Question about 1999 BMW 323 Series

1 Answer

Hi i locked my bmw 323i with key pad now it wont

Hi i locked my bmw 323i with key pad now it wont unlock with key pad if i do it with the key the alarm keeps going off what do i do ?

Posted by on

Ad

1 Answer

The BMW is complicated since i had a similar problem with mine. the keypad is connected partly to the ECM and the TDS. the connector to the keypad partially gets corroded over time and wont send the correct signal to disable the alarm. Check the connection first. if it is fine. disconnect the power to the battery for 5 minutes to let the TDS reset and try again. if it fails then chances are the key pad is faulty

Posted on Apr 23, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Unlock drivers side door when key won't work


All BNW's have remote key openers built into key, so what doesn't work, the manual lock, or the remote key, or both. When you say you don't have keyless entry, on a BMW the remote is the key.
CeraCoat-NanoTech.com

Jan 28, 2015 | 2000 BMW 323i

1 Answer

I can't get gas to go in my bmw 323i convertible, help? The gas cap is very hard to get off now and the pump won't suction on when I try to put gas in.


1. Unlock the gas cap. Slip the key into the slot on the center of the cap with the teeth toward the outer circle. 2. Turn the key clockwise. The lock cylinder gives and allows the key to move. 3. Turn the gas cap counterclockwise. Unscrew the cap...------------------------------------------------------------------------------
Best R270 BMW CAS4 BDM Programmer

Feb 26, 2013 | 1998 BMW 3 Series

1 Answer

I changed the key batteries for my 1999 BMW 323i after they died. Afterwards the remote unlock and lock won't work, the car also won't start but it can turn over/on and the radio and the lights...


stick the key in the ignition, turn it to the on position, remove it within 5 seconds, then hold the unlock button down and press the lock button 3 times within 10 seconds and release both buttons. The doors should lock/unlock to give you confirmation and your key should work.

Jul 05, 2011 | 1999 BMW 323 Series

1 Answer

My 323i was stored for 2 years. I am now getting it road ready and the passenger front, and both back doors wil not unlock. can you help?


Hi, try this as it may or may not apply to your model.Get in, open and close the drivers door, put key in ignition turn 2 clicks and take back out again, within 5 seconds, hold the 'lock' button in the middle of the key and press the 'unlock' button 3 times, then let go. Quickly repeat the lock and unlock button sequence on the spare key. All doors should lock and then unlock when it has worked.


Jan 24, 2011 | 1999 BMW 323 Series

1 Answer

2000 BMW 323I WONT UNLOCK WITH THE KEY OR KEY FOB, ANY IDEAS?


I had same problem. Driver door would lock/unlock with key in keyhole in door, but not with fob, and other doors would not lock/unlock. Even once inside none of the doors would lock/unlock with lock switch, or even by pulling handles. Mechanic (very trustworthy) explained I needed a new control module (cost me $600). Good Luck. $600 is better than having to roll down the windows so Grandma can Luke Duke it outta the car.

Feb 19, 2010 | 1999 BMW 323 Series

2 Answers

2006 BMW 323i Passnger Door lock will not lock / unlock w/ remote


Replace fuse 57 (15 amp) then disconnect battery and wait 30 to 45 minutes before reconnecting the battery.

My 2006 BMW 325I had the same problem with the door locks not responding. I checked all related fuses and found #57 (15 amp) was the only related fuse blown. I put in a new fuse and it still would not work. I then disconnected the battery for a while then once I reconnected the battery everything worked fine.

I believe I blew the fuse while repeatedly pushing the unlock button rapidly while walking across the parking lock to the car. I suggest only pushing the unlock button only once or twice.

Jul 28, 2009 | 2000 BMW 3 Series

3 Answers

2000 bmw 323i auto trans wont go in reverse. i just had the front and rear brake pads and rotors changed. the ABS light is on as well even after the change.


ive heard people say that on a auto transmission on a BMW that if it wont go into reverse there might be something wrong with the transmission... just a thought, i might be wrong

Jul 09, 2009 | 1999 BMW 323 Series

2 Answers

1999 bmw 323i dashboard reads S and car wont turn over


If this is an automatic then the gearbox sounds as though it has a fault, check fuses in glovebox i think theres two in there for the gearbox. if they are ok you need to have a diagnostic check im afraiid

Mar 23, 2009 | 1999 BMW 323 Series

1 Answer

Central Locking System Malfunction (i suppose)


check the door lock switchs first to make sure their is power going to it then check the lock actuators sounds like the door actuators though that need to be replaced.

Mar 07, 2009 | 1999 BMW 323 Series

Not finding what you are looking for?
1999 BMW 323 Series Logo

572 people viewed this question

Ask a Question

Usually answered in minutes!

Top BMW Experts

Frankie B

Level 2 Expert

65 Answers

Fred Sops

Level 2 Expert

272 Answers

Doberman

Level 2 Expert

254 Answers

Are you a BMW Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...