Question about 1997 Audi A4

Open Question

WHAT DO I NEED TO WIRE IN THE 12S SOCKET TO THE CAR AND HOW IS IT DONE ON AN AUDI A4 1997 1.6 PETROL

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to remove and replace front air suspension struts in 2006 Audi A8


Follow these steps:
  1. Open the car hood. If you have a factory stereo system installed you need to now the security code t reactivate the sound. Remove the negative cable from the battery to prevent the air bags from popping.
  2. Use a pair of wheel chocks behind the rear wheels. Use a car jack to raise the side of the car you will work on. Take off the wheel by loosening the lug nuts.
  3. On the wheels wells in the engine chamber use a socket and ratchet and remove the grommets and upper strut nuts. Also disconnect the brake hose bracket and ABS sensor wire from under the car.
  4. Again take the socket and ratchet to loosen the pinch bolt and nut located on the upper control arm, which you will remove from the wheel knuckle. When the pinch bolt goes through you must not pry open the slotted area. Use a socket and ratchet and remove the strut assembly.
  5. Place a spring compressor on the coil spring and tighten it enough to relieve the pressure from the spring cap. Using a socket and ratchet remove the center nut from the strut rod. Remove the spring cap, coil spring and spring seats from the strut. Place the coil spring on the new strut along with the new spring seats and spring cap.
  6. Place the center nut on the strut rod and tighten it. Take off the spring compressor form the coil spring. Install the strut on the Audi and mount the upper control arm with the wheel knuckle.
  7. Connect the ABS sensor wire to the strut. Attach the brake hose bracket to the strut and tighten the nut. Install the three upper strut nuts in the engine compartment and tighten them. Cover the nuts with grommets. Place the wheel on the Audi and tighten the lug nuts with the lug wrench.

Mar 17, 2014 | Cars & Trucks

1 Answer

Thermostat needle sticks at zero or at full there is water in the coolant tank, you put petrol in the car and the needle doesn't read correct it may drop from half way to zero what the f!*&K is...


Sounds to me like you need a temperature sensor replaced in the water block of the engine.If this is not the case then the output wire from the sensor could be shorted to power[sensor the most likely suspect].

Sep 30, 2010 | Audi A4 Cars & Trucks

1 Answer

How to connect my bluetooth to my 2007 audi a4 q , how to connect my ipoh to it also , in the book it talk about interface but i cant find anything in my car.


the "interface" is the wire supplied by the maker of your ipod to connect into the socket in the car.(here in Europe you have to buy a "parrot" to "interface with the radio for the phone as not all phones are compatible.)

Sep 25, 2010 | 2007 Audi A4 Convertible

1 Answer

How manny litres of petrol dose the petrol hold on an Audi A4 P reg 1.8li


Petrol tank capacity:
1997 Audi A4 FWD: 16.4 U.S. gallons = 62 litres
1997 Audi A4 Quattro: 15.9 U.S. gallons = 60 litres

Aug 20, 2010 | 1997 Audi A4

1 Answer

My Audi has just had an MOT and the mechanic told me I may have a problem with the Cambus as my rear driver's light is brighter than the passenger side. What is involved in fixing this with Audi and how...


I would suspect this to be a very simple fix. It's probably a poor ground or loose socket. The plug-in for the light may be loose or corroded and need to be replaced or the ground wire for that light is not making a good connection. The ground wire needs to be taken off and cleaned up and put back on. It could also be the light socket itself that is making the poor connection and may need to be replaced.
While I'm not familiar with the cost of Audi repairs, this is a job that can easily be done by a DIYer so it shouldn't be overly expensive. Hope this helps.

Jun 05, 2010 | 2002 Audi A4

2 Answers

Location of reversing light switch audi a4 cabriolet 2005 2.4 v6 reversing lights on permanantly when driving


I think on top of the transmission, the one has a wire, and looks like a sensor. To remove, need a 19mm , open wrench or socket wrench.

Feb 28, 2010 | 2005 Audi A4

1 Answer

Need to find a switched earth for a tow bar fitted to audi a3 its for a 12s type plug and for the fridge pin number 7


you can get a switched ground useing a live wire to switch a rely to provide switched ground.live power to pin 85 ground to pis 86 and 30,the pin 87 will be negative whe the key is on.

Jul 05, 2009 | 2005 Audi A3

1 Answer

Car wont start


try taking off the gas cap and then retighten it.may have a vacume lock.make sure gas cap is tight.

Jul 05, 2009 | 2005 Audi A3

1 Answer

Audi a6 1996 2.0 fuel line leak


Find out the diameter of the line and get some tubing and compression fittings at a hardware store.

Apr 13, 2017 | 1996 Audi A6

Not finding what you are looking for?
1997 Audi A4 Logo

Related Topics:

56 people viewed this question

Ask a Question

Usually answered in minutes!

Top Audi Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

yadayada
yadayada

Level 3 Expert

75117 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14228 Answers

Are you an Audi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...