Question about 1996 BMW 318

1 Answer

316i 1st gear when u speed up the car jolts going up in revs but all the other gears r ok?

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

Hi, check the rubber hose between the air box and the inlet manifold, the rubber was cracked underneath and was drawing air after the sensor, causing the car to jump in 1st gear! a quick fix is to tape it using electrical tape, or just replace it. hope this helps!! steg

Posted on Apr 27, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Travelling at 100 klh @ 2000 revs kicked down in Polo-revs up to 4500 but would not move up gear(s)


run the fault codes to check for TCM or other problem sensor in the transmission. It may be a protection item as it is unwise to kick down at that speed as kickdowns are used to change to lower gears when going up hill or pulling a load and need a lower gear . They are not meant to pass at speed .It is the same effect bas with a manual in overdrive at 100klms and suddenly shifting into 1st gear

Dec 23, 2014 | Cars & Trucks

1 Answer

I HAVE A MICRA 2005 MODEL WITH NO POWER. WHEN THE CAR IS IN NEUTRAL CAR REVS FINE, THE MOMENT YOU SELECT 1ST GEAR ENGINE LABOURS AND REVS UP VERY SLOWLY AND DOESNT REV PASED 4000 RPM PLEASE ADVISE


possible selector problem when you push forward for 1st your are actually pushing into 3rd, try starting car from 2nd gear and see if it stalls as that would mean you are hitting 4th. usually a car can pull off in second gear ok. if this is the case go to a dealer to sort this out. as your gear selector is not aligning up correctly. if this is not the case the engine could be losing compression but that seems less likely.

Oct 22, 2014 | 2005 Nissan Micra Visia

1 Answer

Honda accord 2005 2.2cdti,1st and 2nd gears are very slow on the rev uptake,but the rest of gears are ok,ive tried egr valve air flow meter and map sensor,still no good any suggestions


Try changing the fuel filter now. Higher revs on initial take of requires more fuel that isn't required at lower revs at speed in the higher gears. Could also be dirty air filter.

Sep 25, 2014 | 2005 Honda Accord

1 Answer

Problems selecting 1st gear peugeot 106 1.1 zest


If the clutch is a problem you will have difficulty selecting 1st only as the gears would be spinning from the engine revs.. I would say that the front input shaft (clutch shaft) bearing is failing allowing miss alignment of the synchros and not allowing proper engagement of the gears synchro rings. It means removal and repair to the gear box so the clutch can be inspected while the box is out.

Apr 08, 2013 | Cars & Trucks

1 Answer

2001 dodge 2500 5.9l 4 speed automatic shift problems


For car not changing gears it can be shifter assembly issue, or it can also be transmission issue. Get the shifter assembly inspected with ignition OFF.

For more troubleshooting, I suggest you to get the Following help link checked, its complete step by step procedure to inspect gear shift issues: -----

GEAR SHIFT ISSUES

http://alltypesofpartsreplacing.blogspot.com/2012/11/gear-shift-issues.html

==========

These will help.
Thanks.

Feb 15, 2013 | Cars & Trucks

1 Answer

1991 Dodge Caravan - Transmission problems


BELIVE ME THIS HAPPENED TO ME AND IT WAS BECAUSE MY OIL WAS LOW CAUSING THE ENGINE TO REV HIGHER TO MAINTAIN SPEED.DO YOUR SELF A FAVOR AND CHECK (ALL) THE FLUIDS IN YOUR VAN 1'ST.HOPE THIS HELPS

Jul 30, 2009 | 1991 Dodge Caravan

1 Answer

Need to know how to adjust clutch on 03 focus with 5 speed


hi are you saying you canno select 1st gear?? but able to select other gears and drive car ok ? your clutch is auto hydraulic adjust if you could offer more info on 1st gear unable select? it would give a better picture of what may be your problem? at the moment its sound like selector problem?

Nov 16, 2008 | 2003 Ford Focus

Not finding what you are looking for?
1996 BMW 318 Logo

Related Topics:

209 people viewed this question

Ask a Question

Usually answered in minutes!

Top BMW Experts

Frankie B

Level 2 Expert

65 Answers

Fred Sops

Level 2 Expert

272 Answers

Doberman

Level 2 Expert

254 Answers

Are you a BMW Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...