Question about 2001 Dodge Dakota

2 Answers

Heater fan only works on the two low settings.

2002 Dodge Dakota the heater fan runs on the two low settings but when you turn the knob to the two high settings the fan quits running.

Posted by on

  • yadayada
    yadayada May 11, 2010

    check the fan switch for burnt contacts and connector

×

Ad

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 48 Answers

If you have checked the switch as recommended, it is most likely to be the heater resistor which contols the diffrerent speeds. it is
normally fited near to the motor and is a squarish block with multiplug on it and coils like springs in the centre of it, look at the coils they may be burnt out.hope this helps

Posted on Apr 22, 2009

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Master:

    An expert who has achieved Level 3.

  • Dodge Master
  • 428 Answers

Howdie you need to replace the blower motor resistor it runs your speeds

Posted on Jul 26, 2012

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Where is the heater resistor on a 2005 dodge dakota? Behind glove box?


should be just above the blower motor. You will need to remove the glove box door to gain access.

Dec 12, 2015 | 2005 Dodge Dakota Club

1 Answer

The heater in my 2002 Dakota works only at the very highest setting. There is no power at the lowers settings. The defrost light doesn't come on until that setting also, so definantly no power. When turned...


I'm assuming you mean the fan only works on high. If that's the case the blower motor resistor is bad. When the fan switch is on high it puts a full 12Volts to the blower motor. When you have the switch in any other possition, the voltage is routed through the resistor and reduced thus making the motor run slower.

Dec 14, 2009 | Dodge Dakota Cars & Trucks

1 Answer

2002 Dodge Dakota 4WD Sport, 6 cylinder. Gear


look at the shifter linkage, and as far as the heat check your heater core

Dec 04, 2009 | 2002 Dodge Dakota Club Cab

2 Answers

2004 Dodge Dakota Heater fan motor will not run on low speed. All


Your blower resistor may be wearing out or corrosion setting in. The part is cheap and you can probably replace it. This link shows where an 01 is located. Yours may be in the same spot on on the engine bay side of the passenger firewall. Check with your auto parts store also for location.

http:/www.gtrippleb.com/auto/durango/tech/durango_blower_resistor.htm

Nov 10, 2009 | Dodge Dakota Cars & Trucks

1 Answer

Location of heater control module on Dodge Dakota 2002


The heater control module is in most newer vehicles the heater control panel in the dash. Where the fan, heat, a/c controls are...

Sep 14, 2009 | 2002 Dodge Dakota Club Cab

1 Answer

Have a Dodge Dakota and the heater fan went out


tey testing the heater resistor first if that does not work put a hot wire and a ground to the motor if it turns then it's the heater or the switch and get back to me to help you with the rest.

Aug 20, 2009 | 2001 Dodge Dakota

1 Answer

2002 Nissan Altima - Heat doesn't get hot and doors get stuck


Did the switch break because it was stuck? If so, then yes, they will have to change actuators and doors. Does the fan work on all speed setting? If so then you do not need a blower resistor. The resistor pack only controls the current flow to change speeds of the fan.

Dec 05, 2008 | 2002 Dodge Dakota Club Cab

Not finding what you are looking for?
2001 Dodge Dakota Logo

400 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6918 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...