Question about 2004 Lexus RX 330
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
After having my oil changed, the next day the trac off light and vsc light came on and don't go off...can you tell me how to get them off? HELP
Posted on Jan 17, 2009
to reset for a momentany malfuntion,disconnect the negative battery terminal few minutes, reconnect,start engine and drive to check
Posted on May 03, 2009
My car (06 GS430) began giving me more frequent "Check VSC" warnings. (Code P0455 in my case. Really glad I bought that OBDII tool--resetting the codes is a snap!)
I knew that a loose gas cap could cause this, so normally I just give it a twist and it tightens. Now I found that no matter how many "clicks" I tightened the gas cap, it would not cinch down snug. The lightest turn the opposite way would open it.
I was all set to head over to CarQuest for a replacement filler cap. But I thought I'd inspect mine first just to see why it stopped holding. Upon inspection, I saw that what holds the cap in place is compression of the rubber O-ring at the back of the cap, which compresses against the filler neck. That apparently was no longer happening.
I carefully removed the O-ring from the cap--using screwdrivers to lift it over the edge of the groove it sits in. Like removing a bike tire from the rim--work your way around. Then I cut a strip of electrical tape about 10" long, and 1/4" wide. I wound this into the curved groove where the O-ring normally sits, just to build up a little thickness. Put the O-ring back in place. Done.
Now the cap tightens like it's supposed to, and thus far, it has stopped the VSC error codes. Don't know if it will fix your issue or not, Good luck.
Posted on May 09, 2009
It is not hard to change the sensor, it just screws into a threaded hole. The light will not go out immeditaly, after the sensor is replaced. It needs to go thru a drive cycle. Your best bet is to replace the sensor and get the code cleard by whoever scanned it for the 0031 code.
Posted on Jul 23, 2009
Check your switches for the VSC, some get bumped on (due to their location) and some get stuck in the "on"position.
Posted on Aug 04, 2009
Tips for a great answer:
Nov 25, 2015 | Toyota Cars & Trucks
Aug 17, 2014 | 2006 Toyota Sequoia
Jun 17, 2013 | 2006 Toyota RAV4
May 16, 2011 | 2004 Toyota RAV4
Jan 25, 2011 | 2008 Toyota Sienna
Nov 16, 2010 | 1999 Lexus ES 300
Jul 24, 2009 | 2000 Oldsmobile Intrigue
May 20, 2009 | 2004 Toyota Solara
75 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: