Question about 2005 MG ZR

2 Answers

Knocking noise when turning right at low speed

Posted by on


2 Answers

  • Level 1:

    An expert who has achieved level 1.


    An expert that has over 10 points.

  • Contributor
  • 2 Answers

If memory is correct the car is front wheel drive? If so problem is likely a worn constant velocity joint (CV) on the right hand side. Better to get a garage to check before buying one as they are a bit expensive to replace.

Posted on Dec 31, 2013

  • _-__-___-_
    _-__-___-_ Dec 31, 2013

    better yet, have it DIAGNOSED, gue$$ing is very expensive. noise is a hands on job, the finding, not something net bunnys can hear, or even say what end of car its on.... .could even be brakes, or wheel bearings, or suspension damage, (stop) lots more,, but is all just like tears in the rain, get it diagnosed.


  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • MG Master
  • 20,706 Answers

Cv joint or brake pads or wheel bearing or loose lug nuts/
this is a hands on deal, why ask net bunnies to guess?
we can drive it , test it or hear it.

Posted on Oct 10, 2013


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

What would cause a knocking noise under car during movement?

am I reading this right it doesn't do it over bumps,steering

or braking but when you are driving, could you give more info like does it only happen when driving or turning corners, high or low speeds or both thanks in advance

Jul 27, 2014 | 1999 Peugeot 406

1 Answer

Knocking Noise from Front End Toyota Corolla 2004

Ensure the wheel nuts and Axle nuts are properly torqued to the specification. Lift up the front wheels, place supports under the car and do the following:
- Sit if front of right wheel, slightly move it right and left and feel any abnormal noise if coming out of it. If click-click or Tuck-Tuck sound is observed it could be due to the excessive play in the tie rod end, rack end, ball joint wheel bearing or U joint. Next hold the Tire with your one hand at the top and with other hand at the bottom. Shake the Tire inside out and feel any noise or play. If play is observed, it could be the worn out ball joint or the wheel bearing. Now hit the Tire at the top with rubber hammer and observe any rattling noise coming from near the center of the wheel. If you could listen to the extra noise it could be due to the dried up caliper pins. Grease the pins with graphite grease. If all is found fine, similarly check the left wheel and repair as necessary.

Sep 15, 2013 | Toyota Corolla Cars & Trucks

1 Answer

Motor started knocking this morning noise is loud while driving when I speed up the knocking speeds up and the same when I slow down and the knocking noise sumtimes stop when I bring tahoe to complete...

I would guess that you have a failed big end bearing. The slipper turning in the conrod cap will give a knock and at the sametime block of the oil hole which allows you to keep up the oil pressure. Drain the oil and check for shiny specks or bits of metal in the oil. If you have a magnetic sump plug check for fragments on the magnet

Jan 26, 2013 | Cars & Trucks

1 Answer

Knocking knoise under 1500 rpm

If your car has hydraulic tappets and low low oil pressure at engine speeds then it can make tapping noises. Oil pressure is needed to maintaine the tappets clearances, excessive cleaeances will produce noises.

Jan 30, 2012 | 2000 Pontiac Sunfire

1 Answer

Knocking, juddering noise in the steering

You may have to look at your tie rods. Those are the next parts to look at.

Jul 04, 2010 | 2003 Jeep Grand Cherokee

1 Answer

Noise from steering column

if p/steering fluid is low pump will make a droning noise. top up fluid and check for leaks, usually seepage from pipes at reservoir.

Apr 23, 2010 | 1997 Audi A4

1 Answer

1990 honda has a knock in the front when you turn right at low speeds.

It could be a worn cv joint. They usually knock while turning, then get progressively worse.

Sep 12, 2009 | 1990 Honda Prelude

Not finding what you are looking for?
2005 MG ZR Logo

69 people viewed this question

Ask a Question

Usually answered in minutes!

Top MG Experts


Level 3 Expert

78919 Answers

Bryan Mcphee
Bryan Mcphee

Level 1 Expert

23 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

4818 Answers

Are you a MG Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides