Question about 1995 Pontiac Bonneville

1 Answer

Rusty Fuel line

How do i replace the fuel line from the tank on up to the front

Posted by on

  • yadayada
    yadayada May 11, 2010

    u must make the line up yourself, you will need a tubing bender and a flaring tool.

×

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 89 Answers

The fuel line should be in sections.i had the same problem on my 93 chevy truck.the sections come 4' long with male connectors.go to advance auto or your choice,and get some female connectors to connect the four foot sections with.you will need a hand held line bender so you can bend the line to run with your frame.you can replace all of the fuel or the bad sections

Posted on Apr 21, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why wont my 90 f-150 custom EFI 5.0L start?


If you got as lot of rust from the fuel. you may have to replace the filter again. or clean out all the fuel lines and replace the injectors. May even have to replace the fuel tank.

Dec 21, 2014 | Cars & Trucks

1 Answer

How long does it take to replace fuel pump on 98 trans sport?


depend on how rusty are fuel line at fuel filter and tank strap ,must lower the tank gm fuel pump are expensive

Aug 15, 2014 | Cars & Trucks

1 Answer

Rough idle


Hello Patricia. Their are several common problems with this year Sportage that makes it run rough. The most common problem is clogged fuel injectors caused by a rusty gas tank. Their is a recall for this concern but even if the vehicle already had the gas tank and fuel injectors replaced that does not mean you do not have the problem as the replacement gas tanks also rust out. to check for this you should remove the fuel filter and drain the gas out of it into a clear container. Blow thru the outlet so unfiltered fuel is drained into the container. If the fuel is rusty you will need to replace the fuel tank,filter and injectors and then flush out all the fuel lines. Another common problem causing a rough idle with this year is the camshaft timing being incorrect. This is caused by a loose timing belt or sometimes the keyway on the crankshaft breaks so the crankshaft sprocket turns on the shaft. This means that when the timing marks for TDC cylinder 1 are lined up everything looks good but in reality the sprocket is lined up but the crankshaft is not at true TDC. I think their may be a TSB for this. Dont forget to also look for vacuum leaks. If the problem started after spark plugs where replaced you may want to check for a disconnected vacuum line at the rear of the manifold. The manifold comes off to replace the spark plugs and it is very common that the technician forgets to put this vacuum line back on. Hope this helps.

Apr 18, 2014 | 2000 Kia Sportage

1 Answer

Fuel is leaking or being forced out of the tank had a recent fuel pump replaced is it possible to have a leak after such a procedure


yes very very possible the fuel lines probably are very rusty and/or brittle and when disturbed to replace pump can develop a leak also any connections where the lines hook to tank can leak or could be top seal on tank where pump goes into tank(top seal usually only leak on a full or near full tank)

Jan 29, 2011 | 2001 Chevrolet Cavalier

1 Answer

The fuel pump and membrane etc. are shot. Also the fuel tank shows corrosion of rust and gunk. My mechanic says it would be cheaper to clean out the old tank rather than replace it with one i found at a...


If you have a rusty old tank, it will always be a rusty old tank. If you can find a nice tank at the junk yard great, but I would always replace the used pump and strainer no matter what. It is not an impossible job if you have the proper tools. The problem you may run into is if the fuel lines are rusted they are impossible to disconnect not to metion if the fuel tank straps are rusted where they bolt on you may not be able to get the bolts out. This vehicle is no spring chicken and you could run into a real mess. I personally hate these jobs. Do not apply heat or an open flame anywhere near the lines or tank as it can cause an explosion or an uncontrollable fire.

Nov 18, 2010 | 1991 Mazda 323

1 Answer

I have a 1995 Mazda MPV,V6,4x4,I think the fuel is not working


Don't drop the gas tank. Pull back the carpet in front of the rear seat and there will be a square cover closer to behind the passenger seat with 4 screws holding it down. Remove that cover and it will expose your fuel sending unit cover. This will be circular in shape with 6 or 8 small philips head screws holding it in place. Unfortunately they will probably be very rusty and hard to get out. You will first need to disconnect the electrical plug and the 2 fuel lines. After removal of the fuel lines and the screws carefully remove unit to expose fuel pump.

Apr 05, 2010 | 1995 Mazda MPV

2 Answers

I have a 1989 k1500 350 5.7L. how to remove the fuel filter from the gas tank. It's rusty around the fuel filter and gas tank. I just don't want to miss anything up.


The best think i have found to use on rusty parts is called PB Blaster, It comes in an areosal can that can be purchased at any local parts store such as Autozone or Advanced Auto Parts, Spray some on the rusty parts and let it soak for a little while and it should break free no problem.

I hope this helps, Good Luck, Allen

Oct 04, 2009 | 1989 Chevrolet C1500

2 Answers

How to change fuel pump 1990 cadillac seville


The fuel pump and sending unit is located in the tank. I hope your tank is empty, if not you will need to siphon it out. It is dangerous with the gasoline, and remember the fumes burn, not gas. You start by removing the filler hose, then loosen straps, detach sending unit wire and fuel line, then lower tank. Then unscrew the sending unit/pump and replace. reinstall.

Jul 05, 2009 | 1990 Cadillac SeVille

2 Answers

Trying too find where the fuel pump is in my 92isuzu pick up truck its a 4cylinder


its in your fuel tank. make sure the tank is empty before you drop it.

Jan 18, 2009 | 1992 Isuzu Pickup

1 Answer

1987 4Runner


My 1999 4Runner just started having starting problems. I replaced the battery under warranty. still has issues. It has issues with the engine Hot or Cold so I know its got to be something other than the starter. What I figured out last night was, depending on how I hold the key when turning the ignition can determine if the engine will start or not. Pushing down, while turning has the most success, while pushing up while turning will always not start.
Therefore this sounds similar to the condition that had affected my other car and now I'm looking into replacing the starting switch.

Jul 06, 2008 | 1993 Toyota 4Runner

Not finding what you are looking for?
1995 Pontiac Bonneville Logo

Related Topics:

103 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

76673 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8531 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...