Question about Cars & Trucks

Open Question

P0601 on Pontiac Montana Shuts down. If you turn

P0601 on Pontiac Montana Shuts down. If you turn key to start nothing happens And three to five minutes it starts

Posted by Anonymous on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 315 Answers

SOURCE: Noise when turning the key to start my 2005 Pontiac Montana

might be the fuel pump. should sound like an electric motor running, whirring sound. like a very quiet dough mixer.

Posted on Mar 05, 2009

  • 14036 Answers

SOURCE: car shuts down

if you have a maintance free battery check the eye in it if green its okay.if dark or black .battery no good that cause car to quit.if battery good you got a ignition component problem.

Posted on May 30, 2009

  • 490 Answers

SOURCE: can i start montana without key

you can but I dont recomend it,the vehicle is too new and your steering wont work is you did get it started.Find a lock smith or take the number inside your glove box to the dealer and they can make you a new key,or use the VIN #

Posted on Jul 23, 2009

  • 432 Answers

SOURCE: turn the key and nothing happens

It could be the switch that the key goes into is wearing out.I hope this helps you.

Posted on Sep 04, 2009

  • 10319 Answers

SOURCE: 2003 pontiac montana key wont turn first time this

the tumblers in the ignition cylinder is jambed.
replace the lock cylinder to fix this problem

Posted on Feb 07, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How do you reset the change oil light on a 2002 pontiac montana

On most GM models, you turn the key on but don't start the engine.
Depress the gas pedal to the floor quickly three times.
The light should flash a few times then go away.

Dec 09, 2012 | 2002 Pontiac Montana

1 Answer

I have a 2006 pontiac montana and a starting disabled light comes on and the vehicle shuts of when its running , and sometimes it doesnt start on the first try

Most likely the PassKey circuit is going bad. Something to try is to connect a 10 amp battery charger to vehicle and leaving the key in the on position for 10 minutes. at the end of that, turn key off. You are supposed to do this procedure 3 time to relearn the security system. At the end, turn key off, then try to start it. Sometimes it works. Its worth a try. Otherwise you will have to replace it.

Sep 27, 2010 | 2006 Pontiac Montana

1 Answer

Oil change light is on how can i turn it off

  1. Turn the ignition key to ON (with engine OFF).
  2. Push the accelerator pedal fully to the floor and release three times within five seconds.
    • The CHANGE ENGINE OIL light should flash.
  1. Turn the ignition OFF, then start the vehicle.
    • If the CHANGE ENGINE OIL message comes back on, the monitor has not reset. Repeat the procedure.

Apr 05, 2010 | 2000 Pontiac Montana

1 Answer

Change oil message stays on even after repeatedly cancelling

Pontiac Aztek, Montana 2001-05 w/o (DIC) Driver Information Center; Torrent, Ascender 2006

Turn the ignition to ON, with the engine off. Fully depress and release the accelerator pedal slowly three times within five seconds. Turn the key to OFF If the CHANGE ENGINE OIL’ message comes back on when you start your vehicle, the engine oil life system has not reset. Repeat the procedure.

Pontiac Aztek, Montana 2001-06 wI (DIC) Driver Information Center

urn the ignition to ON, with the engine off. Press the MODE button until the DIC reads ‘OIL LIFE LEFT/HOLD SET TO RESET Press and hold the SET button until 100% is displayed. You will hear three chimes and the “CHANGE ENGINE OIL” message will go off. Turn the key to OFF. If the “CHANGE ENGINE OIL” message comes back on when you start your vehicle, the engine oil life system has not reset. Repeat the procedure.

Good luck

Nov 10, 2009 | 2001 Pontiac Aztek

2 Answers

How to reset the change oil light in a 2001 pontiac montana with a digital message center?

turn the key on to the power position but do not start the vehicle, then press the accelerator pedal to the floor three times within a ten second period.
Good luck dont forget to rate

Apr 01, 2009 | 2001 Pontiac Montana

2 Answers

Noise when turning the key to start my 2005 Pontiac Montana

the only thing that i can think of is the auto door locks engaging

Mar 05, 2009 | 2005 Pontiac Montana

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

45 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

80637 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

john h

Level 3 Expert

15427 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides