Question about 2006 Chevrolet Uplander

1 Answer

2006 chevy uplander noise coming from front left

The noise is coming from front left when going straight forward. No noise when turning left or when idle. It feels like rotation grinding or as if running dry.

Posted by on

  • alex  phx
    alex phx Apr 24, 2009

    Thx, How much effort is involved to replace bearings? Idea of cost to repair at dealer in canada less than $500 or more?



1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Chevrolet Master
  • 443 Answers

You need to jack the front left wheel off of the ground and try to get movement from in and out wiggle it put one hand on top of tire one on bottom of tire and **** it in and out to see if that bearing is loose .. if so it might need replaced or maybe take it appart and grease it.. I believe those are only replaceable .. not greasable.. thanks jerry P.S I would do this soon sounds like it could leave you stranded with more expensive problems ..

Posted on Apr 24, 2009

  • Jerry Koski
    Jerry Koski Apr 24, 2009

    Well not sure on costs up there but down here it should be way under 500 to repair.. thanks Jerry

  • riggsa1cad Mar 31, 2015

    the noise could also be sticking brake caliper on inside brake pad, brake pad could be completely worn down to metal



1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Replace front disc brakes on chevy uplander

Changing brake pads is pretty simple and straight forward. If you would like to try it yourself and save some money, GO HERE for a full color pictorial.

May 02, 2011 | Chevrolet Uplander LT Cars & Trucks

1 Answer

Need to replace turn lamp on left front (dash message). I have replaced rear turn lamps, but cannot see how to access the turn lamp area in the front. In the rear a couple of bolts held the whole rear lamp...

Welcome to

Park and Turn Signal and Daytime Running Lamp Nuts (Qty: 3)


Disconnect the forward lamp harness connector from the lamp socket


Thank you for using

Regards, Lee Davidian

Jan 12, 2011 | 2006 Chevrolet Uplander

1 Answer

Chevy caviler 1998 hit curb wit left tire

Something is bent... have a front end shop check it out, replace any bent parts and re align the front end.

Mar 13, 2010 | 1998 Chevrolet Cavalier

1 Answer

I have a 2006 toyota tacoma. When I go straight

a front hub bearing is bad probably the left front

Feb 27, 2010 | 2006 Toyota Tacoma

3 Answers

Cant figure how to get to bulb

There are 2 pins and 2 bolts that hold in the head lamp. Remove the head lamp to access the signal bulb. Good Luck

May 31, 2009 | 2007 Chevrolet Uplander LS Minivan

3 Answers

Where is the fuse box in the 06 chevy uplander

I have a chevy uplander and you have to open the passenger door and its on the side of the dash, to the right of the glove box. You will notice a small rounf opening with just enough room for 2 fingers to go in. the whole side will come off when you pull it.

Feb 28, 2009 | 2006 Chevrolet Uplander

1 Answer

Looking for location of ECM

Hope this helps

UPLANDER 06 Elec Cont Unit (ECU); (left front of engine compartment), 3.5L

Nov 13, 2008 | 2007 Chevrolet Uplander LS Minivan

5 Answers

2006 Chevrolet Uplander LT 2wd bad road noise in the rear end

i had the same problem, i found out that both rear torque arm bushing are filled with liquid grease, when they go bad all the grease comes out of them and then the metal sleeve inside the bushing starts the hit the bolts, when you hit a bump. that was the loud noise, that i had.

May 15, 2008 | 2007 Chevrolet Uplander LT Minivan

Not finding what you are looking for?
2006 Chevrolet Uplander Logo

523 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

80339 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides