Question about 1996 Cadillac Fleetwood

1 Answer

We have a 1996 Cadillac Broughm, and today while driveing home the whole back end went high in the air, and the front end stayed down wards, when we turn the car off, it almost sounds like it running a motor??

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Cadillac Master
  • 6,982 Answers

Check that the arm that goes between the rear axle and the level control on the body has not come off or broken. You can pull the fuse temporarily to keep the pump from running so the battery does not go dead.

Posted on Apr 21, 2009

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

Went to start car last night an upon start up the service airbag came up on my 1999cadillac eldorado can I not drive my car

it is possible that by removing the battery cable that the CPU program has become corrupted . Try having the program reset using a scanner first

Jul 04, 2014 | 1999 Cadillac Eldorado

1 Answer

Engine surging up and down, hard to start, shutsdown when I remove my foot from the accelerator, sometimes stays at high 2000 rpm's while driving without using the accelerator

doug you do have some problems first thing is to ckeck your fuel pressure or it could be dirty or bad injectors or loose injector connections or a intake air leak or vacum lines or pressure regulator (fuel) it gonna be a process of elimnation hope this helps

Oct 28, 2011 | 1996 Cadillac DeVille

1 Answer

Car want stay crack.will fire up but want stay on thinking it may be ignition coil.year 2002 cadilac escalade all weel drive 6.0 engine.I did drive it to the store came back home then went to head back out...

I would check your fuel system first, like the fuel filter and then the fuel pump. it 7 years old and if you have had dirty fuel......... was it ok before going to the store?

Dec 18, 2009 | 2002 Cadillac Escalade

2 Answers

I have a 1996 Dodge Ram 1500 quad cab 4x4. I have been in Iraq for 15 months, and now that I'm back I went out to test the truck out. when trying to switch into 4 high, nothing happens, no "jump",...

Most likly cause to your problem would be the transfer case vacume switch check for vacume at switch then check for vacume at the front differntal if you have vacume at switch but none at the front differntal then replace transfer case vacume switch if no vacume at switch look for broken vacume line at intake manifold

Sep 17, 2009 | 1996 Dodge Ram 1500 Club Cab

1 Answer

The transmission on my 1996 Ford explorer has intermittnly not shifting into the next hiher gear. Sounds like it is revving upp but no increase in speed. When i let off the gas it shifts. Yesterday I...

Sounds like the the black rubber line and plug you found up front is the breather tube for the front differential the plug for the rear end should be on the drivers side of the vehicle like if you crawl under it right in front of the rear tire the plug is on the front side of your rear end it should take a 3/8 ratchet to take the plug out.The tranny issue could be needing to change the vacuum modulator and a tranny filter,fluid change.

Aug 07, 2009 | 1996 Ford Explorer

4 Answers

Forgot toi turn the air suspension off when

Remove battery, remove windshield washer bottle, remove air compressor and disconnect both air lines from the compressor dryer. Make sure compressor electrical wiring is plugged in, install battery, turn suspension switch to ON, turn ignition switch to the ON position, close all door and the compressor should come on and completely lower the whole truck. Once the truck is completely down, turn the ignition OFF, remove battery and connect both air lines. Install battery ensure electrical wiring is plugged in, turn ignition switch to ON, the compressor should come on and raise the vehicle to the correct ride height.

Jun 14, 2009 | 2001 Lincoln Navigator

1 Answer

1996 Honda Civic--car broke down about 10 minutes into driving it

there is only 2 things that can make a trans slip.. low on fluid, which i asume is now at the correct level.. or a blown clutch pack inside the trans itself. which will require the trans to come out to be overhauled,, sorry

Mar 29, 2009 | 1996 Honda Civic

1 Answer

Clunking/vibration/squeling noise under the front end

sounds like u need front brake pads and rotors i would check brakes first if ok then i would check front wheel bearings but cv joints make a clicking sound usauly when turning

Mar 29, 2009 | 1997 Chevrolet Cavalier

1 Answer

Air Conditioning system 97 deville

Look for a high side pressure sensor. It sounds like something is tripping an A/C code.

Mar 11, 2009 | 1996 Cadillac DeVille

Not finding what you are looking for?
1996 Cadillac Fleetwood Logo

Related Topics:

135 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts


Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8140 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides