Question about 1984 Volkswagen Rabbit

1 Answer

1984 Volkswagen is surging

I have a 1984 Rabbit, 1.8 L engine, when driving on the road at highway speed, the motor will surge, when depressing the gas, it feels as if there is nothing there. It will stall out, however, it will restart.

Please help.

Posted by on

  • yadayada
    yadayada May 11, 2010

    low fuel pressure maybe? what is the reading?

×

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 8 Answers

Check all your vaccum lines could be one or more may be cracked

Posted on Sep 30, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 1984 Rabbit Convertible runs great, but has a surge in idling and after driving for a short while when going to stop, stalls out?


you are right it is a air leak but either at the intake gasket or tb gasket seeing you replaced the hoses already. spray some carb cleaner around those areas while running and see if idle changes this will pin point the area of trouble. make sure you dont have any spark plug wires arcing out cause this could ignite the carb cleaner.

Dec 15, 2014 | 1984 Volkswagen Rabbit

1 Answer

Car surging


Is the car equipped with the Automatic Transmission?
If so, read on.
Otherwise skip to the end and answer some questions.

POSSIBLE SCENARIO:
I have observed a condition where my car surges slightly when the torque-converter clutch (TCC) cycles between lock and unlock when driving on an uphill grade.
First some basics and history that will explain why the TCC is used.

Engine, Torque Converter, TCC, and Transmission relationship--
The TCC allows for a solid connection between the engine and transmission which allows the input to the transmission to rotate at the same speed as the engine.
Without a TCC, there is slippage between the engine and automatic transmission. The slippage is greatest at low engine RPM. That is what allows the engine to run with the automatic transmission in gear, like when you first shift into gear or stop at a stop sign. When the throttle pedal is depressed, the engine RPM begins to increase and the torque converter begins to slip less and less the more the engine RPM increases. The car moves. But even at cruising speeds the torque converter slips slightly. Engine RPM is greater than transmission input RPM, which is realized as slight decrease in fuel efficiency.
When acceleration is complete and a constant speed is being maintained, the engine power output is reduced to the point where the TCC can engage and eliminate any slippage between the engine and transmission. If the car has a tachometer the engagement of the TCC can be verified when a slight reduction in engine RPM observed without a corresponding change in vehicle speed.
One method used to test the operation of the TCC is as follows:
Find a flat section of road where it is safe to perform the test.
Reach a steady speed and keep the gas pedal depressed with one foot. While observing the tachometer (or listening for an increase in engine RPM), with the other foot depress the brake pedal enough to activate the break light switch but not enough to engage the brakes. When the brake light switch activates, the TCC receives a signal to disengage. With the gas pedal being held steady, release the brake pedal and the engine RPM should decrease when the TCC engages.
Old cars with Automatic Transmissions did not use a TCC. I believe the TCC was put in use in an attempt to increase fuel economy.

MY EXPERIENCE WITH SIMILAR SYMPTOMS
The condition that causes that issue on my car is this:
- A slight uphill grade increases the load on the engine.
The car tends to gradually slow and it is necessary to depress the gas pedal to maintain speed.
- Depressing the throttle pedal (manually, or automatically with cruise control engaged) signals the torque converter clutch to unlock when the load increases slightly. (A more drastic load increase would signal the Transmission to downshift to a lower gear.) The corresponding increase in engine RPM and output is enough to compensate for the reduction in speed. When the vehicle speed, engine RPM, and throttle position stabilize to the point that the TCC will engage and the engine RPM will reduce in correspondence with TCC engagement. Now, if the road conditions have not changed, power output is not enough to maintain vehicle speed. With the increased load caused by full engagement between engine and transmission, and the cycle (surging) repeats itself until the road conditions change.

Does that help?
If not:

QUESTIONS
Please define the symptoms.
What are the road conditions when the surge occurs? (A slight uphill grade?)
What is the frequency of the surge?
Does the engine power output have a noticeable surge?
Is there a speed change related to the surge?
Does the tachometer move up and down with little or no change in vehicle speed?
Are all instrument indication in the normal range?
What else has changed?

Good luck!

May 24, 2014 | Subaru Impreza WRX STi Cars & Trucks

1 Answer

1980 Rabbit Pickup. Engine surges at all speeds.


1980??? didnt have any sensors ,distributor cap points and carb ,zenith carb as i remember and bosch points and distributor

Jun 27, 2009 | Volkswagen Rabbit Cars & Trucks

1 Answer

1995 toyota pickup, surging at around 2000 rpms


Is the check engine light on?

A major cause of surging is either air leaks between the air flow meter and the engine intake manifold, or a bad or mis-adjusted throttle position sensor.

Feb 24, 2009 | 1995 Toyota Pickup

1 Answer

No low speed heater fan, only high speed works


BLOWER MOTOR RESISTOR IS BAD . HI SPEED IS DIRECT POWER BUT ALL OTHERS GO THROUGH RESISTOR

Jan 21, 2009 | 1984 Volkswagen Rabbit

1 Answer

Power surges at highway speeds


it possibly is a faulty throttle poisition sensor

Dec 07, 2008 | 1994 Ford Explorer Limited

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

166 people viewed this question

Ask a Question

Usually answered in minutes!

Top Volkswagen Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

yadayada
yadayada

Level 3 Expert

75197 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7782 Answers

Are you a Volkswagen Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...