Question about Toyota Yaris

1 Answer

Oil filter requires changing

Oil filter needs changing how do i do it

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 6 Answers

Start by dropping you oil and make sure you engine isnt hot ........open you oil intake this is where you pour you oil in then get a new oil filter and seal it with some bnew oil and replace the old oil filter thentighten up the sump plug which you had to remove to get rid of you old oil and tighten up your new oil filter and fill up oil up to full mark on dip stick hope this help jason

Posted on Apr 22, 2009

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 4 Answers

SOURCE: oil quantity needed for oil change

2 litres of petrol

Posted on Jan 01, 2009

lemmingleejn
  • 173 Answers

SOURCE: oil filter in civic 97

If you go to a reputable motor factor,
you can only be sold the correct filter for the civic.
As there are soo many variables in engine type, it's almost impossible to tell, oil volume, or which type filter.
However, I will say, be sure that you don't mix semi-synthetic oil, and mineral oil.
Oil changes should be undertaken every 30,000 miles, (unless under extra work load, (in which case, slightly more regularly))

Otherwise, 10/40 or 15/40 grade oil, is perfectly fine.
The trick to not overfilling the oil, is simply just to take your time, clean the dip stick and retry, until you have the correct reading.

Please don't forget to rate:)

Posted on Jul 29, 2009

thunderalley
  • 432 Answers

SOURCE: i need to change my Aveo Oil How much leter is

any local Autozone can help you

Posted on Sep 24, 2009

  • 1779 Answers

SOURCE: I have changed the lube oil and filter in my

The instructions on how to reset the' oil change required' message is in the owners manual (I believe it's page 81). Listed below is a site to get a free download of the manual for your 05 Mountaineer. Let me know if you have any trouble accessing this info.
https://www.fleet.ford.com/maintenance/owners_manuals/results.asp

Posted on Apr 01, 2010

  • 20 Answers

SOURCE: maintenance required light. does that

yes!!!!

Posted on Aug 21, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My car overheats even after you drive only 5 kilos. What could be the problem


two liquids regulate temperature i the car - oil and coolant. you need to check both, as you did not bother to think and provide us with manufacturer,model, fuel type and year, only general info can be provided.

oil - check level and change/top up as required, if change required - change oil filter as well while you are at it. change for type of oil required for your vehicle, oil and filters should be changed every 5000km (3500miles) to 10000km (7000miles), this depend on the condition, driving and age of the engine.

coolant - check level, top up f required.

if oil level is correct, and no loss in coolant either, you need to check coolant flow, start investigation if pump belt is not too lose and tension it if required, cannot do that if pump is driven directly from the shaft. check for thermostat problem and change if required, lastly - check radiator flow and reverse flush if required.

if you are flushing radiator - best is to flush block and heating system as well at same time, drain liquid and re-fill with new coolant.

hope this will help you at least a bit - do not forget to vote... :-)

Apr 10, 2015 | Cars & Trucks

Tip

How to change the oil in your car


Attention: Read each step completely before you begin that task. Tools Required:
#1: Oil filter wrench or pliers
#2: Small wrench and sockets (Metric sizes for import cars)
#3: Oil collection device (pan or bucket)
#4: Funnel
#5: Cloth rag or paper towels
#6: Jack and stands or ramps
Supplies Required:
-Correct amount and type of oil, and thrust washer if necessary
-Correct oil filter
Step 1: Determine the correct oil type, oil filter type and size, and amount of motor oil for your car. (Information found in owner's manual)
Step 2: Park your car on level ground and turn off the engine.
Step 3: Locate the engine and make the oil pan accessible. (With the use of jack and stands or ramps) Tool #6 required.
kormega_11.jpg
Step 4: Remove oil cap. (Located on top on engine)
kormega_12.jpg
Step 5: Loosen oil drain plug. Collect oil when draining and dispose of properly. (Located on oil pan which is attached to the bottom of engine block, directly below oil cap)
Tool #2and 3 required
Caution: Oil will start to drain and may be hot
kormega_13.jpg
Step 6: Once completely drained (a slow drip), replace oil plug. Install new thrust washer with oil drain plug if necessary. Do not over tighten.
Tool #2 required
kormega_14.jpg Step 7: Loosen oil filter. Collect oil when draining and dispose of properly. (Attached to the side or bottom of engine)
Tool # 1 and 3 required
Caution: Oil will start to drain and may be hot
kormega_15.jpg Step 8: Install new oil filter hand tight. Lube the rubber O-ring on oil filter with motor oil, and make sure the O-ring from the old filter is not still on the oil filter connector.
kormega_16.jpgkormega_17.jpg Step 9: Pour correct amount of new motor oil into engine.
Tool#4 required
kormega_0.png Step 10: Check for oil leaks from drain plug or oil filter.
kormega_18.jpg Step 11: Turn on engine and continue to check for leaks. Tighten oil drain plug or oil filter if necessary.
Step 12: Turn off engine and check oil dip stick to see if the right amount of oil has been added. After removing oil dip stick, wipe clean with rag or paper towel. Reinstall oil dip stick and then remove again to see correct oil level. Then Reinstall oil dip stick again.
Tool #5 required
kormega_19.jpgkormega_20.jpg Step 13: Lower vehicle from jack and stands or ramps.
Step 14: Record the mileage of the car for future reference. (Motor oil should be replaced about every 3 months or 3,000 miles)kormega_21.jpg

on May 03, 2011 | Nissan Maxima Cars & Trucks

1 Answer

Trans missom oil filter for hyundia trajet v6 how to change


transmission oil filters are normally inside the transmission and will require the pan to be removed . They will not need attention unless you have drastic problems with the transmission
Mostly all that is needed is a an oil change

Feb 04, 2015 | Hyundai Trajet Cars & Trucks

1 Answer

Toyato camray with filter how much ltr 2008 model


Toyota 2008 Camry V6 requires 6.1 quarts of SAE 5W-30 oil with filter change
The 2008 Camry's with the 2.4L I4 require 4.5 quarts of new 0W-20 or 5W-20 oil with a filter change

Oct 11, 2012 | 2008 Toyota Camry

1 Answer

Need to know what kind of oil mt 2007 RAV4 uses.


Your 2007 RAV4 requires 4.5 quarts SAE 5w20 with filter change. I use Pennzoil and highly recommend it but all major brands are good. Use a quality filter such as Wix, Purolator, or Bosch. Change your oil/filter every 5,000 miles if using conventional oil and every 7,000 miles if using synthetic if you drive normally.

Feb 07, 2011 | 2007 Toyota RAV4

1 Answer

What if any special tools are required for a


No special tools required. MAYBE!

I say maybe because if you've ever taken you car into a quick lube place and they've changed your filter they are Notorious for installing the new filter on TOO TIGHT!. They are actually told to do this so the owner is forced to come back and have them do the next oil change. Its almost criminal.

The plug to drain the oil from the car is a simple 5/8in bolt, a socket or open ended wrench with work just fine.

The Oil filter SHOULD be able to unscrew by hand. Now if its on there too tight. There is a tool at any auto parts store called a Oil filter Wrench. They run around 10-20 bucks. all it is a handle with a metal ribbon that loops around the filter and allows a better grip.

You can also get away with jamming a screw driver into the filter and using that for leverage to unscrew it from the engine. *Note* This is extremely messy!!!

Just remember when installing a new filter to tighten it one half turn after it becomes tight. It does not need to be cranked on there hard.

Hope this Helps and thanks for using FixYa.com

Aug 14, 2009 | 2005 Ford Fusion

2 Answers

How do I change the oil filter on a MAZDA 6 4 CYL..


You don't need a special tool. Use a 6mm allen to remove the filter drain plug. It will probably start to spin the filter housing. You can remove the housing by hand or with a regular oil filter wrench.

Aug 12, 2009 | 2004 Mazda 6

4 Answers

Changing oil in a Ford 450 super duty motor home


Places that service motorhomes want to make the bigger bucks. Do it yourself. Its just a drain plug and filter removal. They have a large oil capacity but if you have changed oil before on other cars go ahead and do it. If it sits high enough off the ground you will not need to raise it. Get a good oil change pan that holds 8 quarts. It may take that much.

Jul 08, 2009 | 2008 Ford F 450 Super Duty

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

390 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8516 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...