Question about Chevrolet Silverado 3500HD

1 Answer

How do I take the fanclutch off a 1986 chevy truck

How do I take the fanclutch off

Posted by on


1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 2 Answers

To take off the fan clutch figure out which way to turn nut then with very long chisel or steel bar with chisel type end hit the edge of the nut to crack loose the nut and then it may be taken off by hand.

Posted on Apr 19, 2009


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

New water pump,fanclutch,and thermostat when driving truck over heats on 99 chevy blazer

have a compression test done to determine gasket or cracked head. Have a flow test done on the radiator as the cores may be blocked . If automatic check the operating temperature of the transmission oil as if it is excessive then that extra heat has to be cooled by the radiator as well. Run fault codes to check for air/fuel mixture ratio as ,lean conditions will cause over heat. Check that the fins on the radiator cores are in good condition and not crumbling off.

Jun 18, 2014 | Cars & Trucks

1 Answer

1986 Chevy: where can i find my fuel pump on my 1986 Chevy...

If it is fuel injected the pump will be in the gas tank. If it is carb it will be on the front lower left side of the engine

May 18, 2010 | 1986 Chevrolet Chevy

1 Answer

1986 chevy c10 truck. pulled steering wheel to

THE horn piece should turn with the wheel lock plate. if it does not then something is not installed properly

Apr 12, 2010 | 1986 Chevrolet Chevy

2 Answers

How to change a ignition in a 1986 chevy truck

If the ignition switch is in the column then you need special tools to remove the steering wheel and various other components to get at it. Find a shop that can do this for you.

Aug 03, 2009 | 1986 Chevrolet Chevy

3 Answers

Ignition timing specs for a 1986 Chevy 454?

Automatic I presume. 8 degrees BTDC @ warm & 700 RPM.
distributor vacuum off & plugged. In drive, & accessories off.
Don't forget parking brake on.

Jul 16, 2009 | 1986 Chevrolet Chevy

1 Answer

Trying to locate fuse block for 1986 chevy celebrity wagon

That should be under the dash on the drivers side hope this helps

Mar 19, 2009 | 1986 Chevrolet Chevy

1 Answer

Chevy motor

it will, as long as they are the same drive type...i.e. both front wheel drive motors, or both rear wheel drive.

Feb 20, 2009 | 1986 Chevrolet Chevy

2 Answers

How to replace a fanclutch on 2004 yukon denali.

you need to get a slip ring wrenchto hold it you can get one at sears

Dec 07, 2008 | 2004 GMC Sierra Denali

1 Answer

1986 chevy caprice

how to install a 1986 capri starter?

May 24, 2008 | 1986 Chevrolet Caprice

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

70 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts


Level 3 Expert

80263 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides