Question about 1994 Jeep Wrangler

1 Answer

Half my fuse box went out

My turn signals and brake lights went out so i tested the fuse box and found out the left side had power but the right side did not for any fuses on that side they seem to run to a box on my fender under the hood but i have no idea what that is.

Posted by on

  • 1 more comment 
  • lynch4321 Apr 20, 2009

    i tested it with the ignition on and off and no difference the complete right side is out i even tested the wires coming into the fusebox and no power to those as well. my turn signals or brakes dont light but my headlights and parking lights do work, instrumentation lights work oh its this is on a 1979 jeep cj5 not a wrangler

  • Richard Scordino May 11, 2010

    Good thing you said what year before I started looking at diagraqms!!!
    Have you checked on the firewall side of the bulkhead connector?And on the backside of the fuse box?


  • Richard Scordino May 11, 2010

    Before you panic, did you test the fuses with the on and off?

×

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

    Problem Solver:

    An expert who has answered 5 questions.

  • Contributor
  • 7 Answers

On the buss connector for the turn signal switch with the signal flashing check voltage on the Green-W/trace. Should be intermittent 13.8 V.

1) The Orange at the signal selector buss should have +13.8v all time key is on.

2) Check red w/trace at brake lamp switch, With brake pressed both sides should have +13.8v

(if there is no voltage at above ORANGE we need to check the fuseclips for corrosion, then pull the fuseblock out and check for corrosion on the wires. The buss that feeds those fuses could have some corrosion going on.)

If the turn signal switch fails it will take out the brake lights also, IMHO this will be found to be the culprit in most failures. Gotten allot of water around under the dash?

Posted on May 19, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

Where is the fuse located for left brake light on fuse box


Brakes are generally not fused seperately. Have u check the bulb in the left side.

Sep 15, 2014 | Cars & Trucks

1 Answer

No trailer Brake Lights right or left side


Try the specified fuses in the under hood fuse center. they are common to blow.

Mar 28, 2014 | 2004 GMC Yukon XL

1 Answer

No brake lights


This may sound confusing, so here goes.
Normally I would say check the turn signal switch because for decades the brake light switch power went thru the turn signal switch.
But in your case, its more complicated.
The wiring diagram looks like you have a wire from the brake switch and another from the turn signal that joins inside the right and left rear tail lamp assembly. There are also fuses in the rear fuse box including one for just the brake lights. So its possible that fuse is dead and yet the turn signals would work.
You may have to get a book with the wiring diagrams to trace the circuits.

Feb 06, 2013 | 2005 Chevrolet TrailBlazer

1 Answer

No indicators working found fuse box which fuse?


When you are talking about "indicators" we could assuming that your are refer about signal lights. This work with "flashers" devices.

For 1996 Audi A4 2.8L SFI 6cyl the Flasher is located in front seating area, driver side, under dash, behind dash lower panel, mounted above driver side of steering column.

About generic fuses, open the driver side door. Remove panel on left side of dash. Fuse box is behind panel:

Fuse # / Description / Amps
1 / Heated washer jets / 5
2 / Turn signals flasher unit / 10
3 / Headlight washer, illumination of glove compartment, engine compartment, climate control, automatic transmission, instrument cluster / 5
4 / License plate light / 5
5 / Instrument cluster, seat heating, test connection for cruise control, bulb monitor for auto-check control, Automatic transmission display, switch lighting, mirror switches and actuators, airbag warning light, outside temperature indicator, Climate control / 10
6 / Central locking system / 5
7 / Anti-lock brake system / 10
8 / Vacant
9 / Mirror heating / 10
10 / Vacant
11 / Cruise control (automatic transmission) / 5
12 / On board diagnostic system / 10
13 / Brake lights / 10
14 / Interior lights, reading lights, anti-theft alarm system, vanity mirror / 10
15 / Instrument cluster, power windows, climate control, automatic transmission / 10
16 / Anti-lock brake system, Anti-Slip-Regulation / 5
17 / Heated door locks / 10
18 / High beam right / 10
19 / High beam left / 10
20 / Low beam right / 15
21 / Low beam left / 15
22 / Tail and side marker right / 5
23 / Tail and side marker left / 5
24 / Wiper and washer system / 25
25 / Blower for heating, climate control / 30
26 / Rear window defogger, mirror heating / 30
27 / Rear window wiper / 15
28 / Fuel pump / 15
29 / Engine timing / 20
30 / Sun roof / 20
31 / Tail lights, cruise control, automatic transmission / 15
32 / Engine timing / 20
33 / Cigarette lighter / 15
34 / Engine timing / 15
35 / Trailer receptacle / 30
36 / Fog lights / 15
37 / Radio / 20
38 / Luggage compartment light, central locking system / 15
39 / Emergency flasher / 15
40 / Horn / 25
41 / Anti-lock brake system / 25
42 / Vacant
43 / Vacant
44 / Seat heating / 30

Hope this helps (remember to rate and comme this free answeer).



Jun 16, 2011 | 1996 Audi A4

1 Answer

I have 1999 Blazer with brake light out on driver side only. All other lights work. Replaced bulbs but nothing changed. Swapped the working lights from the other (right side) with the driver side but...


THE BRAKE LIGHTS DO GO THROUGH THE TURN SIGNAL SWITCH. TO TEST, REMOVE THE PLASTIC COVER AROUND THE THE COLUMN, UNDER THE STEERING WHEEL. THE TURN SIGNAL SWITCH MUST BE IN THE OFF POSITION. YOU WILL NEED TO EXPOSE THE WIRES UNDER THE STEERING WHEEL. DO NOT DISTURB THE WIRES IN THE YELLOW JACKET. THEY ARE AIRBAG WIRES. YELLOW PLUGS YELLOW JACKETED WIRES ARE AIRBAG.THE WIRE IN QUESTION HERE IS YELLOW BUT IT IS NOT IN A YELLOW JACKET, [ SLEEVE ]. NOW, PUSH ON THE BRAKE PEDAL. THE YELLOW WIRE IS LEFT REAR TURN & BRAKE WIRE, DARK GREEN IS RIGHT REAR TURN & BRAKE WIRE. BRAKE PEDAL DEPRESSED, IF BOTH OF THOSE WIRES HAVE POWER, ALL OF THAT IS OK. IF THE YELLOW WIRE HAS NO POWER TURN SIGNAL SWITCH IS BAD

Jan 16, 2011 | Chevrolet Blazer Cars & Trucks

7 Answers

2003 Dodge Ram 3500 left turn signal problems / trailer


Well let me shed some light on this issue. I have the same problem. Trailer connection from truck does not have power to left turn signal and left brake light. I just got back from the dealership and $100.00 labor charge. My problem is the TIPM (Fuse Box for short) and FCM (little silver module hooked to the Fuse Box on the left hand side of the fuse box). $910.00 for the parts and Chrysler doesn't have any in stock. 4-6 weeks to maybe fill a back order. I am currently researching an alternative way to fix this issue. I will let you know.

Feb 04, 2010 | 2004 Dodge Ram 2500

1 Answer

Right turn signal stays on will not flash left works.2001 jimmy


its your blinker box.. all major lights run through there

Aug 04, 2009 | 2001 GMC Jimmy

1 Answer

Can't figure out why no power is getting to the right side brake light and turn signal. The other lights work on the tailight. I checked the fuses. brake light switch, and checked the wires for damge.


your wiring may have gotten pinched by crossmember or something else.i would check for power out of the fuse block.there are four wires on the right side coming out of your fuse box with a seperate flat vertical plug,the colors are brown,dark green,yellow and light green.brown is tailight,light green for your backup lights and green and yellow for left and right stoplight/turn signals.use a test light at the plug.

Mar 28, 2009 | 1985 GMC K1500

1 Answer

Brake light/turn signal no not work on left side only.


check fuse number 7 in Engine Compartment Fuse Box , if its ok you need change turn signal switch

Mar 15, 2009 | 1996 Ford F150 Regular Cab

2 Answers

2001 Explorer Sport ,Rear Driver Brake Light and Turn Sig. Broke


Rear lights are double filament bulbs one side for the lights other side for the brake/turn signals so it still may be a bulb. Do u have a test light or volt meter you can check to make sure u have power there when brakes or turn signals are activated. Or just try another bulb.

Feb 12, 2009 | 2001 Ford Explorer Sport

Not finding what you are looking for?
1994 Jeep Wrangler Logo

414 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76673 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...