Question about Cars & Trucks

Open Question

I have a2012 px ranger and wish to fit a egr blanking plate.Do I need one with the one and will it set off any fault lights etc .thanks

Posted by Anonymous on

Ad

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
tneubauer
  • 437 Answers

SOURCE: torque spec on 1987 ranger flywheel and cluth plate

15-24 ftlbs.

Source: Mitchell1

Posted on Jan 15, 2010

Ad
  • 44379 Answers

SOURCE: New Egr valve fitted to my fiesta 56 plate

use a scanner to reset the ECM

Posted on Aug 03, 2014

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1997 ford ranger run rough at idle why


Could be a few different thing's . vacuum leak , spark plugs , EGR valve leaking , dirty throttle plate , dirty mass air flow sensor. Idle air control problem . dirty fuel injectors ! How's it run other wise ? are there any lights lit on the dash , check engine , service engine soon etc....

May 04, 2015 | Ford Ranger Cars & Trucks

1 Answer

What resistors do I need to fit LED tail lights to a 2012 PX Ford ranger ute


fast blinking light tells you that one of the bulbs is bad. replace the bad one and it should be fixed not need for resisters EVER

Jan 05, 2015 | Ford Cars & Trucks

1 Answer

My 2004 Sebring 2.4L does not have an egr valve. The engine light is on light is on with and error of p0400 . So what now?


With the code coming up for an EGR valve I would consider it unlikely that it left the factory without one as it would have had the code from day one and it would have been fixed at a service under warranty.. If you got the car second hand then it is possible that the EGR valve failed and the previous owner found it easier to blank it off to sell it . I would consider fitting a new valve and getting it working properly as it is critical to passing the road worthy certificate., performance and economy.

May 03, 2014 | 2004 Chrysler Sebring Sedan

2 Answers

Ford Ranger check engine light. I had it diagnosed as an EGR Valve, replaced it and the light cam back on after about 5 miles.


They all say the EGR valve is the problem but most of the time its the mass air fow meter is at fault.So i would recomend changing that.

Dec 29, 2009 | 2000 Ford Ranger SuperCab

3 Answers

Blowing blue smoke turbo works now and then on an


Sounds like you need a new turbo, the turbo is lubed by engine oil and shaft seals leaking into the intake.

Oct 24, 2009 | 1989 Ford Escort

2 Answers

Ford Ranger 2.5 on a53 plate. EML comes on


my ford ranger run rought when i rare it up it blows some black smoke

Oct 12, 2009 | 2003 Ford Ranger Regular Cab

2 Answers

Sometimes car drives eally well plenty boost other


Hi,you need to get the codes read first this will probably show an intermittent problem with the accelerator pedal position switch,if not check for air and vacumn leaks to all the actuators ,the fuel pumps are know for internal failure if you use bad fuel,

Aug 11, 2009 | 2001 Ford Focus

1 Answer

1990 ranger 2.3L runs rough.at idle and when cruising. good acceleration. changed out the obvious, plugs, cap, filters etc. no luck. runs fine for awhile with egr sensor disconnected than reconnected, but...


There will be an egr control solenoid that allows vacuum to reach the egr solenoid, sometimes it will be called the egr vent solenoid. It is probably bad.

Mar 07, 2009 | 1990 Ford Ranger SuperCab

1 Answer

Jaguar x-type power loss


blank it off with a piece of ally

Jan 06, 2009 | 2003 Jaguar X-Type

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

349 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...