Question about 2002 Chevrolet Blazer

1 Answer

Some time when i start my 01 blazer theres nothing and then bam

Some times when i go to start my 01 blazer there nothing no sound no click all light are on i have full power but no start then i just keep turning the key or hold it in the start possition and all of a sudden bam it starts like nothing happend also the other day it started fine but soon as put in gear bam agai it cuts out but start right back up what is this b4 i put this thing in the trash and call it a day also not sure if this is related but some time i go to start and it clicks like dead battery but after i keep trying it starts just fine and thats without a jump or ne thing ( i was thinking batter alt summing like that but hope use can help thanks

Posted by on

  • rspjr0310 Apr 21, 2009

    Thanks i just cleaned the cables yesterday and it almost seemed to make it worse but now i just went out and start it it started right up and i had not 1 problem its crazy

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 232 Answers

Check your battery cables and connections,if you access to an ohmmeter you can check them,clean any corrosion on the cable clamps and battery posts,pull the negative cable off the motor and clean it and the spot on the motor it bolts to.Place a lead on each end of the negative cable,you should get a 0 ohm reading or really close to it,any higher than 2 or 3 ohms and the cable is bad,repeat the procedure with the positive cable.Be sure to have the thecables undone from the battery,placing an ohmmeter on a live circuit will burn up the internal fuse or burn up the meter.If the cables check out good look to the starter solenoid.Hope this helps,

Posted on Apr 21, 2009

  • George DeMore
    George DeMore Apr 21, 2009

    Definitly get the cables checked with an ohmmeter.I've had this problem and have seen it many times and its almost always a bad cable.Have a good day and glad I could help.

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Reversed the boost


you (at the least ) blew 1 or many fuses,
you do that and risk blowing up a fortune on electronics.
its not 60 Chev, that is so forgiving...

fuses: (ijm at alldata.com looking)
fuse 19, 80amps engine bay fuse box. bam?
are the head lights dead, they work all the time, even keys in pockets.
are they part of nothing.
then... that means... fuse 19 is bad.
open the fuse box in the engine bay see those.
they will all be dead, and 19 toast.
i just use a voltemeter to find which are blown.
starting there, then working to the cab box.
12v good
0v bad, key on

Feb 04, 2014 | 2004 Honda Civic

1 Answer

01 blazer security light on theft deterant code given truck will try to start then die. please help before i have to put another penny in it. Is it the passlock, bcm or what. there is no chip in my ke


check with code scanner to see if it is passlocked can barrow with deposit from auto zone the passlock will only turn off fuel with starting fluid it should run for a few sec.

Sep 19, 2012 | 2001 Chevrolet Blazer

1 Answer

No spark and no sound from pump


as you suggested crank position sensor cause such troubles, as hard starts and sometimes stalling. simply replace it.

Dec 05, 2011 | 2002 Chevrolet Blazer

1 Answer

Once my blazer gets up to 55 and runs a little while, i start to lose rpms and when i give it gas it does nothing unless i give a very little gas until it dies down to nothing. if i pull over and wait few...


Sounds like you are running out of gas. When was the last time you changed the fuel filter? PO 300 means there is a miss fire which can harm the catalytic converter. It could also be a ignition problem. Coil pickup. Without hands on diagnosis it is hard to exactly pin point the problem.

Aug 08, 2011 | 2001 Chevrolet Blazer

1 Answer

1995 s-10 blazer startin issues


it could be the starter relay..

Feb 01, 2009 | 1995 Chevrolet Blazer

1 Answer

Bypassing hood cable override system to get under my hood


Also helps to clean and oil the latching mechanism. On my Blazer (01) you'd pull the handle by the brake all the way back, hear a slight click up under the hood and nothing happened. Pound on the hood above the latch a few times and it'd pop open. I cleaned and oiled it... works fine now

Aug 04, 2008 | 1999 Chevrolet Blazer

6 Answers

Chevy blazer won't start


Well odds are that your blazer is fixed by now. Either way sounds like a bad battery, that's why you need jumps all the time. Why it would die, there are too many possibilties off hand. So what was wrong with it?

Jul 27, 2008 | 1999 Chevrolet Blazer

Not finding what you are looking for?
2002 Chevrolet Blazer Logo

80 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7726 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...