Question about 2002 Dodge Stratus
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
Here's a link to this great service
Posted on Jan 02, 2017
ok first the fan relay should be located inside the elecrical box. this is usually located on the drivers side under the hood. next even you have only one speed when you turn the switch it's because the reostat is bad it is located in the fan motor housing. hope this helps.
Posted on Aug 28, 2008
its under the and i have replaced several radio's in those caravans because the radios are shorted out and keep blowing the fuse
Posted on May 08, 2009
If it's a chrysler engine the thermostat is located just below radiator cap. If mitsubishi diamond star engine it's located on the cylinder head , beside the air cleaner housing
Posted on May 10, 2009
The battery is accessible without removing the left front wheel and tire assembly..
Verify that the ignition switch and all accessories are OFF.
Turn the steering wheel to the full left position.
Disconnect and isolate the negative battery cable remote terminal from the remote battery post.
WARNING: NEVER GET UNDER A LIFTED VEHICLE IF NOT SUPPORTED PROPERLY ON SAFETY STANDS.
Remove battery splash shield. Refer to the Body section of the service manual for the procedure.
Disconnect the heater blanket cord, if equipped.
Remove the short bolt from the battery hold down and remove the hold down (Battery Location).
Disconnect the negative and positive battery cables from the battery.
Slide the battery toward rear of vehicle and lift out of the battery tray.
Remove battery from vehicle.
Posted on Oct 18, 2009
jack up the car take the wheels off the caliper which holds the pads need to come off usally 2 bolts if you are replacing the rotors you may have to hit them with a hammer to break the free if they have little clips on the rotors you can grabb the clips with pliers and take them off you do not need to replace them make sure you push the pistons on the calipers back in clean and lube the pins and the any where the rest on the knuckle do get lube on the rotors put it all back together do the same on the otherside before you start the car pump the brakes until a good pedal then you are good to go i hope this helps you
Posted on Apr 13, 2010
Tips for a great answer:
Mar 14, 2018 | Dodge Cars & Trucks
Jun 03, 2015 | 2000 Dodge Stratus
Mar 15, 2012 | 2003 Dodge Stratus
Sep 23, 2010 | 2006 Dodge Stratus
Oct 10, 2009 | 2004 Dodge Stratus
Jun 24, 2017 | 2004 Dodge Stratus
Apr 29, 2009 | 2002 Dodge Stratus
Aug 23, 2008 | 2003 Dodge Stratus
170 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: