Question about Hyundai Accent

1 Answer

Need to replace boot sleeve on manual trans shifter

I had a Haynes book on my 2002 Hyundai Elantra, but I can not find it. I'm trying to replace the shifter sleeve on the manual shifter. Do you know if the entire center console needs to come out in order to take the two screws out of the sleeve, or is there an easier way. The center console is getting stuck on the E Brake.

Thanks.
NJB

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

The frame that holds the "leather" in place just pops right out (come at it from one side; it'll sort of pivot around the other side -- I can't recall which is which, but trial and error works). Alternately, if you remove the six screws holding the entire center console in place, it can slide forward and rotate such that it'll clear the e-brake. Alternately alternately, if you curl your fingers underneath the boot frame on the side facing the rear of the car, you can pop the darker gray smooth plastic part of the center console entirely off while leaving the whole center console screwed in.

Posted on Jun 24, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I need to replace a automatic transmission pressue control solenoid, so I need a schematic for a 1999 Hyundai Elantra, or can any one help with the problem at hand?


dont replace parts till u kno the answer--thats an older trans so a # of things may be worn--a data stream shud be performed to pinpoint instead of just a code reader--also a pressure chec too--haynes manual or chilton show repair details

Oct 18, 2011 | Hyundai Motor 1999 Elantra

1 Answer

I just drove my 2009 elantra home and it will not shift into reverse or park, need help


there should be a place for you to insert your key to unlock the shifter or a unlock button. it should tell you in your owner hand book where it is at to unlock the shifter.

Nov 30, 2010 | 2007 Hyundai Elantra Limited Sedan

1 Answer

2010 hyundai elantra Manual trans won't start.


Check engine block ground.
Check starter.

Feb 19, 2010 | 2000 Hyundai Elantra

5 Answers

Which auto repair manual has the most specific instructions for replacing timing belt on 2003 elantra?


A haynes repair manual should have a pretty precise set of directions. I could also fax you a copy for a small fee. but if you spend the money for the book you would have all the information you ever could need for the car. its up to you which one you would rather go with.

Aug 29, 2009 | Hyundai Motor 2003 Elantra

1 Answer

Is it possible to put a shift boot with a custom shifter on at automatic 01 hyundai elantra to make it look like a standard?


yes, jus need to get a booth with a bibig enough base to cover shifter base and get o costom shifter knob from auto shop

Aug 23, 2009 | 2001 Hyundai Elantra

1 Answer

Can't get car in or out of gear


Throwout bearing will need to be replaced most likely. Otherwise cluctch plate or fork may have stuck

Aug 06, 2009 | Hyundai Motor 2002 Elantra

1 Answer

Will not shift out of park


can you move the shifter and it wont go into gear or will the shifter not move at all?? if shifter wont move, there is an electrical solinoid that will not allow the shifter to release when the car is off, that could be faulty, i think it also has a safety mechanism that wont allow it to shift if your foot is not on the brake? if the shifter moves through prn321 but the trans wont come out of park, you have broken the shifter cableand or damaged the shifter mechanism in the trans. hope i have been of some assistance

May 16, 2009 | Hyundai Motor 2003 Elantra

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

493 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...