Question about 1993 Chevrolet Suburban

1 Answer

1993 suburban will not start

When we turn the ignition it acts as if it were in gear

Posted by on

  • its420_us May 11, 2010

    Will it start in neutral?

  • paconos2007
    paconos2007 May 11, 2010

    is it a straight drive..

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 202 Answers

Try putting the gear shift in to nuetral position and while holding the key to the start position and if it starts up your neutral safty switch is going out on you i hope this is helpfull for you. please rate my solution thank you

Posted on Apr 21, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1993 7 suburban doesn't start wants to but it doesn't start all the way and it makes a funny noise


Hard to say anything about the 'funny noise'.

The engine needs fuel, air, and spark to start and run. If any of these are lacking then it won't.

I would first remove a spark plug from each side of the engine to see what MAY be going on. If the spark plugs are wet with fuel, then I would lean towards it being an ignition problem.

If they are dry, then it could possibly be a fuel problem.

You could also remove the distributor cap to see if there is corrosion on the terminals of the cap and rotor.

I had to rescue a GM vehicle a few years ago that quit running going down the road. The engine acted like it wanted to start but just wouldn't. I did the above suggested checks and it turned out to be the distributor cap and rotor were both corroded to the point of not allowing the spark to get to the spark plug wires. New cap and rotor and it started right up and has been running ever since.

Hope this helps.

May 29, 2015 | 1993 Chevrolet Suburban

1 Answer

So my 1993 chevy suburban won't start battery is good and starter is good I got a new ignition switch I got the old one out and I'm having trouble getting the rod to fit in the new one need some help in...


On Blazers, when you turn the key, it pulls the rod up and down. It is by where the tilt is. This rod usually has a bend in it so when you put the new rod in, you have to jiggle it a lot.

Nov 17, 2014 | 1993 Chevrolet Suburban

1 Answer

1991 suburban starter not doing anything


check that you have the starter wire on the solenoid correctly
whne you say power to the starter --is that from the battery lead or the small control wires from the ignition switch

May 17, 2017 | 1991 Chevrolet Suburban

1 Answer

I have a 1993 gmc suburban 1500 in it dont start up at all dont make no nose when u turn the key.it use to act crazy like run great all day intel u turn it off then it wont start back up intel later u will...


Leave the starter alone, If you turn the key and it does not make noise then you are going to need a ignition switch, electrical part, the ignition switch the electrical part it is located on the steering colum under the dash. look under the dash along the steering column now turn the key as you cycle it do you see a rod moving? where that rod connects to is the" electrical ignition switch part" here I made a drawingcansmo_3.png

Apr 29, 2011 | GMC Suburban Cars & Trucks

1 Answer

I have a 92 chevy suburban and when i put it in gear it wants to go but then soon acts like its in neutral, in all gears. Has plenty of fluid. Then at times when i first start it up. put it in gear it wont...


Change trans fluid and filter. Sounds like filter is starting to clog up. Trans fluid & filter should be done every 30k. More often if you do alot of heavy towing

Feb 18, 2011 | 1992 Chevrolet Suburban

1 Answer

1993 suburban is not starting and it is not the battery. What could it be?


IF BATTERY CABLES OLD THEY WILL CAUSE POOR GROUND HIGH RESISTANCE IN STARTER CIRCUIT CAUSING STARTER NOT TO CRANK ENGINE.CHECK TO SEE IF DASH LIGHTS AND GAUGES WORK WHEN YOU TURN ON IGNITION SWITCH IF NO CHECK IGNITION FUSES.IF FUSES OKAY IGNITION SWITCH IS OPEN NEED REPLACING.NOW IF BATTERY VOLTAGE IS 12.6 VOLTS, BATTERY CABLES GOOD AND IGNITION SWITCH AND FUSE OKAY. STARTER SOLENOID OR STARTER FAULTY.REMOVE STARTER TAKE TO ANY AUTO PARTS STORE THEY WILL TEST STARTER.TURN OFF RADIO BEFORE REMOVING NEGATIVE BATTERY SO YOU WONT LOCK OUT RADIO.

Nov 02, 2010 | 1993 Chevrolet Suburban

1 Answer

1993 GMC 1500 suburban 350 engine will not start. Engine starter turns, ignition does not fire.


i have a 1993 suburban gmc 1500. when i put the key in an turn it nothing happen at all.befor the car stop running it use to act crazy like start up in run great but when u turn it off it dont start back up. u wll have to wait than it will start..can u tell me what that can be..

Sep 13, 2010 | 1993 GMC Sierra

1 Answer

1993 GMC Suburban. When truck gets to 25mph it won't shift gears and gets sluggish. I have to continously tap the accelerator to get to quit ''acting sluggish'' but it won't go over 50 mph. It's also...


Inspect your TPS (throttle position sensor) and the wire leads. If wire leads seam to be good, replace the TPS.
If your have a 700R4 transmission, check your TV cable and adjust accordingly. But i believe your Suburban has the 4L60E and is electronically controlled.
Thank you for using Fixya and good luck. Simple and easy fix.

Apr 20, 2010 | 1993 GMC Suburban

1 Answer

My 96 Suburban will not start. The truck turns over well. I have checked the battery, alternator, spark plugs, coil, replaced the fuel filter and the serpentine belt. It will start if I plug my battery...


If you have a 1996 Suburban that will not start. The first place I would start is take the screws out from the cover under the ignition switch and replace the box with all the wires. That box when bad will cause all kinds of things to happen...Truck not to start. Shifts darn hard from 1st to 2nd gear. Wipers to not work at time or the wipers stop and go. You will not get the impulses to even register on a tester. After hooking up to a computer I could not get anything to register on the tester/computer as I was turning over the motor with the ignition switch...Next I decided to turn over the motor with the ignition switch and wacked the bottom of the stiring column and the puter screen cam to life....Replaced the box and never had a problum in 4 years and my truck transmision dont slam gears any more.
Hope this helps.
Sincerly
Troy H
troylynxtn@yahoo.com

Mar 31, 2009 | 1996 GMC Suburban

Not finding what you are looking for?
1993 Chevrolet Suburban Logo

Related Topics:

113 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7688 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...