Question about 2004 Lincoln Navigator
Put air in the tiers and suspension went down
That should not happen. Did you turn the switch off in the back for the suspension? Did you do something else at the same time, like check the spare tire for air pressure?
I have info on 2003 navigator 4 wheel air suspension. Maybe similar
SECTION 204-05: Vehicle Dynamic Suspension — 4-Wheel 2003 Expedition/Navigator Workshop Manual
DESCRIPTION AND OPERATION Vehicle Dynamic Suspension The four wheel air suspension system is comprised of the following components:
WARNING: Do not remove an air spring under any circumstances when there is pressure in the air spring. Do not remove any components supporting an air spring without either exhausting the air or providing support for the air spring to prevent vehicle damage or personal injury.
Air Suspension Pneumatic Diagram
Item Part Number Description 1 5319 Air compressor and drier 2 5B322 Air line T-fitting 3 5B321 Air line union 4 — Air line Y-fitting 5 18945/5311 Air spring and solenoid
Principles of Operation
The 4-wheel air suspension (4WAS) module commands changes in vehicle height that are necessary for both the load leveling and the vertical height adjustment features.
The 4WAS load leveling feature automatically makes adjustments in vehicle height so that the vehicle is always at trim height, and that constant front-to-rear vehicle attitudes are maintained over the load range of the vehicle. Adjustments in height that are necessary to correct height differences between the vehicle left and right sides for the 4WAS system are restricted to what can be reliably achieved with three height sensors.
The height adjustment feature has three vehicle heights within a two-inch span:
Kneel height — improves the ease of entering and exiting by lowering the vehicle one inch below the trim height in the front and rear when the vehicle ignition is in the OFF or LOCK positions and the vehicle is stationary.
Trim height — normal vehicle ride position; vehicle moves to trim position when the ignition is ON, when the transmission is initially shifted to DRIVE or REVERSE mode, when all doors are closed or when speed of more than 24 km/h (15 mph) is detected.
Off-road height — improves ground clearance by raising the vehicle one inch above trim height in the front and rear when the vehicle is at 4x4 low modes and the vehicle speed is less than 40 km/h (25 mph).
The 4WAS module uses the universal bus protocol, (UBP), module communications network for sending and receiving various signals with the exception of speed, information from the three height sensors, and the air suspension service switch. For additional information about UBP, refer to Section 418-00 .
The 4WAS system holds vehicle height when any door or rear hatch is opened. The system stores front and rear vehicle height the moment any door is detected open. The system then maintains this height regardless of the addition or removal of a load. The system returns to its commanded height when all doors are closed or vehicle speed exceeds 24 km/h (15 mph).
Air Suspension Service Switch
The air suspension service switch signal is needed to wake up the 4WAS module. Without the module receiving this signal, the 4WAS system is inoperative at speeds below 24 km/h (15 mph) and will not react when the vehicle is raised or lowered. At speeds above 24 km/h (15 mph), the system will be active as if the air suspension service switch is in the ON position.
Vehicles without message center When the air suspension service switch is in the OFF position and the ignition switch is in the RUN position, a "CHECK SUSP" will appear in the RH corner of the instrument cluster.
Vehicles with message center When the air suspension service switch is in the OFF position and the ignition switch is in the RUN position, the message center will display "SUSPENSION SWITCHED OFF"
Inspection and Verification
Visually inspect for obvious signs of mechanical and electrical damage.
Visual Inspection Chart Mechanical Electrical
I fthis does not help, the dealer can hook up his diagnostic equipment and download fault codes. Good luck. Please give best rating if this helps.
Posted on Apr 20, 2009
It sounds to me like your airbags got holes in them and the compressor possibly died. I got a conversion kit for my Nav from strutmasters.com about 3 years ago and I havent had any problems with my suspension since. Hope this was of some help.
Posted on Jun 10, 2009
I agree with going to strutmasters or someone like that. I just replaced my air suspension system all the way around (front and rear) for $300. Each of those rediculous bags is $187. It took about a half hour each. If the bags have any air in them, drill a hole in them first. Also, it is essential to take off the tie rod in the front (this is easy, one bolt) After it drops down there is plenty of room. In the rear, drop the stabilizer arm...also one bolt and easy. Truck rides great now!
Posted on Mar 07, 2015
Why is my 2004 navigator 4x4 ride is boucey at level airbag ht
Posted on Sep 19, 2010
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
I would recommend going to strutmasters.com and taking a look at our conversion kits. these convert you from the airbag to a powder coated American made steel coil spring that is guaranteed to last the life of the car. Airbags and compressors are constantly having to be replaced. Also something alot of people don't know is that theses air suspensions are not meant to be in temperatures above 90 Degrees or below 40 Degrees. That is most of the world. The temperature will cause you to replace alot of bags. and typically when your replacing a bag you are going to have to replace the compressor to because the bag had a hole or small crack in it causing the compressor to over work and it will die. I posted the link below so you can take a look http://www.strutmasters.com/lincoln-suspension-parts-s/1.htm I hope I was of some help Good Luck!!!
Posted on May 06, 2009
could be faulty compressor which pumps up the suspension,is it leaking from anywhere,causing the pump to work too hard,has it just packed up,check fuses but probably compressor
Posted on Oct 26, 2009
Tips for a great answer:
May 01, 2016 | 2008 Lincoln Navigator 4x4
Dec 25, 2015 | Lincoln Cars & Trucks
Oct 16, 2011 | 2004 Lincoln Navigator
May 29, 2011 | 1999 Lincoln Navigator
Sep 21, 2010 | 2004 Lincoln Navigator
Mar 28, 2010 | 2003 Lincoln Navigator
Nov 07, 2009 | 2004 Lincoln Navigator
May 10, 2009 | 1998 Lincoln Town Car
Aug 11, 2016 | 2004 Lincoln Navigator
23,436 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: