Question about Cars & Trucks

Open Question

Replacement of oil pan on 2007 dodge charger 3.5

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

ams51pr
  • 21 Answers

SOURCE: replacing oil pan on 2003 dodge neon

To replace the oil pan jack and place car in towers. Remove the undercover shielding and watch out for the exhaust that will also have to be move. Drain the oil pan. The holding bolts will be removed with appropriated tools. Tap with wood block to lose it. Once removed check the oil pump for damage. To replace make sure to used a proper gasket and sealant. Install all parts back.

Posted on Jul 05, 2008

emissionwiz
  • 75066 Answers

SOURCE: Hole in oil pan, can i replace it myself?

yes u can, but it is one heck of a job with a lift, u will need a good floor jack and safety stands and a really good assortment of hand tools both metric and standard.

Posted on Apr 27, 2009

Keith100881
  • 74 Answers

SOURCE: oil pan rusted out, needs replacing

which eng. 3.9 5.2 5.9 v8 5.9l6

Posted on May 24, 2009

  • 226 Answers

SOURCE: 2007 dodge grand caravan . using alot of oil with

5000 is too long in between oil changes for that vehicle. Change it every 3000

Posted on Feb 24, 2010

jturcotte
  • 7754 Answers

SOURCE: I HAVE A 2007 2500 DODGE RAM WITH 5.9 CUMMINS AND

depends on whether you have 2WD or 4WD. The manual says if you have 2WD you have to remove the tranny,but not if you have 4WD. See procedures below.

5.9L & 6.7L Diesel Engines
2WD Models

  1. Before servicing the vehicle, refer to the Precautions Section.
  2. Open the hood.
  3. Remove the negative battery cables.
  4. Raise and support the vehicle.
  5. Remove the transmission oil cooler lines.
  6. Remove the propeller shaft.
  7. Remove the starter bolts.
  8. Support the starter.
  9. Remove the torque converter bolts.
  10. Remove the exhaust hanger bolts.
  11. Remove the gear shift cable.
  12. Remove the wiring harness.
  13. Remove the transmission mount.
  14. Remove the crossover bolts.
  15. Position the transmission jack.
  16. Remove the bell housing bolts.
  17. Remove the transmission.
  18. Remove the flywheel housing bolts (8).
  19. Remove the flex plate bolts (8).
  20. Remove the engine oil dip stick.
  21. Drain the oil.
  22. Remove the steering rack bolts.
  23. Remove the oil pan bolts.
  24. Remove the oil pickup bolts.
  25. Remove the oil pan.

4WD Models
  1. Before servicing the vehicle, refer to the Precautions Section.
  2. Open the hood.
  3. Disconnect the battery negative cables.
  4. Remove the intake air assembly.
  5. Remove the radiator shroud retaining bolts.
  6. Install engine support fixture No. 8534B.
  7. Raise and support the vehicle.
  8. Drain the engine oil.
  9. Loosen the front engine mount bolts.
  10. Lower the vehicle.
  11. Use the engine support fixture No. 8534B to raise engine out of the front mounts.
  12. Remove the engine oil dipstick.
  13. Raise and support the vehicle.
  14. Remove oil pan bolts, break the pan to block seal, and lower pan slightly and remove oil suction tube fasteners.
  15. Remove oil pan and suction tube.
  16. Remove the 2 bolts from the front of the engine block stiffener.
  17. Remove the oil pan.

Posted on Oct 30, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Transmission oil pan replacement


Measure all the fluid you drain and replace it with the same amount plus 1/4 quart.

Jul 05, 2016 | 2007 Dodge Nitro

1 Answer

How do I remove oil pan from a Dodge ram 2010


How to change oil pan on dodge ram 2000 - YouTube

? 2:42
www.youtube.com/watch?v=J1njjsDFjVk
Apr 9, 2015 - Uploaded by Carlos Juarez
How to change oil pan on dodge ram 2000 ... How to Replace Remove Headlights on Dodge Ram 2009 2010 2011 2012 hid - Duration: 3:40.

Oct 07, 2015 | Dodge Cars & Trucks

1 Answer

How to remove a oil pan from a 2008 dodge charger v6 2.7l


jack it up,drain all the oil.take all the bolts off,scrape all the gasket off without damaging the metal,put new gasket and pan on put all bolts back,

Jun 16, 2015 | 2008 Dodge Charger

1 Answer

How to replace oil pump un an a 2007 dodge durango 5.7 hemi motor


the oil pump is located inside the oil pan. removing the motor will be needed to do the job unless you got a new way to open the oil pan with everything in the way. if you have really low or no oil pressure. or after driving for a few miles the pressure drops a lot. the bearings could also be gone and that is going to need to be address with the motor out. other option is get a junkyard motor and replace it. but you never know what could be wrong with that motor. try to hear the engine run if possible

Feb 12, 2015 | 2007 Dodge Durango

1 Answer

Cost to replace oil pan in 2006 dodge charger sxt?


YES if you look around you'll find a drain plug repair kit ,its a common problem but there's hope ,a universal fit repair kit ,and with a little knowhow most can do it in about an hour after you fully drain oil ,my question is why the people who did the damage are not paying for all the repairs ? if that's not an option then go with repair kit. hope this helped you ,good luck.
Woody

Aug 28, 2014 | 2006 Dodge Charger

1 Answer

How much to change the oil pan on 2006 dodge charger sxt


You can purchase universal drain plugs at about any parts store that are designed to repair stripped out pans. They have a bar with a nut that fits into your drain hole and a plug seal that fit around the drain hole. This is the cheapest way to permanantly fix your problem.

Aug 27, 2014 | 2006 Dodge Charger

1 Answer

2008 dodge charger oil plug


please clarify;need to know where plug is? at bottom of oil pan. stripped plug? need a replacement plug? try auto parts store in help aisle. can't be to much help unless you're more specific.

Nov 11, 2010 | 2008 Dodge Charger

1 Answer

2007 dodge charger 3.5 v6 is overheating and has no heat


i have a awd 300 same problem 3 yrs in a row... 1st 2 times the replaced the themostat and flushed radiator... 3rd time the had to replace the oil cooler and completely flush the whole system again. tech at dealer told me it is a bad design flaw.... chrylser does not seem to be in a big rush to fix it.... trading for anything other than chrylser product ASAP !!

Nov 07, 2010 | 2007 Dodge Charger Daytona R/T Sedan

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

80 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...