Question about 2000 Volkswagen Passat 4Motion

1 Answer

Removing 2000 VW passat door panels for speaker install.

Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 115 Answers

The door panel comes off With a T-10 torx or a Hex (Allen) wrench
that will fit and A large Philips Screw Driver..

Remove the Plastic cover on the inside Door handle.
And the Screw or Screw along the Bottom of the door panel.
Then remove the screws that hold the handle the the door.
They are located behind the Plastic plate you removed with a tiny screw driver earlier... Be careful not the mark up the cover whaytprying it up. It is best to pry from underneath. Where marks if made can not be seen

After the screws are out 4 I believe. The Use of a CLip tool ir best.
For getting behind the panel to pop it off. A screw driver will work.

After all the clips are released. Pull the light at the bottom of the panel down and out. Disconnect it ur push it back thought the hole it came from..



reverse to install

SKETCHLAB.com

Posted on May 16, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1997 vw passat passenger door does'nt lock


there is a plastic clip that hold a rod in place that is attached to the lock might be damage look behind door panel at the lock itself.
or might be a bad actuator.

Dec 06, 2012 | 1997 Volkswagen Passat

1 Answer

Car door will not open. vw 1.8 1999 passat


remove door panel and check actuator for power and that actuator rod is connected and the plastic clip did not break or pop off

Nov 01, 2009 | 1999 Volkswagen Passat

1 Answer

VW Passat 1.6l 2000 (UK) Electrical failure


fuses are usually in the glove box or under the drivers dash or under the drivers side hood either physically inspect every fuse by pulling them one by one or the aid of a test light and a good ground to the test light

Sep 09, 2009 | 2000 Volkswagen Passat 4Motion

2 Answers

VW Passat 1.6l 2000 (UK) Sudden failure of


check under seat, there are 3 sets of wires, they could be coroded, these wires run all the windows door, any thing that is for useing the power, i know just had it fixed 245, 00 later,,

Sep 09, 2009 | 1999 Volkswagen Passat

1 Answer

I want to install remote central locking 00 VW Passat


The motor is part of the lock in drivers side door
John

Sep 07, 2009 | 2000 Volkswagen Passat 4Motion

1 Answer

VW Passat sport 2000. Wipers have stopped is it a fuse and where would i find it please.Washer is ok


Posted as a 2000 VW Beetle, but the fuse panel should be located on the side of the dash just inside the driver's door. There should also be a fiuse diagram on the fuse door panel, as well as in the back of the Owner's Manual.

Jun 28, 2009 | 2000 Volkswagen Beetle

2 Answers

Speakers


This is a partial solution to let you know that the door panels for both the front and rear speakers have to be removed,, See repair manual for removing the door panels

Dec 15, 2008 | 1999 Volkswagen Passat

2 Answers

Front speaker installation for VW Passat


If you've not taken speakers out before they are easy to do, you have to pull the door trim off, first look if there are any screws and take them out then carefully pull the trim away from the door and using a torch you will see plastic holding clips you have to pull the trim off at that point, some will break but they are a few cent only and can be got from the VW dealer readily, take your time and you "might" not break any of them, I find a plastic 12" ruler to be handy along with a flat bladed screwdriver, first cover all the blade of the screwdriver with masking tape to stop any damage if you slip.
very simple job to do just take your time and dont rush the clips have a tough hold on the doors also.

Nov 28, 2008 | 2001 Volkswagen Passat

Not finding what you are looking for?
2000 Volkswagen Passat 4Motion Logo

2,322 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

yadayada
yadayada

Level 3 Expert

75822 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8202 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...