Question about 2001 Isuzu Trooper

2 Answers

Tourque On Demand Check light flashing-No TDC codes

Monterey,2001,Auto,Diesel,cruise control.Transmission has been serviced as per owners manual,197,000 Klms.-No DTC codes that are readable.

Posted by on

  • 2 more comments 
  • pgtnl_1804 Apr 20, 2009

    Is the drive shaft (Transfer box) ?. Rear wheels shaft doesn't appear to have any wiring near it.

    Thank you.

  • pgtnl_1804 Apr 21, 2009

    Thank you once again for your assistance. I actually have a (Holden Jackaroo Monterey.Right hand drive). I have been to 5 different dealers(GMH) and it appeared that it was always in the too hard basket.They weren't backward in the charging department though.I will try an auto electrician next,they couldn't be any worse.

  • pgtnl_1804 Apr 21, 2009

    Thank you for the encouragement. The auto lecky is very snowed under with work so it will take a while before I am able to give you guys the results of your thankful information.

  • pgtnl_1804 Apr 22, 2009

    I have tried to rate both of the helpful information,clicked on the icons,bit like the problem,it doesn't work. Thank you guy's.

×

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 291 Answers

Yes you are right.the autoelectrician is a good choise to get it checked.this will bring us to some conclusion.to what to get replaced and what to get repaired.this will help. please do rate the solution.thank you for using fixya. thanks.

Posted on Apr 21, 2009

  • jamesrated Apr 21, 2009

    thanks for this update.also keep updated what happens so we can continue from there/please do  rate the solution if helped.thank you for using fixya.

  • jamesrated Apr 22, 2009

    thank you for updating.just click the four blue dots below the solution on the lower side and it will be rated.thank you for using fixya.have a great day.

×

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Brigadier General:

    An expert that has over 10,000 points.

  • Master
  • 8,619 Answers

Hi

When such warning indicator light flashes it means the wiring that runs along the drive shaft can be corroded as no codes are present. Also get your vaccum solenoids checked. Also get the ECU wirimg checked as it is the part that can be faulty if the codes are not coming and TOD light is flashing.

Please do accept this solution and revert for further assistance.

Thanks
Rylee

Posted on Apr 20, 2009

  • Rylee Smith
    Rylee Smith Apr 20, 2009

    Hi



    If you are unable to find any wires near the shaft then look for ECU wiring. If the wiring is fine then disconnect only + or - battery connections from the ECU and then reconnect it after 5 min.s and check if the TOD light still flashes.



    You can find the ecu for your car under the steering wheel(on the right bottom corner).



    Please do accept this solution and revert for further assistance.


    Thanks

    Rylee

×

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Started to drive our 2005 Subaru and the Check engine light came on as well as the cruise control light. What should I do?


stop
check oil level in sump and transmission if auto
check coolant level in the radiator
run the fault codes to see what sensor put the lights on
it is possible that the VSS in the auto if auto set the TCM off
as engine lights reprot on engine and transmission faults

Dec 19, 2016 | Subaru Cars & Trucks

1 Answer

Error code P0500 and speedometer and cruise control not working


Well code 500 would sure cause the problems you mentioned. If you have replaced the sensor and the problem continues, it could be something in the wiring or the gear inside the transmission.

Jan 23, 2014 | 2001 Mercury Villager

1 Answer

Speedometer and cruise controll on2003 sonata stopped working ,and check engine light on


No speedometer or cruise control and a check engine light all point to the VSS(vehicle speed sensor) on the transmission.Take it to a parts store that does free code scans(like Auto Zone) to verify the code(should be P0500-P0503).Or,take a chance and just change the sensor.

Oct 25, 2012 | Hyundai Motor 2004 Sonata

2 Answers

What do these codes from a 2001 Mercury Sable LS mean? p1747, p0743, p0750, p0760, p0135, p0141, p0161, p0720, p0755...My car wont shift-out & barely takes off. The check engine light is on along with...


My chech engine light was on after i got it back from the garage and it was the P1451 anti theft system module error engine disabled what does that mean? The light wasnt on when i dropped it off.

Jul 10, 2011 | 2001 Mercury Sable

1 Answer

I have a 95 f250 powerstroke diesel, automatic, since yesterday the transmission has been slipping between 3rd and overdrive. the problem started while hauling a fairly light horse trailer and the...


You should not use overdrive unless you are steadily going highway speeds. I had one of those and my ex liked to use cruise control on windy coastal roads. This caused it to shift back and forth from 3rd to overdrive constantly. So I disconnected the cruise control so he couldn't use it. Lol. I'm not suggesting this for you. You should keep overdrive off for now and have your transmission serviced. New filter & oil & flush the cooler. Make sure you ONLY USE THE RECOMMENDED FLUIDS!!!!!!!!!! See if that helps. Do not use overdrive pulling a trailer and going up a hill and do not use it if you are on windy roads where you are slowing down alot of times. Try letting off the gas for a second when you do want to engage the overdrive. Remember to always check your automatic tranny fluid with the engine running and fully warmed up.

Apr 01, 2017 | Ford F-250 Cars & Trucks

1 Answer

The cruise control on my 2001 just quit working i have checked the fuses and all are ok while driving i can engage the criuse control and the cruise light comes on for an instant almost like a flash any...


A vehicle speed sensor provides a signal for the cruise control and also for the ABS braking and the overdrive function. I would start with finding the fuse for the cruise control in your owners manual. Also some cruise controls have vacuum lines attached, if so, check for cracked or broken vacuum lines. Good luck.

Oct 07, 2010 | 2001 Ford F150 Styleside SuperCrew

1 Answer

Cruise control stopped working


Check the switch, located on the brake pedel the stop light switch and the cruise control switch are on the brake pedel towards firewall. The cruise control switch is plastic.

Mar 25, 2010 | 2001 Ford F350 Super Duty SuperCab

1 Answer

Check engine light, flashing cruise control light


if you put a scanner on it you'll prob get a code telling you what prob is.if you have a autozone or,pepboys they could put scanner on it and tell you what prob is the only way

Feb 08, 2010 | 2007 Subaru Impreza WRX Sport Wagon

1 Answer

2001 gmc 6.6 diesel 2500hd,the problem wont rev


safety[ limp] mode truck wont go over 2000 rmp but it will get u safely off road or to a service station or home ur getting some kind of code thats effecting ur truck --use a different reader urs might not be able to retrieve the problem code but can reset the computer-some auto stores such as auto zone / advanced auto scan for free check shops in ur local area

Feb 07, 2010 | 2001 GMC Sierra 2500HD

2 Answers

1999 Dodge Ram 2500 Diesel 4x4


there is a cruise control module , easiest way to find it is follow 2nd throttle cable under hood right to it. it most cases there unplugged

Jan 08, 2009 | 1999 Dodge Ram

Not finding what you are looking for?
2001 Isuzu Trooper Logo

Related Topics:

102 people viewed this question

Ask a Question

Usually answered in minutes!

Top Isuzu Experts

yadayada
yadayada

Level 3 Expert

75005 Answers

Steve Hurc
Steve Hurc

Level 3 Expert

450 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...