Question about 1988 Dodge Aries

1 Answer

Pin hole in the hose on the fuel line

There is a pin hole in the hose going from the gas line to the fuel injector, how do we get the part to replace it

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 16 Answers

Salvage yard..... good luck

Posted on Nov 29, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Where to drain the bad gas from I mixed it with diesel


There is NO drain on the tank bottom.....Disconnecting fuel line/add extension if/as needed,place hose/extension in aux fuel tank,add 'Modis',request fuel pump 'on' & drain tank.....Add fresh fuel,replace fuel filter & ad fuel injector cleaner (Preferably Lucas #10020) & PROPERLY dispose of waste fuel.

May 01, 2015 | 2006 Nissan Maxima

1 Answer

1995 mercury cougar xr7 intermitent hesitation ! fuel pressure at fuel rack is 28 psi.


try injector & fuel system cleaner, check throttle body & injectors for cleanliness, also run diagnostic on sensors, check vaccuum lines for pin holes, does it do it if you foorboard the gas ped. when it hesitates ?

May 27, 2014 | 1997 Mercury Cougar XR7

1 Answer

I have a F350 diesel non- tubo with a fuel leak in back at top. replaced o ring at back injector and replaced all hose clamps but still bad runing leak. What next?


This engine has fuel lines that run to each injector from the injector pump. On the older Fords they touch each other in places. This constant vibration from the engine has caused a pin hole in one of your fuel lines to the injector. You will need to find the bad line. Can be hard as some of these are buried and hard to see. The replacement line will need to be purchased from Ford as each fuel line has to be a certain length and they are all high pressure lines. I have seen this many times in the older Fords.

Apr 05, 2012 | Cars & Trucks

1 Answer

Small pin holes i gas line under driver side door How can i seal it without changing line


You can cut out the rusted sections and replace them with rubber fuel injector hose and be sure to use two hose clamps on each end.

Feb 04, 2012 | 1993 Jeep Grand Cherokee

1 Answer

Gas is leaking from my fuel rail (phlegm) on my number 5 fuel injector on my 1994 camaro


  • Park the Camaro on a flat, level surface and set the parking brake. Open the hood and secure it in place with the hood prop. Disconnect the negative battery cable.
  • Open the gas tank to relieve pressure on the fuel lines.
  • Remove the sight shield from the fuel injector with a socket wrench. Loosen the screws on the hose clamps and disconnect the fuel lines connected to the injectors. Keep a rag handy to catch any fuel that leaks.
  • Disconnect the vacuum hose and ignition coil wire, then unplug the electrical connectors. Remove the fuel injector mounting bolts, undo the retaining clips and remove the fuel injectors.
  • Put a thin coat of engine oil on the new fuel injector's O-ring. Place the O-ring in position, install the new fuel injectors and secure the retaining clips. Install the mounting bolts with a torque wrench set at seven pounds.
  • Plug the electrical connectors back into the fuel injectors. Reconnect the vacuum hose and ignition coil wire. Connect the fuel lines and tighten the hose clamps with a screwdriver to secure them in place. Bolt the sight shield in place with a socket wrench.
  • Place the gas cap back on. Reconnect the negative battery cable



  • Dec 06, 2010 | 1994 Chevrolet Camaro

    3 Answers

    I have a 1994 Nissan Sentra, It stalled on the highway, and would not start back up. First thing I did was put some gas in the tank because you never know. Next thing I did was to spray ether in the...


    It takes more then fuel pressure for the engine to run. First thing to do is check the injector fuses and visually inspect the wiring. If that checks out OK use a noid light to see if the injectors are firing. If they aren't firing there is a bad sensor, bad injector driver in the computer or a wiring fault.

    Aug 25, 2010 | 1994 Nissan Sentra 4-Door

    3 Answers

    Why does my car smell like gas & uses way too much gas and is leaking gas on my engine out of a line?


    I don't know if your stating that gas is leaking on your engine but anyways....other than the bad syntax in your sentence. You may have leaky injectors and there maybe too much fuel getting into your combustion chamber and getting stuck around the catalytic converter which will give you really bad gas mileage, smell like fuel and destroy you Cat.Converter. Start with injectors to see if they are leaking and check all fuel lines thoroughly. Also check your charcoal canister (black canister on the firewall) to see if its broken, cracked or leaking anything. If its very strong. Check near the tank itself. If you ever see fuel on the ground when you fill your tank, you may have a torn line at the tank or the seal around the gas tanks fuel sending unit is leaking is leaking. Good luck Plz rate

    Jan 16, 2010 | 1997 Pontiac Sunfire

    1 Answer

    How Do I connect a cut rubber fuel line on a Buick Century


    Ouch! call around to parts stores there is a nylon hose kit repair with barbed ends & clamps.Good Luck care around gas

    Aug 30, 2009 | Buick Century Cars & Trucks

    1 Answer

    Pin hole leak in fuel line, (fuel injected), how do i fix???


    Either replace the fuel line, or cut that section out, and put a piece of fuel line hose in and clamp it on both sides. Make sure the fuel hose is for fuel injected systems.

    Jul 21, 2009 | 1995 Chevrolet Lumina

    1 Answer

    Small hole in fuel line??


    if it is a pressure line it has to be replaced. if it isn't you can cut out the pin hole and take a piece of metal tubing and insert in both ends of hose and use small hose clamps. this is a quick fix for very lil money. hope this helps please rate this solution. thanks

    Aug 29, 2008 | 1988 Buick Century

    Not finding what you are looking for?
    Cars & Trucks Logo

    Related Topics:

    67 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Dodge Experts

    yadayada
    yadayada

    Level 3 Expert

    75066 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22095 Answers

    Jeff Turcotte
    Jeff Turcotte

    Level 3 Expert

    7754 Answers

    Are you a Dodge Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...