Question about Infiniti Cars & Trucks

Open Question

Transmission valve body

I'M GETTING TWO CODES P1759 AND P1757

Posted by Anonymous on

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

garyq1970
  • 73 Answers

SOURCE: 2001 jeep grand cherokee transmission revving-codes p1757, p1762

P1757 1T CCM 1996-2003 Cherokee, Grand Cherokee A/T Governor Pressure Above 3 PSI In Gear At 0 MPH Conditions: Engine started; vehicle driven to a speed over 30 mph, and the PCM detected the Governor Pressure Sensor was more than 3 psi with the requested pressure at 0 psi (95% duty cycle command) for 2.65 seconds. The fault must occur twice on one trip to set the code. Possible Causes: Check for the presence of other A/T related trouble codes Governor pressure Sensor is damaged or has failed Governor pressure Sensor VREF (5v) circuit is open or shorted Transmission valve body is leaking, damaged or has failed PCM has failed P1762 1T CCM 1996-2003 Cherokee, Grand Cherokee A/T Governor Pressure Sensor Offset Volts Too High/Low Conditions: Key on or engine running. Gear selector in Park or Neutral. PCM detected an out-of-range Governor Pressure Sensor signal for 1.3 seconds. The fault must occur 3 times on one trip to set a code. Possible Causes: Governor pressure Sensor VREF (5v) circuit is open Governor pressure Sensor ground circuit is open P/N switch is damaged or has failed (not operating properly) Transmission fluid has excessive debris or it is contaminated PCM has failed

Posted on Nov 17, 2008

  • 1861 Answers

SOURCE: 2000 pontiac montana wont go into 4th gear

I would be interested in knowing if the thermostat is sticking open. Most Overdrives are prevented from engaging until the coolant temperature is over 177 degress F. Check you temp gauge...does it read Low? If so, change the t'stat, and see if that fixes your problem, or, if that does not help, get a complete transmission FLUSH, BEFORE you go out and get a rebuild. You just might save a ton of money.

Posted on Aug 29, 2009

  • 1252 Answers

SOURCE: Getting two Codes P1757 and

P1757--Governor pressure above 3 psi in gear with 0 mph
P1762--Governor pressure sensor offset volts too low or high

Posted on Jun 05, 2011

clifford224
  • 1975 Answers

SOURCE: where is the P1757 FRONT BRAKE SOLENOID VALVE

9b7b862b-b191-4739-b598-df678ca694cf.jpg9982a5eb-9cc4-4ad5-a4a7-2eb836e5da0f.jpg
Yes it has something to do with the transmission and the picture and legend of parts inside your transmission will help aid you in that valve's location. I would check the connector at the transmission (outside) for any moisture or debris that may have gotten inside that connector and cause a poor connection. Hope this helps...

Posted on Sep 02, 2013

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have 2005 nissan armada. I had my transmission rebuilt last now a year later I'm getting a p1759 code. What is that


P1759 NISSAN - Front Brake Solenoid Valve Function
Possible causes
Faulty Front Brake Solenoid Valve
Front Brake Solenoid Valve harness is open or shorted
Front Brake Solenoid Valve circuit poor electrical connection
www.autocodes.com/p1759_nissan.html
Service bulletin for a various Nissan Models with the RE5R05A transmission
www.autocodes.com/uploads/nissan/NTB10-003a.pdf

Mar 21, 2017 | 2005 Nissan Armada

1 Answer

How do i fix the p1757 trouble code on a


If you have never taken out a valve body and computer control system inside the transmission, I suggest you don't. Parts fall out. You could end up with a transmission that doesn't work.

Feb 13, 2016 | 2006 Nissan Xterra

1 Answer

I got error code P1759. not sure if I need to order a shift solenoid or what to fix the problem


There is a factory service bulletin for the 2003-2010 Infiniti vehicles with 5-Speed A/T for the P1759 code. The bulletin recommends replacing the Transmission Valve Body to fix the problem.

Read more: http://engine-codes.com/p1759_infiniti.html#ixzz3ZIMl6GG9

May 05, 2015 | 2006 Infiniti M35

2 Answers

I have a 2005 nissan pathfinder the code p1757 came up yesterday the check engine light is on and i have some oil or transmission fluid in my water


Well for Nissan vehicles the code means there is a problem with the ABS front brake solenoid valve. And that would not cause anything to leak into the radiator.
If the coolant is brown, its engine oil. If its pink, its transmission fluid.

Feb 10, 2013 | Cars & Trucks

1 Answer

Had new battery installed. Plugs wires tried to start turns over just cranks wont start. Checked codes they are p 1757 and p 0441.


image.php?u=60163&dateline=1264699148

o ,Ca75
icon1.gif RE: Transmission Codes P1757 & P1762 Remove the transmission pan and replace the governor pressure solenoid and transducer. There are 3 7/16 or 11mm bolt heads and 2 25mm torque bolts, then remove the bracket holding the sensors up to the valve body. also ajust the bands if needed at that time. __________________

Feb 27, 2011 | 2001 Dodge Ram 1500 Truck 2WD

1 Answer

Engine code 1759 on 2005 Nissan Pathfinder, I live in AZ and when it gets over 108 my car does not want to accelerate when I start from a stop. Today I had the transmission fluid checked and the fuel...


I also have a 2005 pathfinder. I just, today, got p1757 and p1759. I am having the same problem you described. I also noticed the tempature difference. I live miami, fl. I read something about front brake valve solenoid forcing the transmission into a safe mode so there is no pick up. What did you find if anything? Any solutions? Any advice?

Jul 02, 2010 | 2005 Nissan Pathfinder

1 Answer

2000 Dodge Durango - P1757 GOV Pressure Not Equal


I have had to replace the governor on those dodge transmissions, and there is a filtering metal mesh screen around the governor inlet port that seems to always get plugged up with small metal shavings. The governor is located under the transmission pan to the rear of the main valve body.

May 05, 2010 | 2001 Jeep Grand Cherokee

3 Answers

My 2005 Nissan Xterra will not engage the Reverse gear, neither will it shift to higher level gears no matter how you push the accelerator pedal. I took it to the repair shop and the scan it and the...


i have the same problem 2005 xterra 4x2 giving pretty much all the code you posted but i did and tried everything possible to fix it myself with a little success but still ( Engine Light ) comes on with the last code P1757 front breake soleniod i did change the front passenger sensor but now the light came on again i believe the driver side need to replace as well ..... but weird the whining noise from the engine still there sound like i am going 120mph but actually im going 30mph only initiall problem was fixed by replacing the Transmission Oil 5 qrt S type from nissan dealer it did help for at least few months but then the problem came back... i also replace the Transmission Revolution speed sensor by doing that id just eliminate the code to pop up... i love my xterra but im getting really fraustrated everytime i see her in my garage colleccting dust not running.. dont want to spent a fortune rather thingking about trading it anyway like id said you might thingking replacing the Transmission oil that would maybe solve the issue.... GOOD LUCK....

Apr 19, 2010 | 2005 Nissan Xterra

1 Answer

2001 jeep grand cherokee transmission revving-codes p1757, p1762


P1757 1T CCM 1996-2003 Cherokee, Grand Cherokee A/T Governor Pressure Above 3 PSI In Gear At 0 MPH Conditions: Engine started; vehicle driven to a speed over 30 mph, and the PCM detected the Governor Pressure Sensor was more than 3 psi with the requested pressure at 0 psi (95% duty cycle command) for 2.65 seconds. The fault must occur twice on one trip to set the code. Possible Causes: Check for the presence of other A/T related trouble codes Governor pressure Sensor is damaged or has failed Governor pressure Sensor VREF (5v) circuit is open or shorted Transmission valve body is leaking, damaged or has failed PCM has failed P1762 1T CCM 1996-2003 Cherokee, Grand Cherokee A/T Governor Pressure Sensor Offset Volts Too High/Low Conditions: Key on or engine running. Gear selector in Park or Neutral. PCM detected an out-of-range Governor Pressure Sensor signal for 1.3 seconds. The fault must occur 3 times on one trip to set a code. Possible Causes: Governor pressure Sensor VREF (5v) circuit is open Governor pressure Sensor ground circuit is open P/N switch is damaged or has failed (not operating properly) Transmission fluid has excessive debris or it is contaminated PCM has failed

Nov 17, 2008 | 2001 Jeep Grand Cherokee

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

63 people viewed this question

Ask a Question

Usually answered in minutes!

Top Infiniti Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14333 Answers

Are you an Infiniti Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...