Question about 1997 Honda Odyssey

1 Answer

Need to replace radiator in 1997 honda accord se. what are the steps?

What steps are necessary to replace radiator in 1997 honda accord se

Posted by on

  • 5 more comments 
  • Anonymous Apr 20, 2009

    replace radiator in 1997 honda accord se. what are the steps?

  • Anonymous Mar 16, 2014

    1997 honda accord, windshield won;t defog

  • Anonymous Mar 26, 2014

    Where is cam sensor on 1997 honda accord

  • Anonymous Mar 31, 2014

    i need a diagraham of fuse box

  • Anonymous Mar 31, 2014

    1997 fuse box diadraham

  • Anonymous Apr 01, 2014

    I need a picture of 1997 honda accord fuse box

  • Anonymous Apr 01, 2014

    i need a fuse panel picure

×

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

  • Expert
  • 126 Answers

First drain radiator by opening drain valve,"located on bottom corner usualy the right,but not always." If you open the overflow or remove cap this will happen much faster.For safety sake disconnect ground wire from battery,the radiator is locked down by top cover that attaches to body with generaly 4 bolts, upper and lower hoses have to be disconnected and if it is automatic the transmission cooling lines are connected in stacked fashion,"one above the other."The cooling fan has to be unplugged and it should be removable at this point,"when unplugging fan be carefull with connector so it doesn't break.reverse steps to replace making sure the bolts go in the right place and it all fits properly.the thermostat,"located behind the kneck of upper hose," should be replaced after connecting lower hose because in order to fill the block up and prevent damaging thermostat the block shoud be filled with coolant before attaching upper hose.

Posted on Apr 20, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have just bought a 1997 Honda Accord SE. I was not given a key fob from factory installed keyless entry. Where can I pick one up which I can just manually program myself that won't be too expensive?


Best bet is ebay I've bought a fob from eBay for my honda in the past. You may have to call a dealership top figure out what fob number you need not all fobs will work for every honda

Apr 27, 2015 | 1997 Honda Accord SE

1 Answer

The fans on my 1997 Honda accord will not come on


have you hooked power and ground to the fan to see if its working?

Sep 28, 2014 | 1997 Honda Accord

1 Answer

1997 honda accord se need to change vss,where


For 1997 Honda Accord 2.2L MFI 4cyl the Vehicle Speed Sensor - Location is located mounted on transmission.

OPERATION
The Vehicle Speed Sensor (VSS) is a magnetic pick-up sensor that sends a signal to the Powertrain Control Module (PCM) and the speedometer. The sensor measures the rotation of the output shaft on the transaxle and sends an AC voltage signal to the PCM that determines the corresponding vehicle speed.



TESTING
  1. Disconnect the negative battery cable.
  2. Disengage the wiring harness connector from the VSS.
  3. Using a Digital Volt-Ohmmeter (DVOM), measure the resistance (ohmmeter function) between the sensor terminals. If the resistance is 190-250 ohms, the sensor is okay.
REMOVAL & INSTALLATION
  1. Disconnect the negative battery cable.
  2. Disconnect the three terminal connector from the vehicle speed sensor (VSS).
  3. Remove the fasteners that secure the VSS to the transaxle housing assembly.
  4. Remove the VSS.
To install:
  1. Install the VSS.
  2. Install the mounting bolts.
  3. Connect the three terminal connector to the sensor.
  4. Connect the negative battery cable.
Hope helps (remember rated this).

Jul 16, 2010 | 1997 Honda Accord

1 Answer

Where is the thermostat located on a 1997 honda accord se


Follow the lower radiator hose up to where it meets the engine. That is the thermostat housing. Remove it and you will find the thermostat. Make sure you get a NEW gasket too. Clean all around where the old thermostat was so it will seal.

Jun 16, 2010 | 1997 Honda Accord

1 Answer

New starter in 1997 honda accord. Bolt closest to


is it in the starter or the trans? In the starter, replace the starter. In the trans, you may need to have someone repair the threads with helicoil, or you can put some locktight on the bolt, get it fairly tight, and it should set up.

Jul 03, 2009 | 1997 Honda Accord

1 Answer

Need to know where the thermostat is


Make sure the engine is cool before you remove any part of the coolant system. On most vehicles just follow your top hose from the radiator to the engine block. There will be two bolts holding on the thermostat housing remove these and clean the area good. Use a silicone based water proof / gasket sealant replace and your done.

Apr 28, 2009 | 1997 Honda Accord

1 Answer

Radiator support


stop by a place that does radiators and I am sure they will sell you radiator supports and try www.autozone.com to see if they have your car listed for diagrams pictures and step by step instructions if your car is not listed then try your local library they have all the car manuals and even copy them for you

Mar 20, 2009 | 1997 Honda Civic

1 Answer

REPLACING HEADLIGHT IN 1997 HONDA ACCORD SE


The back part of the light bulb holder (under the hood) comes apart by rotating countercloskwise. It is hard to access.

Dec 24, 2008 | 1997 Honda Accord

1 Answer

97' accord, stalled on wife while driving? 5 min. later it started and stalled on it's own again. cranked it once more and she drove it home. now a couple of days later the car runs fine but the check


Your best investment is a Haynes Repair Manual, either from your local Auto Zone or similiar retailer or online: http://www.haynes.com/products/searchType/vehicleApplicationSearch2/searchEnd/yes/sfID1//sfID2//sfID3//year/1997/make/Honda/model/Accord/x/20/y/3/productID/193. Step by step instructions on troubleshooting, repair or replacement, based on a complete teardown and rebuild.

Jul 09, 2008 | 1997 Honda Accord

Not finding what you are looking for?
1997 Honda Odyssey Logo

2,018 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7711 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...