Question about 2002 Dodge Dakota Club Cab

Open Question

How to replace passenger side headlight bulb 2002 dodge dakota?

Is it as simple as squeezing my hand behind the assembly to replace only the bulb? or do I have to remove bolts with a wrench? Do I leave the angle adjustment screw (Hex/Allen wrench) alone? or will it help to loosen or remove that?

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 26 Answers

SOURCE: 95 Deville rear caliper bolts.

THE UPPER IS NOT A BOLT ITS A SLIDE PRY THE CALIPER UP OFF THE PADS AND THEN PULL IT OUT MAY BE RUSTY BUT IT WILL COME OUT

Posted on Nov 05, 2008

  • 16 Answers

SOURCE: brake job/2000 dodge dakota

Last one I did took a 7mm.

Posted on Nov 22, 2008

  • 3 Answers

SOURCE: front hub bearing removal 2002 dodge ram 1500 4WD 4.7L V8

i just did a 2002 2500 4x4 with a dana straight axle and had no problem getting on the bolts with a 9/16 12 point socket on a 6 inch extension. If you do not use an extension the head of the ratchet will hit the yoke of the axle shaft.

Posted on Feb 18, 2009

  • 6 Answers

SOURCE: changing headlight on 2005 dodge stratus

when your prying on the clips move the headlight around and it poops right out

Posted on Dec 07, 2009

  • 593 Answers

SOURCE: Remove headlight assembly from a 2001 Dodge Ram

On the upper grill side of the headlight assy. there
should be 1 or 2 push pins that hold the seal on the
headlight assy to the front of the fender. Also check
for a guide/push pin on the inner top of the assy on
the outer fender side. That should be all there is to
hold the headlight in place. Hope this helps.

Posted on Apr 10, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Need to replace turn signal parking light assembly as it was hit and lens are broken, how do I do this


open the hood you will see a rubber type gaskets that attaches to the top of the fender and it goes along the side of the headlight and parking lights assembly remove it , then there is a very small torx head screw located under the headlight assembly remove it once it is loose pull the parking light assembly out towards you ,but be careful cause the bulb pig tail are located behind the assembly . your going to have to maneuver it around to fully remove it . disconnect the light sockets and your done. repeat process backward to reinstall. hope this helps.

Feb 27, 2014 | 2004 Dodge Dakota

1 Answer

Changing passenger side low beam headlight bulb for 2001 Buick LeSabre Custom


there is very little room to gain access to the bulb from behind the headlight assembly.if you remove the plug for the headlight and then slide your hands down on either side of the bulb.there is a lock ring that you must remove(unlock)first.then pull the bulb out and install the new bulb and reassemble in reverse order.NOTE don`t touch the bulb glass with your hands or it can burn out prematurely from the oil on your skin.

Mar 15, 2011 | 2002 Buick LeSabre

1 Answer

2008 buick lecerne headlight replacement bulbs can't remove assembly


Buick says that the front bumper has to be removed in order to remove the headlight assembly. Crazy, I know.. I found that you can remove the air filter box on the drivers side and squeeze your hand in a small hole to replace that bulb. The passanger side is nearly impossible. You can remove to nuts holding the fuse block in place and move it over a little and squeeze your hand in a little hole and reach it. Plan on two to three hours to change one bulb.

Dec 06, 2009 | 2008 Buick Lucerne

2 Answers

How do i change the left headlight on a 2002 dodge stratus


You should have two long star-patterned screws that run through the brackets of it......unscrew thoss and the headlight assembly should pop out and then you can change the bulb or the headlight assembly at that time.

Jun 25, 2009 | 2002 Dodge Stratus

1 Answer

Should be simple pass. side headlight bulb replacement.


JUST REMOVE THE AIR BOX INTAKE TUBE . THE BULB REMOVES FROM THE BACK OF THE LIGHT ASSY. .

Mar 14, 2009 | 2001 Dodge Dakota

2 Answers

How do I replace the headlight bulbs in my 2002 Mazda 626


if the lens covers are yellow or discolored you would have to remove the lens and they have chemical at autozone or napa that can take care of this problem but to replace the bulb you open the hood and put your hand in behind the headlight assembly and there is a plug you normally turn counter clockwise and the bulb comes out always wipe the bulb off if you touch it with your hand because the sweat from your hand will cut the life of the bulbs

Jan 18, 2009 | 2002 Mazda 626

1 Answer

2003 Mercury Sable headlight bulb replacement


This problem is now resolved, thanks to a prior post by sableowner.

http://www.fixya.com/cars/t1479995-2001_merc_sable_headlight_replacement

The 2003 Sable has the same headlight assembly and removal/replacement instructions as the 2001 Sable. Once I had this information in hand, bulb replacement was easy.

Jan 10, 2009 | 2003 Mercury Sable

2 Answers

Need to put on a new horn


it is behind the passenger side headlight assembly. you will have to remove the headlight assembly to replace it. I hope this helps.

Dec 05, 2008 | 2002 Dodge Neon

Not finding what you are looking for?
2002 Dodge Dakota Club Cab Logo

Related Topics:

353 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...