Question about 1990 Acura Integra Hatchback

2 Answers

Sumbody help please. I got a 90 Acura Integra. the car recently

Started while warmed up, the tack drops to zero and i lose power, then i get the power back, and the it drops to zero again. Eventually the engine shuts down and i have to pull over. One the car cools down it will start up and i can drive it again. Then it warms up and does it again. It has been getting progressively worse over the last few days. someone took the coverter off and cleaned it all out and that didn't work. Any suggestions. other than the distributor that was replaced last august? Thanks

Posted by on

  • 1 more comment 
  • bree420 Apr 20, 2009

    they did the fuel pressure test. it was okay. ...

  • Mike Butler
    Mike Butler May 11, 2010

    I'd be real tempted to get my fuel pressure checked especially after warmed up & dying. When it does die, have you tried spraying WD-40 into front of throttle body, with plate open & with air intake hose off? Give it a good shot of 2 or 3 seconds, then try to start. If it starts runs a second or so then dies, I'd be looking at fuel pump problem. (that's why I suggested fuel pressure test.)

  • pdshoto May 11, 2010

    hondas are notorious for distributor faults,,it could be worth changing again.........make sure its timed properly 2,,,,,,

×

2 Answers

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

Same thing happen to my car, it was the distributor. FIRST CHECK YOUR PLUG WIRES TO YOUR DISTRIBUTOR BECAUSE ONE OF MY FACTORY WIRE DOES NOT HAVE A GOOD FIT. THE LACK OF CONNECTION BURNED OUT THE METAL CONNECTOR IN THE WIRE. I REPLACE WITH PERFORMANCE PLUG WIRES.

Posted on May 15, 2009

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 232 Answers

I would look towards you ignition system,as the tach,distributor and ignition coil are all tied together,have the coil and the ignition module checked first.Hope this helps

Posted on Apr 20, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 92 Acura Integra is not starting could it be my transmission fluid level


Search Results

    "No start" Due to Failed Fuel Pump Relay : Acura Integra ...

    repairpal.com > Problems > Acura > Integra
    where is the fuel system relay located at?I have replaced the distributer 2 times and also the... 1992 Acura Integra. fuel pump???? The car does not start unless I ...

    92 Integra wont start! Very weirdo problemo... - Honda-Tech

    honda-tech.com/acura-integra.../92-integra-wont-start-very-weirdo-probl...
    Jun 13, 2012 - Re: 92 Integra wont start! Very weirdo problemo ..... 91 Integra LS Defroster/Water Leaking, Bigmo5328, Acura Integra, 8, 01-30-2014 12:14 PM.

    92 DA9 WILL NOT START!!! - Team Integra Forums - Team Integra

    www.team-integra.net > ... > Generation Specific > Generation Two

    Apr 5, 2010 - 11 posts - ‎9 authors
    I just bought a 92 integra with the B18A1. The guy I ... Team-Integra.net is the premierAcura Integra Forum on the internet. ... But it still won't start and I don't know what is up. .... Engine will not rotate when attempting to start 98 gsr cranks but won't start. - Team Integra Forums ...
    10 posts
    Feb 9, 2012
    1992 Acura Integra NO SPARK! - Team Integra Forums ...
    15 posts
    Feb 5, 2012
    92 integra wont start after driving - Team Integra ...
    15 posts
    Oct 17, 2010
    Car wont start! has fuel but lil spark..? - Team Integra ...
    15 posts
    Dec 1, 2008
    More results from www.team-integra.net

    My '92 Integra cranks but does not s

Jan 21, 2016 | Acura Cars & Trucks

1 Answer

A/C turn on full blast and the engine starts to lose power then shuts down on a 95 acura integra ls automatic?


Possibly a charging problem. Hook a battery tester to it and run it. See if you're getting 14 amps and see what happens when you turn on the AC.

Apr 04, 2013 | 1995 Acura Integra Coupe

1 Answer

Car won't start right away.


The clicking is the solenoid in your starter, you need to check your battery terminals, then check your starting voltage with a multi meter on DC volts, put the leads on your battery terminals if your battery voltage is dropping below 11 volts you need to get a new battery.... you need to check the connections to your starter....

May 01, 2010 | 2000 Acura Integra

1 Answer

Changed fuel pump, now no power please help 92 ACura Integra


maybe its in the battery.. try to recharge it again

Oct 25, 2009 | Acura Integra Cars & Trucks

2 Answers

98 acura integra.....not getting spark to coils.....need help....car shut off on me while driving....will not start back up.....engine cranks but wont start....


is there power at the coil's electrical connector(key must be set to ON? Is some of your warning lights not lit(that normally light-up when key is on) such as airbag, abs, engine, battery etc??? If you answer yes to any of this, your ignition switch has failed. Acura/Honda models 97-02 have a recall on this in 2002 approx 1.5million vehicles affected. Symtoms include, intermitted speedometer/tach fluctuating to zero while car is in motion, intermitted stalling or no start(symtoms increase in hotter weather). The electrical contacts on these ignition switches are faulty causing shorts and archs within. Therefore power supply to vital engine electrical components are cut off. If this is the case, call your local Acura/Honda dealer with your vin# at hand, your vehicle may qualify for a free repair. Hopefully this helps....please rate thanks!!

Aug 18, 2009 | 1994 Acura Integra

1 Answer

NEW ALTERNATOR, NEW BATTERY, CAR still dies and wont start


Check the main power fuse that goes to the alternator output. if the alternator went out it could have burnt this fuse also.

Jun 26, 2009 | 1990 Acura Integra Hatchback

2 Answers

Car not starting when it gets to hot outside?


check your FUEL relay. under the steering wheel. In mine the soldering cracked and as soon as the metal expands from the heat it looses contact. Cost $70 Good Luck :)

Apr 23, 2009 | 1994 Acura Integra

1 Answer

1990 Acura Integra Vin codes


The vehicle grade is denoted in the 6th digit, in your case "4" indicates an RS model.

Oct 19, 2008 | 1990 Acura Integra Hatchback

Not finding what you are looking for?
1990 Acura Integra Hatchback Logo

Related Topics:

173 people viewed this question

Ask a Question

Usually answered in minutes!

Top Acura Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7710 Answers

Are you an Acura Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...