Question about 2000 Toyota RAV4

1 Answer

1996 Rav4 won't stay running

Just replaced timing,plugs,dist cap,rotor,ect. But now it only starts if I slightly give gas.To much gas cuts of the engine, rpm does not go over 3000. Can anybody help? Thanks

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 191 Answers

Did you do the repairs to correct the problem or did they occur after you performed them?

Sounds like it could be a clogged catalytic converter. Have it checked to insure it is flowing freely.

Posted on Apr 20, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

1992 Dodge Stealth SOHC - no problems, running great, then I replaced the distributor (forgot to mark it) & now the car won't start up. It'll turn over, even got it to start once but won't...


put number 1 cylinder at top dead center and drop in distributor so the rotor points to number 1 on cap. may have to try several times as gear moves when lowering dist.

Sep 07, 2013 | Cars & Trucks

1 Answer

Starts then stall


I would check the fuel filter- sounds like it could be clogged and restricting your gas flow

Aug 14, 2012 | 2000 Mitsubishi Mirage

5 Answers

Truck wont crank. we have put new distributor cap, rotor button, coil pack, plugs, wires, and fuel pump. we also checked our firing order.


you said you repl dist cap that means you don't have a crank sensor you have electronic ing module. remove your elec ing module have it tested most auto parts stores could test your module, or check your coil at the neg terminal. should have power. if not you lost your primary volt from your batt.your secondary power is coming from your electronic ing module from the module to the pos terminal on the coil, when the eng cranks,from the coil to the dist cap , from the dist cap center to the rotor then out to the plugs,this all happen pervided the timing belt or timing chain is ok. the cumbustion chainber needs 3 things , thats fuel, air, and spark.

Apr 17, 2011 | 1996 Chevrolet K1500

1 Answer

97 dodge ram no spark


then i would replace whats called the hall effect sensor its that black plastic plate you see when you take dist cap off. just pull rotor and lift up the sensor.dist cap is what holds it on.also under the sensor will be a stamped sheet metal piece that looks like the top of a castle wall. make sure its not loose on the shaft.if it is then new dist will be needed

May 09, 2010 | 1997 Dodge Ram 1500 Club Cab

1 Answer

94 royal begis to cut out, chugs at about 55


Replace the spark plugs and wires along with a distributor cap and rotor. Be careful to leave the old wires and plug wires connected to dist.cap, just remove dist. cap from the distributor and lay aside with plug wires on it then install rotor then new cap and proceed to replace each wire for cap and spark plug one at a time so you don't mix up the spark plug wire firing order. Cap laying to the side is used for reference purpose.

Feb 26, 2010 | 1994 Oldsmobile 88

2 Answers

1989 tbi chev. 5.7 missing or trying to flood with


Try your coolant temp sender, if it's bad the computer thinks it's running cold all the time, therefor giving it more gas.

Oct 26, 2009 | 1989 Chevrolet C1500

2 Answers

Misfires 96 gmc sierra 5.0


if the check engine light starts flashing its probably setting a code may have an injector problem

Aug 05, 2009 | 1996 GMC Sierra

1 Answer

Engine-no go


i think the dist is adjable try advanceing it some times the after market caps are a little diffront

Apr 06, 2009 | 1996 Ford Aspire

1 Answer

Won't start 96 k1500


fuel problem or timing problem i had same problem on 94 aerostar found out the dist. was bad and timing off by 20* bought used dist. adjusted timing runs beautiful

Mar 23, 2009 | 1996 Chevrolet K1500

Not finding what you are looking for?
2000 Toyota RAV4 Logo

Related Topics:

132 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8548 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...