Question about 2003 Lincoln Navigator

1 Answer

Can't remove the plastic cover on the fuse box by pulling on the tab at the bottom.

Posted by on

  • Anonymous Apr 25, 2009

    get a screw driver, pry off the top of the box with a screw driver, then pull from the bottom, not much force required



1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.

  • Expert
  • 235 Answers

I have had a few of these that gave me trouble . release the tab and pull really really hard it will pop off but it takes a lot of force

Posted on Apr 20, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

How do you remove the alternator fuse in a 1997 Toyota 4Runner? The 100A fuse is blown and I can't figure out how to get the old one out to replace it.

Hello, the fuse is bolted in on the inside of the fuse box, there are two ways to try to do this, remove the fuse box, turn it over and remove the bottom cover, remove some of the electrical plugs that are connected, you should be able to see the heavy white and black wires that are attached to the fuse, then remove the bolts and pull the wires away from the fuse , pull the fuse up,.
The other way is to try to pull the sub fuse holder up, there is a separate plastic holder where the fuse is, look for some small plastic tabs that can be depressed and the fuse holder can be pulle up far enough to get to the bolts,

Mar 02, 2018 | Toyota Cars & Trucks

1 Answer

How do I remove the fuse cover? There are slots at top and bottom of fuse box---should I use a flat screwdriver to insert into the slots to release the tabs?

Using a flat screw driver in the slot and then pulling on the top tab will work or just pull on the very top. There is a top outside tab that if you pull it will open.,

Feb 28, 2015 | 1994 Ford Escort

1 Answer

I need to find my 40amp fuse for my auxiliary fan for 1995 325i

On the '95 the fuse box is under the hood, back of engine compartment, back far rt. (looking from the front of the car) corner. There is a black plastic cover with three plastic tabs (if I remember correctly) you pull out gently to remove the cover.

Feb 23, 2013 | Cars & Trucks

1 Answer

How to change cabin filter 2011 Lacrosse

I just changed mine yesterday and these tips listed above were unfortunately incorrect.

Step 1 - Open the passenger door
There is a panel that has no screws on the flatside of the dashboard which faces against the closed door at the jam side. Use a body tool and pry the panel carefully exposing the inside area of the glovebox. If possible dont do this in cold weather because the tabs are plastic. Inside the panel you will see one small tab that the glove box has a 1/4 plastic clip seated in the tab.

Step 2 - Open the glove box. Remove the 3 hex screws on the top interior row of the glove box.

Step 3 - At the right and left corners of the bottom of the glove box remove the two front facing screws on the lower hinge.

Step 4- At the very bottom parallel to the floor there are two more hex screws remove those (they hold the plastic vent in place underneath the glove box. Pull the vent downward to release the tabs.
IMPORTANT: Dont forget to go back to step 1 and pull the small tab from the slot in the dashboard cover area ( Inside the panel you will see one small tab that the glove box has a 1/4 plastic clip seated in the tab)

Step 5 - Pull down on the glove box to release the clips.

Step 6 - You will see a black box inside. There are three tabs (right, top, and left) pull them individually to remove the front facing cover. Inside you will see the air filter. Remove and have airflow arrow pointed downward.

Reverse steps to reinstall. Be sure to line up the clips before pressing them back in place. Do not force them!

Good luck. I hope this helps. I did mine on the first attempt with no issues in about 10 minutes (I'm not a mechanic).

Aug 26, 2012 | Buick LaCrosse Cars & Trucks

1 Answer

Looking for my fuse box in my car. trying to find the one connected with my stereo as my stereo isent working i think i might need a new fuse, and i need the number so i dont have to pull out every one!

The fuse panel is located on the right-hand side of the center console, by the instrument panel. Remove the panel cover to access the fuse cover. Press the tabs on the top and bottom of the fuse cover to remove.


Mar 06, 2011 | 2008 Ford Escape

1 Answer

Where is the fuse box located?

Passenger compartment fuse panel / power distribution box

The fuse panel is located under the right-hand side of the instrument

panel. Remove the trim panel and fuse box cover to access the fuses.

To remove the fuse box cover, place

a finger behind the PULL tab and

your thumb above the PULL tab as

shown in the illustration, then pull

the cover off.

To reinstall the fuse box cover, place the top part of the cover on the

fuse panel, then push the bottom part of the cover until you hear it click
shut. Gently pull on the cover to make sure it is seated properly

here is a link to Ford site, u can download the onwers manual there it is free. The above info was copied from the owners manual.

Oct 19, 2010 | 2004 Ford F150

1 Answer

Change cabin airfilter 2006 Murano

takes about 10 minutes tops and no tools are needed. Slide 2 plastic hinge pins out from bottom of glove box door, pivot the door aside, pop the 3 plastic hook tabs off the bottom of the (white plastic) filter cover, pull the old filter out, and (carefully) slide the new filter in. Replace the filter cover and glove box door hinge pins and you are done.

Arrows should face down.

Sep 07, 2010 | 2006 Nissan Murano

1 Answer

Where is the master computer located

The computer (or PCM) is just below the glove box.There is a panel with just two small screws that cover the area from bottom of glove box door and goes to back of fire wall.(if sitting in passanger seat your your feet would kick this pannel if you just lifted them. Anyway the panel is black,remove the two screws and drop panel down and just leave it in place, The ECU comes out real lly easily (no mounting screws.) there are three large plugs (color coded) blue,red, and white. There are plastic locking tabs on each plug, just pinch the front and back the tabs and pull down on each. The only thing that holds the PCM are two white plastic tabs, one on each side of the PCM. Pull toward you while pushing out on tabs and the PCM just pull down and out. But before removing PCM make sure to disconnect battery or pull the large 20 fuse for the PCM.

I hope this helps! :)

Feb 20, 2010 | 1996 Oldsmobile Aurora

1 Answer

2006 expedition power outlet not working

The fuse u want is:
FUSE #39 20 AMP (FUSE COLOR YELLOW) Console power points (front and
rear of console)

The fuse panel is located under the right-hand side of the instrument
To remove the trim panel for access
to the fuse box, pull the panel
toward you and swing it out away
from the side and remove it. To
reinstall it, line up the tabs with the
grooves on the panel, then push it
To remove the fuse box cover, place
a finger behind the PULL tab and
your thumb above the PULL tab as
shown in the illustration, then pull
the cover off.

Apr 03, 2009 | 2006 Ford Expedition

1 Answer

Power outlets dont work

I just purchased a 2002 Envoy and had the same problem. If you raise the drivers's side rear seat, you will see a big black box. Remove this box by pulling the bottom of the box outward and it will come straight up. Next you will see a black cover. This cover has a push tab on each end. Push
the tabs at the same time and lift up on the cover and it can be removed. Inside the cover there is a fuse diagram. The fuse number for my 2002 was #46. This fuse controls the front plugs and #15 controls the back plugs. Locate the the fuse puller on the top left, then count over to spare fuse #3. Between #3 and #4 the fuse is located about 1 1/2 inches below those fuses. You will see a yellow 20 amp pin fuse (BP/ATM-20RP AUTOZONE). remove and check fuse.

Good luck


Dec 28, 2008 | 2004 GMC Envoy

Not finding what you are looking for?
2003 Lincoln Navigator Logo

Related Topics:

187 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lincoln Experts


Level 3 Expert

80407 Answers


Level 3 Expert

5687 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Are you a Lincoln Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides