Question about Chevrolet Tahoe

Open Question

P0572 chevy tahoe brake switch circuit low - Tahoe Chevrolet Cars & Trucks

Posted by Anonymous on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: chevy tahoe 1999 all 3 brake light wont work good

The Hazard warning switch is bad.

Posted on Jul 12, 2009

  • 1596 Answers

SOURCE: how do you change brake light on a 99 chevy tahoe

I Do Believe that the Light Assembly Comes OUT Via TORX Screws and The Lights are On a Curciut Panel that is then Removed to Gain Access to Bulbe

Posted on Aug 05, 2009

  • 121 Answers

SOURCE: 4 wheel drive selector switch lights go off and

new doesn't mean good, scan the computer for codes and use that code trouble tree.may have wires chewed into and touching from rodents check wires very closely on top of trans. not normal for the dash switch to short out either. may need to replace the contol module and reprogram hope this helps.

Posted on Dec 06, 2009

  • 880 Answers

SOURCE: how to install the brake light switch for 2003

Look under the dash on the drivers side. The switch will directly above the brake pedal. You should see the switch with an electrical connection you can unplug and the nut to take off to remove the switch. Before you put the new switch in notice where the adjustment is on the old switch and put the new one in about the same position. Once installed you will most likely have to make a small adjustment on the adjustment nut and thus the hold down nut. A small adjustment makes a lot of difference. Adjust the new switch so that when the brake pedal is depressed about 1/4 inch the brake light are activated.

Posted on Jan 11, 2010

  • 6826 Answers

SOURCE: fix brake switch on a

Stop Lamp Switch Removal & Installation To Remove:

  1. Disconnect battery negative cable.
  2. Disarm the air bag system. gm-06-00-1035.gif

  3. Using snap ring pliers, remove pushrod retainer from brake pedal pin.
  4. Remove stop lamp switch from pushrod.
  5. Disconnect stop lamp switch electrical connector.
To Install:
  1. Connect stop lamp switch electrical connector.
  2. Snap stop lamp switch onto pushrod.
  3. Using an 11 mm socket, push pushrod retainer clip onto brake pedal pin.
  4. Connect battery negative cable.
  5. Arm the air bag system.

Posted on Aug 04, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

How to fix code P0719 on my 2003 GMC Sierra p/u

code p 0719 refers to torque converter/brake switch B---circuit low====causes --wiring short to ground --torque converter /brake switch---ECM/TCM

Aug 14, 2016 | GMC Sierra 1500 Cars & Trucks

1 Answer

P0572 Brake Switch A circuit low error code.

code p 0572 refers to cruise/brake switch A --circuit high===causes---wiring short to positive ---cruise / brake switch---ECM
replace the brake switch first as it gets the most work , then the cruise control switch also on the brake

Nov 29, 2015 | 2010 Jeep Grand Cherokee Laredo

1 Answer

Lower brake lights no longer work on my 2002 chevy tahoe but the 3rd brake light works fine. Checked fuse and bulbs and everything works fine. Just the 2 lower brake lights dont work.

Most of the time the problem is in the turn signal switch. The third brake light circuit bypasses the turn signals.
Someone would need to check brake light power in and out of the turn signal switch.

Feb 25, 2014 | GMC Cars & Trucks

1 Answer

Low beam don't work on my 1995 chevy tahoe

Do you have power in and out of the dimmer switch on the low beam circuit ?

Aug 30, 2013 | 1995 Chevrolet Tahoe

1 Answer

What does P0572 mean on a 2009 Dodge Charger

According to my code book it is a Brake Switch A Circuit Low input. Sorry that's all i have

Nov 14, 2012 | 2009 Dodge Charger

2 Answers

Wiring diagram for 1999 chevy tahoe

I have gone to two mechanices and no one can fix the brake lights on my 1999 chevy tahoe and i dont know what to do i need help because i have been stoped by the police and its not good HELP ME PLEASE!!!!!!!!!!!!!!

Jan 20, 2012 | Cars & Trucks

1 Answer

I need to know what trouble code p0572 is for a 2004 dodge stratus 4 cyl. ?

P0572 Cruise Control/Brake Switch A Circuit Low. here is a cause/solution for your problem even though it is for a Chrysler it is the same code and fix. Good Luck Tim

Apr 30, 2011 | 2004 Dodge Stratus

1 Answer

Trouble code po572 on dodge dakota slt, 3.7 ltr

P0572 - Cruise Control/Brake Switch A Circuit Low

Switch number 1 on the cruise brakes has low voltage on the circuit. Or how about low voltage on your brake line switches or something? Check to see if inadvertantly the connection to the actual pressure switch (one for front & the one for the rear) may have pulled loose at the switch. These are located in the Hydrolic fluid line... Trace from calipers back. (Two wire connection).

Tell us news.

Aug 02, 2010 | Dodge Pickup Cars & Trucks

1 Answer

Chrysler code P0572 need help

Trouble Code: P0572

Brake Switch Signal No. 1 Circuit Low

Trouble Code Conditions:Ignition is on. When PCM recognizes that brake switch is mechanically stuck in the low/on position, a DTC will set. Three global good trips are necessary to turn off MIL.

Possible Causes:

* Brake switch signal circuit is shorted to ground
* BS No. 2 signal open
* Brake switch is damaged or has failed
* PCM has failed

i would check the brake switch first located under dash and when brake is pushed it hits switch turn ignition on and test the wires if all hot then switch is bad, other wise there is a short or bad pcm and these are not easy fixes requires knowledge of car wiring and diagnostic tools/computer

Jul 09, 2009 | 2004 Chrysler PT Cruiser

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

333 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

80608 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides