Question about 2000 Audi A6

1 Answer

Unplugged drivers window switch on my 2000 a6 put back together now windows dont work and doors dont lock from inside and shows that they are open when they are closed

Posted by on

  • audieurope May 11, 2010

    what was the reason for disconnecting them at first place ?
    Could be your switch malfunctioning and there is wiring issue somewhere else


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Audi Master
  • 22,095 Answers

Check that the plug is in properly and you havent pulled the wires getting the connector off ,and try that if it still doesnt work then its dealer only because i seem to remember that about this year vehicle doesnt have wires as such but bus lines and a module ,if it has then its dealer only because you have upset the module and it need to be re programmed back on line .encrypted software so its dealer only and no silly snap on reader .sorry for the bad news

Posted on Aug 16, 2009

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

My 2000 Audi A6 Quattro's driver door will not

Chances are it's the door mech that's gone it needs to be broken from the inside any dealer or specialize garage should be able to do this

Jul 30, 2011 | 2000 Audi A6

2 Answers

All 4 windows stopped workin at the same time

It's possible that the wires to the driver's door window controls have somehow become disconected, or maybe one of the switches for the windows in the driver's door is not working. First tke the interior panel off of the driver's door, a shop manual should tell you how to remove the interior panel, depending on the style of door it can be a small job or an expensive endevor. If you do get the panel off look at the underside of where the window switches are at and see if the wires and wire harneses are all secure and there are no loose wire conectors or wires. If there are any loose or disconnected reconnect them and try the windows before putting the door back together. You may need to start the car to make sure that there is power to the switches. If the connectors are fine and the windows still don't work, unhook the wires to the switches one at a time (the wires should be connected to the switch through a conector that can easily be unplugged and plugged in again) and test each switch with an electrical tester to see if one is bad. You may have to play with different settings on your tester, but one should be able to work. Replace the switch if one is bad, and again try the windows before putting your door back together. Hope this is helpful.

Oct 15, 2010 | 2000 Daewoo Nubira

1 Answer

My 1998 Audi A6 power windows not working

Check wire harness between driver door and body for broken wires.Wire harness bends , when door opens and closes so it may brake the wire or two inside harness.

Jun 01, 2010 | 2004 Audi A6

2 Answers

Power door locks quit working on drivers side switch. Next day lowered power window now I can not raise or lower any windows from any door switch

You may find broken wires inside the rubber wire cover between the door hinges.. the wires break due to flexing when the door opens and closes .. repair by soldering and heatshrinking the wires back together,,,and this will fix all NOTE ....You can use crimp connectors but they dont offer any protection to the connection and the wire will break at the connector at a later date ....Good luck

Dec 05, 2009 | 1999 Dodge Durango

3 Answers

None of the windows work! 2000 Intrigue

if no fuses are burnt and you have new switches installed then it going to be either bad motors or a broken wire in the harness to the driver door switch set.

Aug 11, 2009 | 1998 Oldsmobile Intrigue

1 Answer

2000 jeep cherokee sport fuse diagram

Likely you are looking for a 30 amp circuit breaker...(Looks like a small rectangular metal fuse) But...if the power door locks work, i don't think that it's bad (serves locks & windows) My diagrams show a bunch of diodes and resistors inside the master (drivers) door switch, but I've had a few apart and never saw any. (embedded?) Personally I don't see anything that shows me reliability built into the switch...It's a really "iffy" design (one in my niece's Jeep only works when the sun shines on the drivers door) There is also a control module associated with the windows but I've never needed to replace one and the manuals never tell you where they are!
Check power at the switch and check harness where it goes through the rubber boot between the door and body. at least 80% of problems I've seen are either the switch or that wiring. Wires can be spliced and you can get a decent used switch at most scrap yards.
Good luck...glad they aren't stuck down!!!

May 31, 2009 | 2000 Jeep Cherokee

2 Answers

VW Polo 2001 - Electric Windows wont open from Drivers side..

I removed all 3 switches from driver and passenger door, which is really easy with a flat head screw driver. took them completely apart, very carefully, with a small screwdriver out of a christmas cracker. put them back together again and 2 switches started working, so I put 1 in the drivers side and 1 in the passengers side so now my drivers door window opens and I lean over to open the passenger door. cool, no money spent...yet ;o)

Mar 25, 2009 | 2001 Volkswagen Golf

1 Answer

Single power window switches dont work

Replace the drivers door window/lock control unit in the door.
I had the same exact issue and it is not a connection issue. I
never left the window open in the rain but the control unit did have some rust on it.

Jan 10, 2009 | 2000 Dodge Durango

2 Answers

None of the driver's side window and door lock controls work. Additionally, none of the other door's widow controls work. The front passenger-side door locks do work.

For killerbee6 - Lets try the simplist possible thing first. Is the window lock (child safety feature) button pressed in? Its located there on the drivers door with all the other windows switches. If it is, then all windows will be locked in their current location. Also the back doors have their own (child safety feature) manual switch located on the end of the door that opens out (which override the manual "pullup lever" inside, to unlock door)

Second possibility is that the modular connector in the drivers door has seperated from its other half.
=====[ ]========= when it should be ========[]==========

For bbmason - sounds like your vehicle was broken into and the theft (which didn't get the truck) may have popped off a switch that is attached to the back side of the key cylinder. That switch tells the Security system a key was used to unlock door, and since its not attached to the cylinder anymore it can't return to it normal 'home/nuetral' state, so when you arm the security it disarms 5 seconds later.

Aug 02, 2008 | 2000 Dodge Durango

Not finding what you are looking for?
2000 Audi A6 Logo

Related Topics:

136 people viewed this question

Ask a Question

Usually answered in minutes!

Top Audi Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers


Level 3 Expert

75005 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14195 Answers

Are you an Audi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides