I just bought a 1984 Pontiac Bonneville from a junk yard. It didn't have any keys. I can still drive it, but cannot figure out how to open the trunk. Is there somewhere I can get a replacement key, or some way to open the trunk without a key?
SOURCE: Trunk wont open where is emergency switch inside trunk
I had the same problem as you. Take out the back seat and there is a large access hole to the interior. There are two bolts that are fairly easy to get to. Remove them and the truck latch is removed from the lid and trunk will open.
SOURCE: trunk will not open with or without key
hello theres really not many choices if you have a trunk key it should work if not and the inside trunk release isnt working either you could try to get at the lock setup from the back seat take your lower seat out remove the lower holding bolts slide up off the top lock setup see if theres enough room to work from there to pop the trunk open with a flash light and a screwdriver if not your going to have to pop the lock cylinder at your trunk once its out you can get a aftermarket replacement under $ 20 goodluck please rate
SOURCE: trunk won't open -1993 audi 90S
if you can drop back seats you can get in and manually flick the lever when it is open you will have to go to dealer to see if you can get a key to match or you might get 1 in a junkyard. if this helps please rate me
SOURCE: how to open the trunk without the key i cannot
call a locksmith. There is a chamber inside the lock for the gas cap that has a code on it. From that code, they can create a new key for you that will open your trunk.
SOURCE: my key wont unlock the trunk anymore but the remote opener does.
There is a cable that runs from the key cylinder to the latch mechanism. There are clips that hold the cable housing in place, and if one of those comes loose then turning the key just moves the housing without releasing the latch. Check the clip closest to the latch. To get the trunk open drop the back seat, crawl in, and pull on the cable.
It is also possible that the cable is broken or damaged and needs to be replaced -- I assume you will then need to replace the enrite assembly.
157 views
Usually answered in minutes!
×