Question about 2010 Toyota Yaris

Open Question

Engine cuts out at random speeds but usually starts again without needing to turn key. Have had to turn engine back on with key couple of times. Latest incident car would not restart, doors would not lock. After driver door locked with key and unlocked, car started again. Inside light not activated by door opening bit switches on manually.

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1861 Answers

SOURCE: door locks

Regarding the rear door child locks: There is a small lever on the latch side of the door, you can only see it with the door open. Move it to the other position.

Regarding the front door locks: You either have a bad door lock switch, or the power lock solenoids are beginning to fail. To check this, you will need to pull the door panels off, & measure the actual voltage at the solenoids whilst manipulating the lock switch. If you have 12 + VDC, I would suggest replacing the door lock solenoids. Not hard to change, but it IS time consuming. Best left to a dealer. Expect to pay 1 hour per side to change each solenoid.

Posted on Sep 30, 2008

bluedevilray
  • 13 Answers

SOURCE: Power Door Locks

fuse problem?

Posted on Jan 19, 2009

  • 1 Answer

SOURCE: 2005 Toyota Sienna Sliding Door Won't Open

Have 2005 Sienna and its Driver side door was not openning. Cheap dealer fixed it himself in front of me. After opening the doors plastic assembly while sitting inside with a screw driver. Then he bent the clip towards left where the metal wire is connected. If you guys want to see what he did i would record a video and upload for you guys. Let me know at xahid2000@yahoo.com

Posted on Mar 13, 2009

jmgldsmth
  • 1869 Answers

SOURCE: 2004 Camry front driver door lock will only lock/unlock with key

Remove the door panel and reconnect the plug going to the front driver door lock or, if you can hear the motor trying to engage the door lock cam when you press the lock/unlock remotereconnect the door lock lever bar

Posted on Jun 09, 2009

  • 13 Answers

SOURCE: can not lock car by key remote . toyota rav 4 53 plate

If your car has an alarm with a separate remote, it is a separate system and it is probably self-arming. When you lock the doors with the key central lock, the alarm gets armed by the RAV4 being OFF and the door locking action. When you unlock the doors with the key, the alarm is still armed because the key is not comunicating with the alarm just the cars factory keyless system.

Posted on Apr 10, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Anti-thief system cut off power to den gine an won't cut it back on


If you are dealing with the anti theft the anti theft will flash as you are trying to start the vehicle if this is the case then it is the anti theft if not then you are not dealing with a ant theft issue. You can do a 30 minute relearn procedure without a scan tool. here is how Turn ignition on without the engine reunning.attempt to start the vehicle then release the key to ON.(vehicle doest start) Observe the security light.afeter 10 minutes the security light will turn off.Turn off the ignition and wait 5 seconds.do this 3 times for 30 minutes. start the engine with the engine started the vehicle will learn the passlock key.

Feb 24, 2012 | Cars & Trucks

1 Answer

Starts but takes a few seconds to start


Hey there jonablac,
well if it starts and then takes a minute to start up all the way from trying to die or cut out the you need to turn up you engines idle speed or if it starts then dies and won't start again wait a couple of minutes and then try to start it back up beacuase it could mean your engine has gotten a little flooded or you don't have you vehicle's engine idiling speed adjusted fast enough.

I hope this helps,

Shadowy Ace

Aug 20, 2010 | 1999 Chevrolet Silverado 1500

1 Answer

Engine cuts off while driving


Sounds like a bad MAIN relay, that controls fuel, It may also be a bad distributor, contact for more help. Thanks for using FIX Ya

Apr 03, 2010 | 1993 Honda Accord

1 Answer

Random misfire/rough idle/stall


Low fuel pressure due to faulty fuel pump will give misfire codes due to fuel starving conditions. Have fuel pressure tested, preferably when running bad.

Jun 20, 2009 | 1998 Plymouth Voyager

2 Answers

Engine cutting out randomly on motorway or at 30mph


We have had this problem on two of our voyagers and the culprit seems to be a blocked air filter that just needs replacing

Jun 09, 2009 | 2004 Chrysler Voyager

2 Answers

2002 Jeep Wrangler 4.0 When Driving the Engine Dies


Put the key in the ignition and turn it on and off (3) times without starting the jeep, leaving it in the on position count the (1) flashing indicator Light, Eg: (5) flashes, Then there will be a pause, then it may flash (3) times, this is a code #53. Keep your Eye on them and write them down. If you should miss (1) Repeat as many times as needed, Info: A #55 means there are no codes!!

May 30, 2009 | 2002 Jeep Wrangler

1 Answer

Mazda Tribute 2002 engine cuts out randomly


I had a Mazda 626 with a similar problem, the car seemed to 'shut down' with no warning, even at highway speeds, as if I just turned the ignition key to 'Off'; After trying to fix it unsuccessfully by replacing several electrical parts, the problem was found to be a defective ignition switch, it was replaced and the problem went away.

Apr 29, 2009 | 2005 Mazda Tribute

1 Answer

F350 super duty,engine cuts out without warning


Check to see if your truck was recalled for a faulty cam shaft sensor. Some sensors develop hair line cracks which allow contaminants to get in and the sensor becomes intermittent. The symptoms can include sudden shutdown of the engine so a recall was issued.

Jun 25, 2008 | 2000 Ford F350 Super Duty Super Cab

Not finding what you are looking for?
2010 Toyota Yaris Logo

Related Topics:

15 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8152 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...