Question about 2007 Hyundai Sonata Limited Sedan

1 Answer

2007 Hyundai Sonata started clicking only when warmed up. The noise started immediately after changing alternator. It did not do this before. The noise is constant and rhythmic when the engine is warm. It increases with increased RPM and decreases in the same manner. Possibly a bearing?

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that got 5 achievements.

    New Friend:

    An expert that has 1 follower.

    Greenhorn:

    A rookie expert who has answered 20 questions on their first day.

  • Contributor
  • 29 Answers

Depending on where you got the alt it could be defective, I've gotten them and they haven't event charged. i'd take it back and have them listen to it so they know that its a bad part.

Posted on Oct 10, 2013

  • Steve John
    Steve John Oct 13, 2013

    Thanks for your comment, Ed. We wondered if it could possibly be the alternator. The car is running fine and the new alternator is keeping the battery charged. We bought it online (saved $100) in doing so. This is the downside of buying online. :(

×

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 393 Answers

SOURCE: replacing rear wheel bearings on 1999 hyundai sonata

  1. for drum brakes with sealed hub(all one piece) remove lug nuts and wheel.
  2. spray penetrating oil around studs if there is a big phillips head screw visible remove it with impact driver/if not use big ballpeen hammer ,tap on flat of drum near studs(becareful not to hit them) until drum loosens(your creating a shockwave to loosen rust)
  3. once drum is off there are 4-bolts coming in from behind backing plate, remove them then hub should be able to be removed w/a little persuation from hammer.
with out sealed hub ,
  1. remove wheel
  2. remove dust cap,cotterpin,star washer(if equipped) do not re use cotter pin
  3. remove nut then washer, wiggle brake drum and front bearing will come out.
  4. put nut on shaft tighten 2-3 turns grab drum by sides and pull towards you this should remove drum leaving inner bearing/seal on shaft
  5. to replace reverse procedure making sure to pack new bearings w/grease(take drum and use long punch to remove bearing races, use race/seal installer to install new races
with disk brakes

  1. remove wheel
  2. remove caliper/bracket
  3. remove rotor
  4. remove 4-bolts from behind,tap old hub out
  5. reverse procedure



Posted on Nov 15, 2008

  • 22 Answers

SOURCE: accelerated clicking/knocking noise when i start driving

sounds like your CV joints are worn out. If the clicking noise gets worse when turning then its a definite possibility. Also check the CV joint boots for splits as this can quickly wear them out. The dust mixes with the grease to form a grinding paste.

Posted on Jun 10, 2009

ghost4548
  • 776 Answers

SOURCE: key is stuck in ignition in 2007 hyundai sonata

The problem is in the tumbler(s) inside the assembly. Before you do anything, try penetrating oil to see if that works... otherwise, the entire assembly will need to be replaced.

Posted on Jun 28, 2009

ghost4548
  • 776 Answers

SOURCE: "Humming" or "bearing" type noise in left front at highway speeds

That's a hub bearing. Replace the one that's doing it. I'm assuming this 'roar' is coming from the front, NOT the rear.

Posted on Jun 28, 2009

ghost45
  • 1280 Answers

SOURCE: Locating and changing spark plugs on 2007 Hyundai Sonata 4 cylinder

They are directly below the coil packs (10mm bolts).


a73d0bb.jpg

Posted on Oct 25, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

WHERE IS THE FUEL CUTOFF SWITCH ON THE 2007 HYUNDAI SONATA


No cutoff switch on Hyundai cars. Only Ford products.
The fuel pump and injectors get power from the engine control relay.

Feb 19, 2013 | 2007 Hyundai Sonata Limited Sedan

1 Answer

2007 Hyundai Sonata automatic transmission fluid changing


if its due do it,if the manual booklet recomended,do it pls

Jun 03, 2009 | 2007 Hyundai Sonata Limited Sedan

Not finding what you are looking for?
2007 Hyundai Sonata Limited Sedan Logo

120 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

80608 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8841 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...