can not give you details, but your probably going to have to find the screws/panel fasteners and take the instrument cluster off. This may require removing the entire dash piece over the cluster.
Launch diagnostic
SOURCE: How to change my rear brake light bulb
Okay you need to lift your trunk remove any carpeting remove hidden screws to undo light fixture be careful not to drop the case once case is in your hand remove the appropriate bulb that needs replacing after wards reinstall light housing/casing and screws good luck with this. Please Rate Me. And for further assistance you can always ask me.
SOURCE: Need to replace instrument cluster/AC bulbs
Hello, You can obtain a 2004 Ram Factory Service Manual with all of that information available from Promanuals.net. The reason why it may be so important is because right before the removal instructions the service manual has diagnostic instructions to try. There are numerous pages on removing the instrument cluster, and cluster bezel.
(1) Disconnect and isolate the battery negative
cable. (For Airbag)
(2) Remove the cluster bezel from the instrument
panel. (Refer to 23 - BODY/INSTRUMENT PANEL/
CLUSTER BEZEL - REMOVAL).
(3) Remove the four screws that secure the instrument
cluster to the instrument panel structural support
(Fig. 5).
(4) Pull the instrument cluster rearward far
enough to access and disconnect the instrument
panel wire harness connectors for the cluster from
the connector receptacles on the back of the cluster
housing.
(5) Remove the instrument cluster from the instrument
panel.
SOURCE: instrument cluster bulb is out. how do i replace
It may not be a bulb, as the instrument cluster usually has a number of bulbs and they probably didn't all blow at once. Pulling instrument clusters can be touchy and may not be for the average "shadetree mechanic" however, typically there are a few screws above the cluster going into the dash pad and a few hidden behind the trim panels below the cluster.
216 views
Usually answered in minutes!
×